Effects of Cu-Wire Surface Fluctuations on Early Failures

Different chemical mechanical polishing （CMP） slurries are used to obtain single-damascene Cu-wires with different surface fluctuations as well as pre-existing surface-defects in wires with rougher surfaces. The presence of such pre-existing defects strongly increases the rate of early failures to almost 100%, reduces electromigration lifetime rapidly to the level of early failures, and changes the multimodal failure distribution into monomodal. The activation energy （0. 74±0.02eV） for the failure mechanism associated with these pre-existing defects confirms a dominant surface diffusion. It shows how a weakest link approximation analysis can he applied to a single wire by dividing the wire into relevant segments and assigning different failure mechanisms to the various segments. The analysis confirms that, although surface-defects are not the fastest early failure mechanism, the ten times higher surface-defectdensity in the rougher wires is responsible for the observed high early-failure rate and unreliable performance.

CO2浓度升高对三种树木叶片化学和舞毒蛾幼虫取食及生长的影响

探讨全球气候变化的生物学和生态学效应是当今生态学中的热点，研究大气CO2浓度升高对植物-昆虫相互作用关系的影响具有重要的理论和实践意义。本文使用开顶式气室（Open-top chamber，OTC）在野外条件下研究了CO2浓度升高对三种树木（小青杨、白桦和蒙古栎）叶片化学成分含量的影响，以及树木叶片品质变化对一种广食性森林昆虫（舞毒蛾）幼虫取食、生长发育和取食偏嗜性的影响。得出如下结果：（1）CO2浓度升高对3个受试树种叶片中的营养成分及次生代谢物含量均有显著影响，总体表现为氮含量降低，而碳氮比、非结构性碳水化合物、总酚和缩合丹宁含量增加。叶片中的化学成分含量可随时间发生显著变化，不同树种、甚至同一树种不同冠层高度的叶片对CO2浓度升高的响应强度也是不同的。叶片的干物质含量和比叶重对CO2浓度升高的响应不显著。（2）室内非选择性取食实验、室内选择性取食实验以及上树取食饲养方式下的多龄期取食实验，均发现高浓度CO2处理组内舞毒蛾幼虫的生长发育受到显著抑制。但对四龄舞毒蛾幼虫所进行的短期生物测定并未发现不同CO2浓度处理下幼虫的生长发育速率、对食物的取食率和转化率等昆虫营养指标存在显著差异。（3）叶片品质的降低是导致舞毒蛾幼虫生长发育受抑制的主要原因。但是总体上，CO2浓度升高导致的叶片品质变化并未显著影响幼虫的取食率和取食量。（4）舞毒蛾幼虫对不同叶片种类表现出清晰的取食选择性，这种选择性在其幼龄期就可表现出来。幼虫对小青杨上层叶片有最显著的偏嗜性，对蒙古栎下层叶片有最明显的拒食性。但是CO2浓度升高导致的叶片品质变化对舞毒蛾幼虫的取食选择性和寄主偏嗜行为并未产生显著影响。（5）检测出高浓度CO2处理组内舞毒蛾幼虫虫粪中含有浓度更高的植物次生代谢物质（总酚和缩合单宁），这很可能是昆虫整体生长发育受抑制的重要原因之一。

