Characteristics of 980/1550 nm WDM coupler based on planar curved waveguides

A wavelength division multiplexer (WDM) for 980/1550 nm based on planar curved waveguide coupler (CWC) is proposed. Compared with conventional parallel straight waveguide coupler (SWC), this structure has more flexibility with two variable parameters of bending radius R and minimum edge-to-edge spacing do, which are the two main parameters for the splitting ratio of coupler and decrease the complexity of device design and fabrication. Based on coupled mode theory (CMT) and waveguide theory, R and do of the WDM CWC are designed to be R = 13.28 m and d(0) = 4.39 mu m. The contrast ratio (CR) and insertion loss (IL) for 980 and 1550 nm are CR1 = 24.62 dB, CR2 = 24.56 dB and IL1 = 0.014 dB, IL2 = 0.015 dB, respectively. The 3D beam propagation method (BPM) is used to verify the validity of the design result. The influence of R and d(0) variations on the device performance is analyzed. For CR > 20 dB, the variation ranges of R and d(0) should be within -0.10 to +0.44 m and -0.05 to + 0.02 mu m, respectively. (c) 2006 Elsevier GmbH. All rights reserved.

Bismuth-activated luminescent materials for broadband optical amplifier in WDM system

New broadband near infrared luminescence covering the whole work windows (1260-1625 nm) of the current wavelength division multiplexing (WDM) system was found from bismuth-activated M2O-Al2O3-SiO2 (M = Li, Na) and Li2O-Ta2O5-SiO2 glasses at room temperature in the case of 808 nm-laser excitation. But the near infrared luminescence mechanism of the bismuth-activated glasses is not well understood up to now. The figure-of-merits of bandwidth and gain of the glasses are better than those of Er3+-doped silicate glasses and Ti3+ doped sapphire, implying they are the promising gain-medium candidates for the broadband amplifiers and the widely tunable laser sources. (c) 2007 Elsevier B.V. All rights reserved.

光滤波器及其在FDM/WDM通信系统中的研究

Submitted by zhangdi (zhangdi@red.semi.ac.cn) on 2009-04-13T11:45:31Z

Injection locked Fabry-Perot laser diodes for WDM passive optical network spare function

In this paper, a protection scheme for transmitters in wavelength-division-multiplexing passive optical network (WDM-PON) has been proposed and demonstrated. If any downstream transmitter encounters problems at the central office (CO), the interrupted communication can be restored immediately by injecting a Fabry-Perot laser diode (FP-LD) with the upstream lightwave corresponding to the failure transmitter. Compared with the conventional methods, this proposed architecture provides a cost-effective and reliable protection scheme employing a common FP-LD. In the experiment, a 1 36 protection capability was implemented with a 2.5 Gbit/s downstream transmission capability. (C) 2009 Elsevier B.V. All rights reserved.

用于WDM系统的垂直腔可调谐光电器件

从理论模型出发分析了实现垂直腔光电器件可调谐的方法，讨论了静电激励的1／3原则，及其对调谐性能的影响，从国内外几个有代表性的研究小组的工作出发，介绍了最新的研究进展。

利用WDM光纤耦合器的光纤光栅传感解调技术

根据WDM光纤耦合器波长解调方案的工作原理、偏振特性以及影响系统波长分辨力的因素,提出一种改进的利用WDM光纤耦合器的光纤光栅传感解调技术.该技术在原技术的基础上,采用偏振控制器控制入射光偏振状态,提高了解调的精度和稳定性.对WDM光纤耦合器的多次波长扫描结果表明,采用偏振控制器后,其波长误差可减小到5pm左右.实验采用1540/1560nm的WDM光纤耦合器对单点光纤光栅应变传感器进行静态解调,结果表明:按此技术开发的解调系统具有0.01nm波长分辨力和10nm的波长线性解调范围.

Investigation on integrated high speed DFB light source and narrow bandwidth RCE photodetector for WDM fiber communication network application

Electroabsorption (EA) modulator integrated with partially gain coupling distributed feedback (DFB) lasers have been fabricated and shown high single mode yield and wavelength stability. The small signal bandwidth is about 7.5 GHz. Strained Si1-chiGechi/Si multiple quantum well (MQW) resonant-cavity enhanced (RCE) photodetectors with SiO2/Si distributed Bragg reflector (DBR) as the mirrors have been fabricated and shown a clear narrow bandwidth response. The external quantum efficiency at 1.3 mum is measured to be about 3.5% under reverse bias of 16 V. A novel GaInNAs/GaAs MQW RCE p-i-n photodetector with high reflectance GaAs/ALAs DBR mirrors has also been demonstrated and shown the selectively detecting function with the FWHM of peak response of 12 nm.

基于WDM模型的PCI卡驱动程序设计

基于WDM模型的PCI卡驱动程序设计,是建立Windows操作系统下数据采集系统面临的关键问题。详细分析了WDM驱动程序的工作原理。以PCI9113A数据采集卡为例,提出了利用Microsoft公司的DDk实现Windows2000操作系统下驱动程序的有效开发方法。讨论了驱动程序的测试和封装。

WDM驱动程序在HIRFL-CSR电源控制系统中的应用

为解决基于Web多层架构的HIRFL-CSR电源控制系统的可靠性和实时性差的问题,利用直接在WDM驱动程序中处理被控设备异常的方法来提高控制系统的可靠性和实时性, WDM驱动程序利用WMI主动向应用程序报告被控设备的异常,简化了控制系统的软件结构,从而进一步提高控制系统的实时性和控制效率。

Windows2000的管理机制(WMI)和WDM驱动程序的研究与应用

主要介绍了一种新型的企业管理和设备测试系统。首先描述了WMI的优点及其体系结构。然后介绍怎样把WMI机制和WDM驱动程序结合起来。最后给出一个访问WMI的标准的方法。

光纤环形镜在光纤通信中的应用

介绍了光纤环形镜的工作原理,讨论了近年来其在高速光开关,波分复用器以及特性测量等领域的若干应用研究.

平面弯曲波导耦合器的特性分析

根据耦合模理论和弯曲波导耦合器的结构特点,对平面弯曲波导耦合器的特性进行了分析,结果表明弯曲波导耦合器的弯曲半径和最小间距两个可调变量,增加了波导器件设计的灵活性;同时由于等效耦合长度的调制作用使得弯曲波导耦合器在波分复用/解复用中比平行直波导耦合器具有更大的复用带宽;分析了弯曲半径和最小间距对弯曲波导耦合器复用带宽的影响,为实际波导器件的设计制作提供了一定的理论依据.

单长周期光栅迈克耳孙干涉仪特性研究

单长周期光栅迈克耳孙（Michelson）干涉仪是由尾纤端面蒸镀高反膜的单根长周期光纤光栅构成。入射光经长周期光栅后，部分被耦合到包层中传输。经过包层和纤芯传输的光信号经尾纤端面反射后，重新耦合回到长周期光栅中，在光栅区域形成干涉。通过理论计算分析了各种因素对其光谱响应的影响。从实验上得到了干涉光谱的谐振峰波长位移与光纤段温度变化成良好的线性关系，测得其温度系数为31．3pm／℃。表明这种结构可用于高温传感或作为波分复用滤波器。