Wood properties and knot occlusion of plantation grown Eucalyptus dunnii and Corymbia citriodora subsp. variegata in a pruning and thinning experiment.

A 2 × 2 factorial combination of thinned or unthinned, and pruned or unpruned 11-year-old Eucalyptus dunnii (DWG) and 12-year-old Corymbia citriodora subsp. variegata (CCV) was destructively sampled to provide 60 trees in total per species. Two 1.4 m long billets were cut from each tree and were rotary veneered in a spindleless lathe down to a 45 mm diameter core to expose knots which were classified as either alive, partially occluded or fully occluded. Non-destructive evaluation of a wider range of thinning treatments available in these trials was undertaken with Pilodyn and Fakopp tools. Disc samples were also taken for basic density and modulus of elasticity. Differences between treatments for all wood property assessments were generally small and not significantly different.Thinning and pruning had little effect on the stem diameter growth required to achieve occlusion, therefore occlusion would be more rapid after thinning due to more rapid stem diameter growth. The difference between the treatments of greatest management interest, thinned and pruned (T&P) and unthinned and unpruned (UT&UP) were small. The production of higher value clear wood produced after all knots had occluded, measured as the average stem diameter growth over occlusion of the three outermost knots, was approximately 2 centimetres diameter. Two of the treatments can be ruled out as viable management alternatives: (i) the effect of thinning without pruning (T&UP) is clear, leading to a large inner core of stem wood containing knots (large knotty core diameter) and (ii) pruning without thinning (UT&P) results in a small knotty core diameter, however the tree and therefore log diameters are also small.

Tree growth relationships and silvicultural tools to assist stand management in private native spotted gum dominant forests in Queensland and northern New South Wales.

Spotted gum dominant forests occur from Cooktown in northern Queensland (Qld) to Orbost in Victoria (Boland et al. 2006) and these forests are commercially very important with spotted gum the most commonly harvested hardwood timber in Qld and one of the most important in New South Wales (NSW). Spotted gum has a wide range of end uses from solid wood products through to power transmission poles and generally has excellent sawing and timber qualities (Hopewell 2004). The private native forest resource in southern Qld and northern NSW is a critical component of the hardwood timber industry (Anon 2005, Timber Qld 2006) and currently half or more of the native forest timber resource harvested in northern NSW and Qld is sourced from private land. However, in many cases productivity on private lands is well below what could be achieved with appropriate silvicultural management. This project provides silvicultural management tools to assist extension staff, land owners and managers in the south east Qld and north eastern NSW regions. The intent was that this would lead to improvement of the productivity of the private estate through implementation of appropriate management. The other intention of this project was to implement a number of silvicultural experiments and demonstration sites to provide data on growth rates of managed and unmanaged forests so that landholders can make informed decisions on the future management of their forests. To assist forest managers and improve the ability to predict forest productivity in the private resource, the project has developed: • A set of spotted gum specific silvicultural guidelines for timber production on private land that cover both silvicultural treatment and harvesting. The guidelines were developed for extension officers and property owners. • A simple decision support tool, referred to as the spotted gum productivity assessment tool (SPAT), that allows an estimation of: 1. Tree growth productivity on specific sites. Estimation is based on the analysis of site and growth data collected from a large number of yield and experimental plots on Crown land across a wide range of spotted gum forest types. Growth algorithms were developed using tree growth and site data and the algorithms were used to formulate basic economic predictors. 2. Pasture development under a range of tree stockings and the expected livestock carrying capacity at nominated tree stockings for a particular area. 3. Above-ground tree biomass and carbon stored in trees. •A series of experiments in spotted gum forests on private lands across the study area to quantify growth and to provide measures of the effect of silvicultural thinning and different agro-forestry regimes. The adoption and use of these tools by farm forestry extension officers and private land holders in both field operations and in training exercises will, over time, improve the commercial management of spotted gum forests for both timber and grazing. Future measurement of the experimental sites at ages five, 10 and 15 years will provide longer term data on the effects of various stocking rates and thinning regimes and facilitate modification and improvement of these silvicultural prescriptions.

Productivity of plantation hardwood tree species in north-eastern Australia: A report from the Forest Adaptation and Sequestration Alliance

The report summarises data from a large number of trials of species with potential for use by the plantation forest industry in north-eastern Australia and provides information aimed at improving the understanding of growth rates, pest and disease risks and carbon sequestration. Data is summarised and presented at a regional level as opposed to individual trial or plot level. As well, nutritional impediments to tree growth and impacts on forest health are also reported. This report is intended to contribute to policy deliberations about developing forestry opportunities that can that can be integrated into the landscape, with particular consideration given to lower rainfall regions. There are several examples in north-eastern Australia where production forests have developed sub-optimally; this has often been due to poor selection of tree species as little information has been available. This report helps address this deficiency.

