Microstructures and mechanical properties of as-cast Mg–5Al–0.4Mn–xNd (x=0, 1, 2 and 4) alloys

Mg-5Al-0.4Mn-xNd (x=0, 1, 2 and 4wt.%) alloys were prepared by metal mould casting method. The microstructures and mechanical properties were investigated. The results demonstrated that Al11Nd3 phase was formed and mainly aggregated along the grain boundaries with the addition of Nd. Meanwhile, the grain sizes were greatly reduced with the increasing Nd content.

Microstructures and mechanical properties of Mg-8Gd-0.6Zr-xNd (x=0, 1, 2 and 3 mass%) alloys

Mg-8Gd-0.6Zr-xNd (x = 0, 1, 2 and 3 mass%) alloys were prepared by metal mould casting method, and the microstructures, age hardening responses and mechanical properties have been investigated. The microhardness of the as-cast alloys is increased with increasing Nd content. The age hardening behavior and mechanical properties are enhanced significantly by adding Nd element. The peak ageing hardness of the Mg-8Gd-0.6Zr-3Nd alloy is 103, it is about 1.3 times more than that of the Mg-8Gd-0.6Zr alloy. The aged Mg-8Gd-0.6Zr-3Nd alloy exhibits maximum ultimate tensile strength and yield strength, and the values are 271 and 205 MPa at room temperature, 205 MPa and 150 MPa at 250 degrees C, respectively. Which are about 2 times higher than those of Mg-8Gd-0.6Zr alloy. The improved hardness and strength are mainly attributed to the fine dispersiveness Of Mg5RE and Mg12RE precipitates in the alloy.

DIFFERENT INTERDIFFUSION CHARACTERISTICS BETWEEN AG/YBA2CU3O7-X AND AL/YBA2CU3O7-X CONTACT INTERFACES

The differences between the interdiffusion characteristics of Ag/YBa2Cu3O7-x and Al/YBa2Cu3O7-x contact interfaces have been revealed by secondary ion mass spectrometry (SIMS). The different electrical properties of Ag/YBa2Cu3O7-x and YBa2Cu3O7-x films after high temperature treatment are well understood by the SIMS results.

Studies on biodegradable poly(hexano-6-lactone) fibers 1. Structure and properties of drawn poly(hexano-6-lactone) fibers

Using high molecular weight (M-n=80,000) Poly(hexano-6-lactone) (PCL'), tough and high tenacity PCL monofilaments with various draw ratios (undrawn to 9 times drawn) were prepared by melt-spinning. The relationship between microstructure and properties of the PCL fibers is described in this current IUPAC Technical Report. Analysis of microstructure of the drawn PCL fibers by wide-angle X-ray diffraction revealed typical c-axis orientation with an increase in crystallinity. It was also supported by sonic velocity measurements. The thermal, mechanical, and dynamic mechanical properties of the PCL fibers were affected significantly by draw ratio. DSC thermograms showed that the melting temperature and the enthalpy of fusion increased with draw ratio. The temperature dependence curves of dynamic viscoelasticity showed that the temperature at tan delta peak of alpha dispersion corresponding to the glass transition temperature shifted toward higher temperature and the peak value of tan delta decreased with draw ratio. The dynamic storage modulus and the sonic modulus increased with draw ratio. These results are due to the increase in crystallinity and molecular orientation with drawing, and are responsible for an increase in tensile tenacity as well as knot tenacity of the PCL fibers.

Investigation on molecular and crystal structures of metal complexes with aminopolycarboxylic acids .1. Synthesis and structure of Na-2[Fe-III(ida)(2)](2)center dot 3H(2)O

The crystal structure of the title complex salt has been determined by single-crystal X-ray structure analysis. The crystal data areas follows; Monoclinic, P2(1)/c, a=15.6480(10)Angstrom, b=16.7870(10)Angstrom, c=10.347(2)Angstrom, beta=90.790(10), V=2717.7(6)Angstrom(3), Z=3, and R=0.0333 for 4789 unique reflections. The complex anion has a pseudo-octahedral structure distorted more than the Cr-III and Co-III analogs, in which each, iminodiacetato ligand (ida(2-)) is coordinated in a facial fashion with the two N atoms in a cis configuration, resulting in an unsym-fac structure.

