Bird and mammal conservation in Gaoligongshan Region and Jingdong County, Yunnan, China: patterns of species richness and nature reserves

Elevational and latitudinal patterns of species richness for birds and mammals were compared with human population density in relation to nature reserve designation in two areas of Yunnan Province, China. Results suggest that species richness is not the same for the two areas. In Gaoligongshan Region, species richness is inversely correlated with elevation and altitude, while reserve designation is positively correlated with elevation and latitude. In Jingdong County, reserve designations are positively correlated with elevation, but species richness shows no clear trends. In general, the present situation is strongly influenced by human activities. It appears that reserve designation is mismatched with species richness in Gaoligongshan Region, while there is a better fit between the two in Jingdong County. In both areas, however, it appeared that reserves were located primarily in order to reduce conflict with humans rather than to maximize conservation of biodiversity, probably because humans were responsible for forest-especially primary forest-destruction and degradation in the low-lying areas.

镇海棘螈繁殖群体生态和遗传结构研究

genetics, such as: population size, reproduction, mating system, growth, development,genetic structure and systematics status; The main results are presented below: The seasonal variation of the operational sexual ratio of this animal was found in the field and the ration always bias the female in the breeding season. Aiming at this character and considering the distance of time and space of both sexual habitat in breeding season, we census female population first by toe-clipping mark-recapture method, then estimated the population size with the definitive sexual ratio. Up to now, this species was found only at the Beilun district of the Ningbo City. The population size of the Ruiyan Temple Forest Park approximates to 369. The status of this population is extremely endangered, so besides protecting this population at the original locality, we also suggested to breed the salamander in fenced locality and to hatch embryos artificially, and send metamorphosed juveniles back to nature. We can transfer some individuals to other similar habitats or breed them under artificial conditions for saving this species from extinction. The early developmental stage of the Chinhai salamander is the same as its relative species, E. andersoni. Their balanceres are poorly developed and disappear very early. Temperature and moisture significantly influence the embryonic development of the Chinhai salamander. The embryonic stage is approx. 29 days under room temperature. The hatchling grows in a logarithmic curve. The larvae stage in water is approx. 58- 88 days. Many factors influence the nomal development, including two aspects of internal and external. Due to these factors, the effective protected measures were presented in detail. The breeding migration of E. chinhaiensis takes place at late March～late April every year. This salamander's hatching rate is high, but the rate of hatchling migrating into water is low. The average effectiveness of all the nest sites is 36.7%. The maternal self-conservation was contrary to the reproductive success of the egg-laying strategy. In the strategy of egg-laying behavior, the first factor selected by the female was its self-conservation, the second is embryonic survival rate, and the last is rate of hatchling survival rate. The oviposition selection is significant for the survival of the larvae. Based on the analysis of the evolutionary process of reproductive behaviors nad egg-laying site selections of all genera of the family Salamandridae, we deduced that perhaps Echinotriton is a transitional type in the evolutionary process from water to land. Due to its location in the adaptive stage in the terrestrial evolution, Echinotriton chinhaiensis's terrestrial nest may be one of important reason that causes this species to be endangered. The genetic deversity analysis shows that although the population size of the Chinhai salamander is quite small compared to other Chinese salamandrid species, the genetic diversity of this population is not reduce remarkably. We explain this phenomena with the polygamy mating system of this species. The result of 4 families' parenthood determinations shows that the parenhood determination can be taken without any paternal information. The "children" of every female include rich genetic information from at least two "fathers". It implies that female Chinhai salamander mates more than once with different males in a breeding season. The molecular evidence, the behavioral observation evidences and the sperm evidence in the female cloaca proved that this species has a polygamy mating system. The kin recognition in the mating of adult salamander was first discussed. The taxonomic status and phylogenetic relationships of 12 species representing 6 genera in the family Salamandridae were studied using DNA fingerprinting. The results showed that the DNA fingerprinting. The results showed that the DNA fingerprinting patterns demonstrated rich genetic diversity and species diversity, and also revealed the taxonomic status and phylogenetic relationshipes of higher taxa to a certain extent. The results are highly consistent with those obtained from the studies based on the morphology, ecology, cytology and molecular biology. The compreshensive analysis indicate that Tylototrition hainanensis and T. wenxianensis should be valid species; Echinotriton should be a valid genus;Tylotortriton is a natural cluster; Tylotortriton asperrimus should be put in Tylototrition rather than in Echinotriton, Hypselotriton and Allomestriton are synonyms of Cynops and Paramesotriton, respectively. There are three main groups in Chinese salamandride: Cynops, Paramesotriton and Pachytrition from the first group, the species of the Tylototriton from the second, and E. chinhaiensis composes the third.