Forest health guide: symptoms of insect and fungal damage on trees

The Forest health guide: symptoms of insect and fungal damage on trees is intended to help forestry and quarantine staff undertake tree health assessments, in both forest and urban environments. The guide is designed to be used as a quick reference to common symptoms of damage, not as an identification guide to particular insect pests and pathogens.

Forest and Wood Products Research and Development Corporation (FWPRDC) Cypress exatractives

Study to investigate the use of cypress pine extractives as a novel timber preservative.

Establishing forest pest detection systems in South Pacific and Australia

The aim of the project is to reduce the risk of serious damage by exotic pests to the valuable timber resources of Fiji, Vanuatu and Australia by establishing efficient detection systems for target pests in high hazard sites. In particular, the project aims to minimise losses in the valuable plantations of Fiji and the emerging plantation industry of Vanuatu. This is part of a 'neighbourhood watch' approach to incursion management that will benefit all regional countries, including Australia.

An audit of forest biosecurity arrangements and preparedness in Australia.

Current biosecurity arrangements for plantation forestry are poorly defined, at least relative to other plant-based industries. Serious pest and disease outbreaks in forestry are relatively rare events. Preparedness for rare events is difficult. Part of the difficulty stems from the competing views of managers and stakeholders. This project sought to directly capture alternative views concerning the key objectives of plantation forest biosecurity, alternative strategies for achieving those objectives, and ultimately recommend preferred actions that might be broadly supported by stakeholders. The outcomes from the workshop were used as a basis to draft a list of strategic actions required to improve forest biosecurity in Australia and to be implemented over the next 2-5 years. Research priorities were identified as research to support cost benefit analyses; investigating the effects of changed environmental conditions on forest biosecurity; pathway analysis for functional pest guilds. Integration of this research within a CRC would also permit the effective development and extension of this research as well as providing training urgently required to maintain forest biosecurity and health expertise.

The Queensland forest industry

An overview of the commercial growing, management and processing of forest products in Queensland.

Processing small diameter logs from sub-tropical species

Small spindleless veneer lathe technology was used to produce veneer sheets as an alternative processing option to optimise the use of small log plantation resource. Thinned (300 spha) and unthinned control (1000 spha) plantings of 10.5-year-old Corymbia citriodora ssp. variegata (CCV) and E. dunnii (Dunn’s white gum) grown in two contrasting sites from climatic regions with large annual rainfall differences were studied. Overall veneer gross recoveries ranged from 50% to 70%, which were up to 3 times higher than typical sawn green-off saw recoveries from small plantation hardwood logs of similar diameter. Major limiting factors preventing veneer from meeting higher grades were the presence of kino defects and encased knots. Splits in E. dunnii veneer also contributed to reduced grade quality. Differences between two thinning treatments for veneer properties and grade recovery were generally small. There was significant evidence of site and species differences on veneer quality. The good quality site with higher rainfall in northern New South Wales produced denser and stiffer veneers with higher grade recoveries. CCV is a superior structural veneer species with high wood density and hardness as well as very good veneer stiffness exceeding 15,000 MPa but Dunn’s white gum has also demonstrated good potential as a useful structural plywood resource. Results indicate that relatively high veneer recoveries were achieved for the sub-tropical plantation hardwoods combined with very superior mechanical properties which suggest that veneer production have suitable attributes for a range of engineered wood products including plywood and laminated veneer lumber.

Development of a productivity asessment toll for native spotted gum forest on private land based on estimates of forest growth on Crown land.

Reliable estimates of forest productivity are essential for improved predictions of timber yields for the private native spotted gum resource in southern Qld and northern NSW. The aim of this research was to estimate the potential productivity of native spotted gum forests on private land by making use of available inventory data collated from Qld and northern NSW for spotted gum forest on Crown land (i.e. state forests). We measured a range of site-related factors to determine their relative importance in predicting productivity of spotted gum forest. While measures such as stand height and height-diameter relationships are known to be useful predictors of productivity, we aimed to determine productivity for a site where this information was not available. Through estimation of stand growth rates we developed a spotted gum productivity assessment tool (SPAT) for use by landholders and extension officers. We aimed to develop a tool to allow private landholders to see the benefits of maintaining their timber resource. This paper summarises the information used to develop the SPAT with a particular focus on forest growth relationships.