Ansa-metallocene derivatives .2. Syntheses and structures of tetramethyldisiloxandiyl bis(1-indenyl and tetrahydroindenyl) zirconium dichlorides

The ansa-zirconocene derivative tetramethyldisiloxandiyl bis(1-indenyl) zirconium dichloride (1) has been prepared by the reaction of the dilithium salt of 1,3-bis(l-indenyl) tetramethyldisiloxane with ZrCl4 . 2THF, After catalytic hydrogenation, the corresponding tetrahydroindenyl complex (2) has been formed. Both 1 and 2 have been shown by H-1 NMR spectra to be the mixture of the cis(meso) and trans(rac) isomers, The pure trans isomers 1(l), 2(l) and cis isomer 2(c) were obtained by recrystallization, The crystal structures of 1(l) and 2(c) were determined by X-ray diffraction. Both crystals of 1(l) and 2(c) are monoclinics, belonging to space groups P2(1)/n(1(l)) and P2(1)/c(2(c)). In the unit cell of 2(c), one of the six-membered rings of the tetrahydroindenyl Ligands has two different conformations which have the same probabilities.

PENDANT FUNCTIONAL-GROUP COPOLYETHER SULFONES .1. SYNTHESIS AND CHARACTERIZATION OF NEW COPOLYETHER SULFONES WITH PENDANT ALDEHYDE GROUPS MODIFIED INTO PHENOLIC AZOMETHINE GROUPS

New functional copolyether sulfones with pendant aldehyde groups were synthesized by the classical polycondensation reaction between 4,4' -dichlorodiphenyl sulfone (I) and various bisphenols such as 5,5'-methylene bis-salicylaldehyde (II-2), 2,2-bis( 4-hydroxyphenyl)propane (III), and 2,6-bis(4-hydroxybenzylidene)cyclohexanone (IV). Condensation reaction with 4-aminophenol led to pendant phenolic azomethine groups containing copolyether sulfones. The structures of the resulting polymers were confirmed by IR, H-1-NMR spectra, and elemental analyses. The polymers were characterized by reduced viscosity, solubility, thermal stability, DSC, and x-ray diffraction measurements.

The Homology and Relationship of Human (Homo sapiens) Chromosomes 1, 19 and Dusky Langur (Trachypithacus obscurus) Chromosomes 6, 8 Demonstrated with Chromosome Painting

http://www.jstage.jst.go.jp/

Absence of association between SNPs in the promoter region of the insulin-like growth factor 1 (IGF-1) gene and longevity in the Han Chinese population

Previous studies have indicated that genetic variations in the factors of insulin/insulin-like growth factor 1 (IGF-1) signaling pathway could influence human life-span by affecting IGF-1 levels. The promoter region of the IGF-1 gene is an obvious candida

Sequence of genome segments 1, 2, and 3 of the grass carp reovirus (Genus Aquareovirus, family Reoviridae)

The genome segments 1, 2, and 3 of the grass carp reovirus (GCRV), a tentative species assigned to genus Aquareouirus, family Reouiridae, were sequenced. The respective segments 1, 2, and 3 were 3949, 3877, and 3702 nucleotides long. Conserved moths 5' (GUUAUUU) and 3' (UUCAUC) were found at the ends of each segment. Each segment contains a single ORF and the negative strand does not permit identification of consistent ORFs. Sequence analysis revealed that VP2 is the viral polymerase, while VPI might represent the viral guanyly/methyl transferase (involved in the capping process of RNA transcripts) and VP3 the NTPase/helicase (involved in the transcription and capping of viral RNAs), The highest amino acid identities (26-41%) were found with orthoreovirus proteins. Further genomic characterization should provide insight about the genetic relationships between GCRV, aquareoviruses, and orthoreoviruses, It should also permit to precise the taxonomic status of these different viruses. (C) 2000 Academic Press.

Synthesis and characterization of optically active aromatic polyimides derived from 2,2 '-bis(2-trifluoro-4-aminophenoxy)-1,1 '-binaphthyl and aromatic tetracarboxylic dianhydrides

Optically active 2,2'-bis(2-trifluoro-4-aminophenoxy)-1,1'-binaphthyl and its corresponding racemate were prepared by a nucleophilic substitution reaction of 1,1'-bi-2-naphthol with 2-chloro-5-nitrotrifluorotoluene and subsequently by the reduction of the resulting dinitro compounds. a series of optically active and optically inactive aromatic polyimides also were prepared therefrom, These polymers readily were soluble in common organic solvents such as pyridine, N,N'-dimethylacetamide, and m-cresol and had glass-transition temperatures of 256 similar to 278 degrees C. The specific rotations of the chiral polymers ranged from 167 similar to 258 degrees, and their chiroptical properties also were studied. (C) 1999 John Wiley & Sons Inc.