A moored underwater energy conservation system for profiling measurement

There is a need to obtain the hydrologic data including ocean current, wave, temperature and so on in the South China Sea. A new profiling instrument which does not suffer from the damage due to nature forces or incidents caused by passing ships, is under development to acquire data from this area. This device is based on a taut single point mid-water mooring system. It incorporates a small, instrumented vertically profiling float attached via an electromechanical cable to a winch integral with the main subsurface flotation. On a pre-set schedule, the instrument float with sensors is winched up to the surface if there is no strip passing by, which is defined by an on-board miniature sonar. And it can be immediately winched down to a certain depth if the sonar sensor finds something is coming. Since, because Of logistics, the area can only be visited once for a long time and a minimum of 10 times per day profiles are desired, energy demands are severe. To respond to these concerns, the system has been designed to conserve a substantial portion of the potential energy lost during the ascent phase of each profile and subsequently use this energy to pull the instrument down. Compared with the previous single-point layered measuring mode, it is advanced and economical. At last the paper introduces the test in the South China Sea.

基于信息重建技术的地震信号处理方法研究

The dissertation addressed the problems of signals reconstruction and data restoration in seismic data processing, which takes the representation methods of signal as the main clue, and take the seismic information reconstruction (signals separation and trace interpolation) as the core. On the natural bases signal representation, I present the ICA fundamentals, algorithms and its original applications to nature earth quake signals separation and survey seismic signals separation. On determinative bases signal representation, the paper proposed seismic dada reconstruction least square inversion regularization methods, sparseness constraints, pre-conditioned conjugate gradient methods, and their applications to seismic de-convolution, Radon transformation, et. al. The core contents are about de-alias uneven seismic data reconstruction algorithm and its application to seismic interpolation. Although the dissertation discussed two cases of signal representation, they can be integrated into one frame, because they both deal with the signals or information restoration, the former reconstructing original signals from mixed signals, the later reconstructing whole data from sparse or irregular data. The goal of them is same to provide pre-processing methods and post-processing method for seismic pre-stack depth migration. ICA can separate the original signals from mixed signals by them, or abstract the basic structure from analyzed data. I surveyed the fundamental, algorithms and applications of ICA. Compared with KL transformation, I proposed the independent components transformation concept (ICT). On basis of the ne-entropy measurement of independence, I implemented the FastICA and improved it by covariance matrix. By analyzing the characteristics of the seismic signals, I introduced ICA into seismic signal processing firstly in Geophysical community, and implemented the noise separation from seismic signal. Synthetic and real data examples show the usability of ICA to seismic signal processing and initial effects are achieved. The application of ICA to separation quake conversion wave from multiple in sedimentary area is made, which demonstrates good effects, so more reasonable interpretation of underground un-continuity is got. The results show the perspective of application of ICA to Geophysical signal processing. By virtue of the relationship between ICA and Blind Deconvolution , I surveyed the seismic blind deconvolution, and discussed the perspective of applying ICA to seismic blind deconvolution with two possible solutions. The relationship of PC A, ICA and wavelet transform is claimed. It is proved that reconstruction of wavelet prototype functions is Lie group representation. By the way, over-sampled wavelet transform is proposed to enhance the seismic data resolution, which is validated by numerical examples. The key of pre-stack depth migration is the regularization of pre-stack seismic data. As a main procedure, seismic interpolation and missing data reconstruction are necessary. Firstly, I review the seismic imaging methods in order to argue the critical effect of regularization. By review of the seismic interpolation algorithms, I acclaim that de-alias uneven data reconstruction is still a challenge. The fundamental of seismic reconstruction is discussed firstly. Then sparseness constraint on least square inversion and preconditioned conjugate gradient solver are studied and implemented. Choosing constraint item with Cauchy distribution, I programmed PCG algorithm and implement sparse seismic deconvolution, high resolution Radon Transformation by PCG, which is prepared for seismic data reconstruction. About seismic interpolation, dealias even data interpolation and uneven data reconstruction are very good respectively, however they can not be combined each other. In this paper, a novel Fourier transform based method and a algorithm have been proposed, which could reconstruct both uneven and alias seismic data. I formulated band-limited data reconstruction as minimum norm least squares inversion problem where an adaptive DFT-weighted norm regularization term is used. The inverse problem is solved by pre-conditional conjugate gradient method, which makes the solutions stable and convergent quickly. Based on the assumption that seismic data are consisted of finite linear events, from sampling theorem, alias events can be attenuated via LS weight predicted linearly from low frequency. Three application issues are discussed on even gap trace interpolation, uneven gap filling, high frequency trace reconstruction from low frequency data trace constrained by few high frequency traces. Both synthetic and real data numerical examples show the proposed method is valid, efficient and applicable. The research is valuable to seismic data regularization and cross well seismic. To meet 3D shot profile depth migration request for data, schemes must be taken to make the data even and fitting the velocity dataset. The methods of this paper are used to interpolate and extrapolate the shot gathers instead of simply embedding zero traces. So, the aperture of migration is enlarged and the migration effect is improved. The results show the effectiveness and the practicability.