Possible impacts of the invasive plant Rubus niveus on the native vegetation of the Scalesia Forest in the Galapagos Islands

Originally from Asia, Rubus niveus has become one of the most widespread invasive plant species in the Galapagos Islands. It has invaded open vegetation, shrubland and forest alike. It forms dense thickets up to 4 m high, appearing to displace native vegetation, and threaten the integrity of several native communities. This study used correlation analysis between a R. niveus cover gradient and a number of biotic (vascular plant species richness, cover and vegetation structure) and abiotic (light and soil properties) parameters to help understand possible impacts in one of the last remaining fragments of the Scalesia forest in Santa Cruz Island, Galapagos. Higher cover of R. niveus was associated with significantly lower native species richness and cover, and a different forest structure. Results illustrated that 60% R. niveus cover could be considered a threshold for these impacts. We suggest that a maximum of 40% R. niveus cover could be a suitable management target.

Diversity and abundance of fungivorous thrips (Thysanoptera) associated with leaf-litter and bark across forest types and two tree genera in subtropical Australia

Leaf-litter thrips were much more common and diverse in dry sclerophyll forest than in wetter forest types in subtropical southeast Queensland, Australia. In dry sclerophyll forest, the species composition of thrips in leaf-litter was strongly differentiated from the thrips fauna associated with bark of the trees Eucalyptus major and Acacia melanoxylon (4 of 34 species in common). The species composition of bark-dwelling thrips was similar across the two tree species and also across two eucalypts with different bark types, Eucalyptus major (flaky) and Eucalyptus siderophloia (rough). The diversity of thrips from the leaf-litter was not differentiated across all of these tree species. Virtually all thrips collected were Phlaeothripidae, subfamilies Idolothripinae and Phlaeothripinae. Idolothripinae were associated almost exclusively with leaf-litter, but Phlaeothripinae were in leaf-litter and bark. The association of fungal-feeding thrips with dry sclerophyll forest raises questions about their ecological requirements and the role they play in nutrient cycling. © 2012 Copyright Taylor and Francis Group, LLC.

The effect of long-term repeated burning and fire exclusion on above- and below-ground Blackbutt (Eucalyptus pilularis) forest vegetation assemblages

We used a long-term fire experiment in south-east Queensland, Australia, to determine the effects of frequent prescribed burning and fire exclusion on understorey vegetation (<7.5 m) richness and density in Eucalyptus pilularis forest. Our study provided a point in time assessment of the standing vegetation and soil-stored vegetation at two experimental sites with treatments of biennial burning, quadrennial burning since 19711972 and no burning since 1969. Vegetation composition, density and richness of certain plant groups in the standing and soil-stored vegetation were influenced by fire treatments. The density of resprouting plants <3 m in height was higher in the biennially burnt treatment than in the unburnt treatment, but resprouters 37.5 m in height were absent from the biennial burning treatment. Obligate seeder richness and density in the standing vegetation was not significantly influenced by the fire treatments, but richness of this plant group in the seed bank was higher in the quadrennial treatment at one site and in the long unburnt treatment at the other site. Long unburnt treatments had an understorey of rainforest species, while biennial burning at one site and quadrennial burning at the other site were associated with greater standing grass density relative to the unburnt treatment. This difference in vegetation composition due to fire regime potentially influences the flammability of the standing understorey vegetation. Significant interactions between fire regime and site, apparent in the standing and soil-stored vegetation, demonstrate the high degree of natural variability in vegetation community responses to fire regimes.

Resilience of a eucalypt forest woody understorey to long-term (34–55 years) repeated burning in subtropical Australia

We investigated the effects of annual burning since 1952, triennial burning since 1973, fire exclusion since 1946 and infrequent wildfire (one fire in 61 years) on woody understorey vegetation in a dry sclerophyll eucalypt forest, south-eastern Queensland, Australia. We determined the influence of these treatments, and other site variables (rainfall, understorey density, topsoil C : N ratio, tree basal area, distance to watercourse and burn coverage) on plant taxa density, richness and composition. The richness of woody understorey taxa 0–1 m in height was not affected by burning treatments, but richness of woody plants 1–7.5 m in height was lower in the annually burnt treatment than in the triennially burnt treatment from 1989 to 2007. Fire frequency and other site variables explained 34% of the variation in taxa composition (three taxon groups and 10 species), of which 33% of the explained variance was explained by fire treatment and 46% was explained by other site variables. Annual burning between 1974 and 1993 was associated with lower understorey densities mainly due to reduced densities of eucalypts 1–7.5 m in height. Triennial burning during the same period was associated with higher densities of eucalypts 0–7.5 m in height relative to the annually burnt and unburnt treatments. Most woody taxa persisted in the frequently burnt treatments through resprouting mechanisms (e.g. lignotuberous regeneration), and fire patchiness associated with low-intensity burning was also found to be important. Persistence of plants <1 m tall demonstrates the resilience of woody taxa to repeated burning in this ecosystem, although they mainly exist in a suppressed growth state under annual burning.