Postharvest handling practices and irradiation increase lenticel discolouration in ‘B74’ mango fruit

ABSTRACT 'B74' mango is a recently commercialised cultivar in Australia, with an appealing skin colour and firm fibreless flesh. However, fruit can develop lenticel discolouration (LD) after harvest, with loss of commercial value, especially after γ-irradiation as a disinfestation treatment. We hypothesised that postharvest practices could increase fruit sensitivity to LD and tested that by sequentially sampling fruit between the orchard and the end of the packing line over two seasons, followed by ripening without and with irradiation treatment. Exposure of 441-610 Gy γ-irradiation significantly increased the severity of LD by 6.8-fold in commercially picked and packed ripe fruit, reducing the proportion of marketable fruit from 98% to 2%, compared to irradiated fruit harvested directly from the trees and not exposed to de-sapping solution and packing operations. Also, LD increased progressively as the fruit passed through the harvesting and packing processes, and exposure to only bore water increased LD severity compared with no water contact. Results suggest that the typical de-sapping process used during harvesting is a major contributor to skin sensitivity to LD in 'B74' mango fruit, and that other packing operations involving wetting of the fruit have an additive effect on it. These effects are exacerbated if fruit is irradiated.

Comparison of firmness meters for measuring ‘Hass’ avocado fruit firmness

The temporal passage of fruit through the supply chain and the selection of consumable fruit by shoppers depend primarily upon fruit firmness. Traditionally, fruit firmness measuring methods, like Effegi and conical probes, are relatively inefficient and destructive. Simple, accurate and non-damaging methods of measuring fruit firmness are ideally required to help assure eating quality to the consumer without fruit wastage. The firmness of 'Hass' avocado fruit at a range of ripening stages was measured with the various different firmness measuring techniques of the Sinclair iQ Firmness Tester (SIQFT), the Electronic Firmometer (EF), the Analogue Firmness Meter (AFM) and hand squeezing. Measurements were made by each method at different points on the same fruit. Destructive bruise assessment was performed 48 h later, thereby allowing sufficient time for fruit to express any bruising resulting from the act of firmness measurements. Non-linear relationships were determined between fruit firmness values measured with the different techniques. The adjusted R2 for the relationship between the SIQFT and the EF was 91.6%. For the SIQFT and the AFM, the adjusted R2 was 73.7%. It was 77.7% for the SIQFT and hand squeezing. A significantly (P<0.05) high incidence of bruising was associated with firmness assessment by the EF as compared with either the SIQFT or the AFM. Among the methods compared, the SIQFT was non-damaging compared with the EF and relatively efficient for measuring the firmness. This instrument merits consideration as a quality control tool of choice in 'Hass' avocado supply chains.