134 resultados para dried earth layer
em Chinese Academy of Sciences Institutional Repositories Grid Portal
Resumo:
土壤干层是黄土高原普遍存在的特殊土壤水文现象,研究其现状、成因、防治、调控措施等对科学认识区域植被承载力、土地生产力以及低效林草改造和可持续植被建设等有重要理论与生产指导意义,而合理通用评判指标与分级标准是开展土壤干层研究的基础。目前黄土高原土壤干层尚无统一评判指标与分级标准,给区域土壤干层研究带来困难。本文在已有研究成果的基础上,提出用土壤有效水饱和度/不饱和度作为土壤干层评判指标,并给出其分级标准。该评判指标计算简单,具通用性和可比性,可望成为土壤干层的通用评判指标。
Resumo:
近年来 ,以林草地地力衰退为特征的人工林草地土壤退化日趋严重 ,其中以土壤水分严重亏缺为特征的土壤干化现象愈益引起了人们的重视。土壤干化的直接后果是形成土壤干层 ,导致土壤退化 ,植物生长速率减缓 ,群落衰败以至大片死亡 ,严重地威胁到中国中北方地区特别是黄土高原地区生态环境的建设。因此 ,研究和解决土壤干层问题已成为黄土高原植被建设的迫切任务。根据现有土壤水分资料 ,初步分析了延安试区植被下的土壤干层现状 ,对不同林草植被下的干层状况做了比较 ,并提出了解决土壤干层问题的意义
Resumo:
8 0年代以来 ,以林草地地力衰退为特征的人工林草地土壤退化日趋严重 ,其中以土壤水分严重亏缺为特征的土壤干化现象愈益引起了人们的重视。土壤干化的直接后果是形成土壤干层 ,导致土壤退化 ,植物生长速率减缓 ,群落衰败以至大片死亡 ,严重地威胁到我国北方地区特别是黄土高原地区生态环境的建设。因此 ,研究和解决土壤干层问题已成为黄土高原植被建设的迫切任务。根据延安试区的土壤水分和植被生长状况调查资料 ,初步分析了不同条件下刺槐人工林地的水分状况。结果表明 :试区刺槐人工林地普遍形成了土壤干层 ,且已相当严重 ;坡向对土壤干层有明显影响 ,阳坡形成的干层较阴坡严重 ;坡度愈大 ,土壤干化愈剧烈 ;林龄对干层严重程度影响不明显。同时 ,研究指出了解决土壤干层问题的意义。
Resumo:
在详细描述土壤干层现象和类型的基础上 ,分析了土壤干层的成因 ,即低降水高蒸发、水土流失、植被类型选择失当、群落生产力过高和群落密度过大等 ,指出土壤干层的危害主要表现为使局部小气候环境趋于旱化、土地退化、植被生长衰退、天然下种更新不良及加大造林难度等 ,最后提出了缓解土壤干层对黄土高原生态环境的恢复和重建的意义和重要性。
Resumo:
A series of La2O3-ZrO2-CeO2 composite oxides were synthesized by solid-state reaction. The final product keeps fluorite structure when the molar ratio Ce/Zr >= 0.7/0.3, and below this ratio only mixtures of La2Zr2O7 (pyrochlore) and La2O3-CeO2 (fluorite) exist. Averagely speaking, the increase of CeO2 content gives rise to the increase of thermal expansion coefficient and the reduction of thermal conductivity, but La-2(Zr0.7Ce0.3)(2)O-7 has the lowest sintering ability and the lowest thermal conductivity which could be explained by the theory of phonon scattering. Based on the large thermal expansion coefficient of La2Ce3.25O9.5, the low thermal conductivities and low sintering abilities of La2Zr2O7 and La-2(Zr0.7Ce0.3)(2)O-7, double-ceramic-layer thermal barrier coatings were prepared. The thermal cycling tests indicate that such a design can largely improve the thermal cycling lives of the coatings. Since no single material that has been studied so far satisfies all the requirements for high temperature thermal barrier coatings, double-ceramic-layer coating may be an important development direction of thermal barrier coatings.
Resumo:
Ultrathin multilayer films of a rare-earth-containing polyoxometalate Na-9[Eu(W5O18)(2)] (EW) and Poly (allyamine hydrochloride) (PAH) have been prepared by layer-by-layer self-assembly from dilute aqueous solutions. The fabrication process of the EW/PAH multilayer films was followed by UV-vis spectroscopy and ellipsometry, which show that the deposition process is linear and highly reproducible from layer to layer. An average EW/PAH bilayer thickness of ca. 2.1 nm was determine,by ellipsometry. In addition, the scanning electron microscopy (SEM) image of the EW/PAH film indicates that the film sufface is relatively uniform and smooth. The photoluminescent properties of these films were also investigated by fluoresence spectroscopy.
