The Flow Theory of Mechanism-Based Strain Gradient Plasticity

The flow theory of mechanism-based strain gradient (MSG) plasticity is established in this paper following the same multiscale, hierarchical framework for the deformation theory of MSG plasticity in order to connect with the Taylor model in dislocation mechanics. We have used the flow theory of MSG plasticity to study micro-indentation hardness experiments. The difference between deformation and flow theories is vanishingly small, and both agree well with experimental hardness data. We have also used the flow theory of MSG plasticity to investigate stress fields around a stationary mode-I crack tip as well as around a steady state, quasi-statically growing crack tip. At a distance to crack tip much larger than dislocation spacings such that continuum plasticity still applies, the stress level around a stationary crack tip in MSG plasticity is significantly higher than that in classical plasticity. The same conclusion is also established for a steady state, quasi-statically growing crack tip, though only the flow theory can be used because of unloading during crack propagation. This significant stress increase due to strain gradient effect provides a means to explain the experimentally observed cleavage fracture in ductile materials [J. Mater. Res. 9 (1994) 1734, Scripta Metall. Mater. 31 (1994) 1037; Interface Sci. 3(1996) 169].

Analysis of instability of a cylindrical soap film of finite dimensions

By means of experiments of instability of a uniform cylindrical soap film, Boys had showed that the bubble molded by the film is unstable when its length is greater than its circumference. Recently that is generally called the Rayleigh Criterion. In this paper, a linear theory in hydrodynamics is applied to analyze the stability of the cylindrical soap film supported by two equal size disks; all conditions of the stationary wave on the end plates of two disks are given. From here we get that the Rayleigh Criterion on the stability of the cylindrical soap film is proved.

Effect of Work of Adhesion on Nanoindentation

Three adhesion contact models, JKR (Johnson-Kendall-Roberts), DMT (Derjaguin-Muller-Toporov) and MD (Maugis-Dugdale) are compared with the Hertz model in dealing with the nano-contact problems. It has been shown that the dimensionless load parameter, $\bar{P}=P/(\pi\Delta\gamma R)$, and the transition parameter, $\Lambda$, have significant influences on the contact stiffness (contact area) at micro/nano-scale and should not be ignored in shallow nanoindentation.

Experimental Investigation Of Influence Of Interfacial Tension On Convection Of Two-Layer Immiscible Liquid

Benard-Marangoni convections of two-layer fluids heated from the bottom are investigated experimentally with a particle imagine velocimetry. The flows are visualized from the side, and various velocity fields near the onset of convection, such as three-layer vortex convective patterns, are observed when the depth ratio varies in a wide range. A new classification of the convective patterns is proposed with more detail than in previous studies. The analysis of the results indicates that the interface tension greatly influences the motion intensities of the bottom and top layers. The dimensionless wave number increases with the Bond number when the motion in the top layer is not more intense than that in the bottom layer, which agrees with the theoretical prediction.

Talbot-SNOM method for non-contact evaluation of high-density gratings

A Talbot scanning near-field optical microscopy (SNOM) method for non-contact evaluating of high-density gratings was described. This method combines the Talbot self-imaging effect of the gratings and the conventional SNOM technique without damage. The significant advantages of this method are its simple structure, reliable and fast measurement for the surface quality of the tested gratings. Experimental results of three different kinds of gratings were demonstrated to indicate that this method is effective for evaluation surface quality of high-density gratings. (c) 2004 Elsevier B.V. All rights reserved.

光折变空间光孤子

回顾了光折变孤子的相关研究及最新进展,描述了光折变孤子的形成及特性,分析了光折变孤子形成的理论机理,展示了光折变孤子的相互作用,说明了光折变孤子的应用价值及缺陷.

发散光束小尺度自聚焦特性的研究

研究了发散光束的小尺度自聚焦效应。从非线性傍轴波动方程出发，利用坐标变换，推导出发散光束小尺度扰动的传输方程，进而得到小尺度扰动增长的临界频率、最大增长频率和相应B积分值的变化规律。研究了发散光束初始曲率半径对小尺度自聚焦效应的影响。结果表明，对于一定的传输距离，随着发散光束初始曲率半径的减小，小尺度扰动的最大增长频率减小，相应的最大增益减小，即B积分值也减小。对于一定的初始曲率半径，随着传输距离的增大，B积分值增长变缓，并最终停止。利用局部能量守恒定律研究了发散光束的成丝距离，发现小的初始曲率半径可以延