油气运聚动力学的模拟分析——以准噶尔盆地为例

The petroleum migration, happening in the geologic past, is the very important and complex dynamic processes in the petroleum systems. It plays a linking role among all static factors in a system. The accumulation is in fact the result of the petroleum migration. For the petroleum geology, the dynamics research of the petroleum migration refers to the mechanism and process research, as well as the use of the quantitative methods. In this thesis, combining with the qualitative analysis and quantitative modeling, the author manages to discuss theoretically some key problems dealing with migration processes, which have not been solved yet, and to apply the studied results in petroleum system analysis in actual basins. The basin analysis offers the base of the numerical modeling for geological phenomena occurring in sedimentary basins, that consists of the sedimentary facies analysis, the section reconstructing technique, eroded thickness estimating, etc. The methods to construct the geologic model, which is needed in the research of oil and gas migration and accumulation, are discussed. The basin analysis offers also the possibility for the latter modeling works to get and select the parameters, such as stratum's thickness, age, stratigraphy etc. Modeling works were done by using two basin modeling softwares: Basin_Mod and TPC_Mod. The role of compaction during the secondary migration and the heterogeneity of migrating paths within the clastic carrier are modeled. And the conclusions were applied in the migration studies in the Jungaer Basin, lying on the Northwest part of the China. To construct a reliable migration model, the author studied the characteristics of the sedimentation, the pore fluid pressure evolution, as well as the distribution and the evolution of fluid potential, following the tectonic evolution of the Jungaer Basin. The geochemical prospecting results were used to evidence and to calibrate the migration processes: the oil-source correlation, the distribution of the properties of oil, gas and water. Finally, two important petroleum systems, Permian one and Jurassic one were studied and identified, according, principally, to the studies on the petroleum migration within the Jungaer Basin. Since the oil, as well as the gas, moves mainly in separate phase during the secondary migration, their migrating behaviors would be determined by the dynamics conditions of migration, including the driving forces and pathways. Based on such a consideration, the further understandings may be acquired: the roles played by permeable carriers and low-permeable source rock would be very different in compaction, overpressure generation, petroleum migration, and so on. With the numerical method, the effect of the compaction on the secondary migration was analyzed and the results show that the pressure gradient and the flux resulted from compaction are so small that could be neglected by comparing to the buoyancy of oil. The main secondary migration driving forces are therefore buoyancy and capillary within a hydrostatic system. Modeling with the commercial software-Basin_Mod, the migration pathways of petroleum in clastic carriers seem to be inhomogeneous, controlled by heterogeneity of the driving force, which in turn resulted from the topography of seals, the fabrics and the capillary pressure of the clastic carriers. Furthermore, the direct and indirect methods to study fault-sealing properties in the course of migration were systemically summarized. They may be characterized directly by lithological juxtaposition, clay smear and diagenesis, and indirectly the comparing the pressures and fluid properties in the walls at two apartments of a fault. In Jungaer Basin, the abnormal pressures are found in the formations beneath Badaowan or Baijantan Formation. The occurrence of the overpressure seems controlled by the stratigraphy. The rapid sedimentation, tectonic pressuring, clay sealing, chemical diagensis were considered as the principal pressuring mechanisms. The evolution of fluid pressure is influenced differently at different parts of the basin by the tectonic stresses. So the basin appears different pressure evolution cycles from each part to another during the geological history. By coupling the results of thermal evolution, pressure evolution and organic matter maturation, the area and the period of primary migration were acquired and used to determine the secondary migration time and range. The primary migration in Fengcheng Formation happened from latter Triassic to early Jurassic in the main depressions. The main period of lower-Wuerhe Formation was at latter Jurassic in Changji, Shawan and Pen-1-jing-xi Depression, and at the end of early Cretaceous in Mahu Depression. The primary migration in Badaowan and Sangonghe Formation is at the end of early-Cretaceous in Changji Depression. After then, the fluid potential of oil is calculated at the key time determined from area and time of the primary migration. Generally, fluid potential of oil is high in the depressions and low at the uplifts. Synthetically, it is recognized that the petroleum migration in the Jungaer Basin is very complex, that leads us to classify the evolution of petroleum systems in Northwestern China as a primary stage and a reformed one. The remigration of accumulated petroleum, caused by the reformation of the basin, results in the generation of multiple petroleum systems. The faults and unconformities are usually the linkers among the original petroleum systems. The Permian petroleum system in Jungaer Basin is such a multiple petroleum system. However, the Jurassic petroleum system stays still in its primary stage, thought the strong influences of the new tectonic activities.