Resumo:
Photoluminescent organic-inorganic composite films incorporating the rare-earth-containing polyoxometalate Na-9[EuW10O36] (EW) and poly(allylamine hydrochloride) (PAH) have been prepared by the layer-by-layer self-assembly method. UV-vis spectroscopy and ellipsometry were used to follow the fabrication process of the EW/PAH composite films. The experimental results show that the deposition process is linear and highly reproducible from layer to layer. An average EW/PAH bilayer thickness of ca. 2.1 nm was determined by ellipsometry. In addition, scanning electron microscopy and atomic force microscopy images of the EW/PAH composite films indicate that the film surface is relatively uniform and smooth. The photoluminescent properties of these films were investigated by fluorescence spectroscopy.
Resumo:
Interfacial waves and wave-induced tangential stress are studied for geostrophic small amplitude waves of two-layer fluid with a top free surface and a flat bottom. The solutions were deduced from the general form of linear fluid dynamic equations of two-layer fluid under the f-plane approximation, and wave-induced tangential stress were estimated based on the solutions obtained. As expected; the solutions derived from the present work include as special cases those obtained by Sun et al. (2004. Science in China, Set. D, 47(12): 1147-1154) for geostrophic small amplitude surface wave solutions and wave-induced tangential stress if tire density of the upper layer is much smaller than that of the lower layer. The results show that the interface and the surface will oscillate synchronously, and the influence of the earth's rotation both on the surface wave solutions and the interfacial wave solutions should be considered.
Resumo:
The oscillatory thermocapillary convection and hydrothermal wave in a shallow liquid layer, where a temperature difference is applied between two parallel sidewalls, have been numerically investigated in a two-dimensional model. The oscillatory thermocapillary convection and hydrothermal wave appear if the Marangoni number is larger than a critical value. The critical phase speed and critical wave number of the hydrothermal wave agree with the ones given analytically by Smith and Davis in the microgravity environment, and it travels in the direction opposed to the surface flow. Another wave traveled downstream in addition to the hydrothermal wave traveled upstream was observed in the case of earth gravity condition.
Resumo:
A mantle plume is understood as a hot, narrow, upwelling flow in the earth's mantle and accompanied by an efficient transfer of mass and energy from deep to upper layer of the earth. The cylindrical plume in earth's mantle plays an important role in explaining the origin of the surface hot spots and linear island chains. From the basic hydrodynamical equations, the detailed mechanical and thermal structure of a cylindrical plume of Newtouian fluids with temperature and pressure-dependent viscosity are given in the present paper. For two sets of rheological parameters the radial profiles of upward velocity, temperature and viscosity in the plume and radiuses of the plume at various depths have been calculated.
Resumo:
La2Zr2O7 (LZ) and La-2(Zr0.7Ce0.3)(2)O-7 (LZ7C3) as novel candidate materials for thermal barrier coatings (TBCs) were prepared by electron beam-physical vapor deposition (EB-PVD). The adhesive strength of the as-deposited LZ and LZ7C3 coatings were evaluated by transverse scratch test. Meanwhile, the factors affecting the critical load value were also investigated. The critical load value of LZ7C3 coating is larger than that of LZ coating, whereas both values of these two coatings are lower than that of the traditional coating material, i.e. 8 wt% yttria stabilized zirconia (8YSZ). The micro-cracks formed in the scratch channel can partially release the stress in the coating and then enhance the adhesive strength of the coating. The width of the scratch channel and the surface spallation after transverse scratch test are effective factors to evaluate the adhesive strength of LZ and LZ7C3 coatings.
Resumo:
Several ultrathin luminescent Langmuir-Blodgett (LB) films have been prepared by using the subphase containing the rare earth ions (Eu3+, Tb3-). The effect of the rare earth ions on the monolayer of 2-n-heptadecanoylbenzoic acid (HBA) was investigated. IR and UV spectra showed the rare earth ions were bound to the carboxylic acid head groups and the coordination took place between the polar head group and the rare earth ions. The layer structure of the LB films was demonstrated by low-angle X-ray diffraction. UV absorbance intensity increases linearly with the number of LB films layers, which indicate that the LB films are homogeneously deposited. The LB films can give off strong fluorescence. and the signal can be detected from a single layer. The characteristic luminescence behaviors of LB films have been discussed compared with those of the complexes.
Resumo:
An Electroluminescent device with PVK film doped with Eu(TTA)(3) Phen and PBD was fabricated. The device structure of glass substrate/indium-tin-oxide/PPV/PVK : Eu(TTA)3 Phen : PBD/Alq(3)/Al was employed. A sharply red electroluminescence with a maximum luminance of 56. 8 cd/m(2) at 48 V was achieved.