水迷宫大鼠脑内记录神经元放电的装置

本发明涉及一种水迷宫大鼠脑内记录神经元放电的装置，属神经电生理学实验装置。该装置由固定在大鼠头上的微电极微推进器(2)，固定在微电极微推进器(2)的保护盒(12)上的前置放大器(3)，通过电缆(5)与前置放大器(3)的输出端相连的后置放大器(6)，与后置放大器(6)的输出端相连的滤波器(7)，分别与滤波器(7)和摄像镜头(1)连接的行为、电生理数据记录系统(8)组成。具有能够在大鼠进行水迷宫训练及测试的同时，记录并观察大鼠脑内相关神经元电活动情况，所用装置防水性能良好、抗干扰性强，结构轻便，实用性强等优点。

从大肠杆菌中获得眼镜蛇毒神经多肽菌株及其获得方法

本发明为一种从大肠杆菌中获得眼镜蛇毒神经多肽菌株及其获得方法，主要是通过从天然眼镜蛇毒神经多肽所测定的一级结构，利用基因载体pET21b，构建的重组质粒pET21b-Cbt，转化至大肠杆菌BL21中，而获得能高效表达眼镜蛇毒神经多肽的菌株。该方法具有直接表达、分离纯化工艺简便、活性高等特点。该菌株的表达产物和天然眼镜蛇毒神经多肽有同样的结构和活性，可以替代天然眼镜蛇毒神经多肽，可以满足逐渐增加的市场需求，又能保护蛇资源，是一种有应用前景的表达菌株。

土壤锗污染对土壤微生物的生态毒理效应

着重讨论土壤添加Ge对土壤微生物的生态效应及土壤Ge污染临界含量。盆栽试验表明,在土壤Ge含量2～2 0 0mgkg-1范围,低浓度Ge对土壤细菌、真菌、放线菌有刺激作用,随着浓度增高,而交替出现抑制和刺激作用。土壤Ge浓度与明亮发光杆菌T3发光度之间有极显著的负相关性,按照T3发光度80 %和10 0 %为临界值,计算得土壤Ge临界浓度分别为5 0 2mgkg-1和5 8mgkg-1。

镉和铜对嗜热四膜虫金属硫蛋白基因的诱导表达

本文在荧光定量PCR优化的基础上,利用该技术考察了不同浓度的重金属镉和铜对嗜热四膜虫金属硫蛋白基因(MTT1)诱导表达的变化规律。结果表明MTT1基因的表达对镉离子的诱导更灵敏,且在一定阈值浓度(≤35.2μmol/L)范围内,镉离子浓度升高会增加MTT1基因表达量,超过该阈值后表达量迅速下降;镉与铜同时诱导时MTT1基因的表达情况与镉单独诱导的类似,但阈值浓度减小为22μmol/L,表明二者的联合毒性为协同作用。镉离子浓度低于22μmol/L时,与铜离子的共同作用会大大增加MTT1基因的表达量,从而增强

Experimental study of a pulsed ytterbium-doped fibre laser with fast and slow saturable absorbers in a linear cavity

We present a linear-cavity stretched-pulse fibre laser with mode locking by a nonlinear polarization rotation and by semiconductor saturable-absorber mirrors. A Q-switched mode-locking cw train and a mode-locking pulse train are obtained in the experiment. We investigate the effects of the equivalent fast saturable absorber and the slow saturable absorbers in experiment. It is found that neither the nonlinear polarization evolution effect nor a semiconductor saturable absorber mirror is enough to produce the stable cw mode-locking pulses in this experiment. A nonlinear polarization evolution effect controls the cavity loss to literally carve the pulses; semiconductor saturable absorber mirrors provide the self-restarting and maintain the stability of the mode-locking operation.

一种网格环境下的密码计算模型

由于密码学和信息安全领域的许多问题最终都被转化为一个耗时的计算,其中许多计算需要利用多台异构的和地理分布的计算机协同,才能有效完成.密码算法的设计、分析和应用对于计算环境敏感,且依赖性较强,不同类型的算法和算法的不同实现模式对计算环境要求差异很大,而且到目前为止还不存在一种通用的分布式密码计算模型.为此,本文根据密码计算本身的需求,首先分别分析了密码算法设计、分析和应用的目标和特征,提出了相应的计算模式,给出了一种网格环境下的通用密码计算模型.进而讨论了密码计算任务分割策略,资源分配和负载平衡问题.最后给出了网格环境Globus Toolkit下的模型构架、实现与实验结果.