SUSPENDED SEDIMENT TRANSPORT IN THE OFFSHORE NEAR YANGTZE ESTUARY

Based on the Estuarine, Coastal and Ocean Modeling System with Sediments (ECOMSED) model, a 3-D hydrodynamic-transport numerical model was established for the offshore area near the Yangtze Estuary in the East China Sea. The hydrodynamic module was driven by tide and wind. Sediment module included sediment resuspension, transport and deposition of cohesive and non-cohesive sediment. The settling of cohesive sediment in the water column was modeled as a function of aggregation (flocculation) and deposition. The numerical results were compared with observation data for August, 2006. It shows that the sediment concentration reduces gradually from the seashore to the offshore area. Numerical results of concentration time series in the observation stations show two peaks and two valleys, according with the observation data. It is mainly affected by tidal current. The suspended sediment concentration is related to the tidal current during a tidal cycle, and the maximum concentration appears 1 h-4 h after the current maximum velocity has reached.

Analysis of corrosive environmental factors of seabed sediment

The corrosivity of seabed sediment at spots at different distances from seashore was studied based on in situ investigations in the northern sea area of the Yellow River mouth. The results show that there is close relation between distance from seashore and corrosivity of seabed sediment.

滩海过渡带地震资料拼接处理方法研究

The technology of seismic acquirement has been more and more intact in both land area and marine area, however, since the acquirement equipment can not handle the tasks in this both two kinds of prospects at the same time, it is very hard to acquire in the prospect of seashore area, and also the quality of the raw data is poor, the related work in seashore area has been a tough task. With the development of the level of exploration, acquired equipment and technology, a certain series of processing methods has been built up, which enhanced the resolving power, the ratio of signal to noise and the quality of imaging, these methods could meet most of the requirements of exploration and the development. What is more, more and more nowadays prospects are composed by two or more 3D sub-prospect, the differences between frequencies, energy levels and the ratios of signal to noise are definitely obvious, we can not perform finely construct analysis and interpretation of reservoir without solving these problems in matching different raw data. As for the prospect that composed by both seashore and marine ones, through the analysis on the characteristics on frequency, amplitude, polarity and multiples of land prospect and marine prospect, the methods on how to eliminate those differences mentioned above were researched, and this paper gives a series of methods includes the computing of matching factor, recognizing of time difference, recognizing of phase difference, matching frequency, collapsing of abnormal energy, frequency compensating and so on, to fulfill the attenuations of energy difference, frequency difference, time difference and phase difference, and what is more, improve the innovative methods: includes the quantities method to synthetically and automatically recognize time difference and phase difference on the basis of signal match technology and according to statistic rule. And distinct the differences on phase and frequency characteristics of received raw data between velocity seismometer and piezoelectricity seismometer, and deduces that there are 90 degrees gap between data from these two seismometers, thirdly, synthetically apply zone abnormal frequency processing, surface consistent abnormal frequency compensate, residual abnormal frequency compensate, stack time equilibrium and optimize the processing seis-flow, deal with the would-be problems, such as low signal and noise rate, low resolution, poor imaging and poor state of consistent. Gain excellent effect in Da-gang oil field.