Crustacean zooplankton size structure in aquaculture lakes: is larger size structure always associated with higher grazing pressure?

Crustacean zooplankton size structure in 27 aquaculture lakes was studied to test the hypothesis that larger size structure is associated with higher grazing pressure. Mean body length of crustaceans was positively correlated with increasing Chl a (r(2) = 0.40, P = 0.000) and TP (r(2) = 0.38, P = 0.000), contrary to the empirical studies. However, the ratio of zooplankton to phytoplankton biomass decreased significantly with increasing TP (r(2) = 0.27, P = 0.005) and mean body length (r(2) = 0.46, P = 0.000). Meanwhile, size structure showed no significant effect in explaining residual variations of phosphorus-chlorophyll relationship (P = 0.231). These results indicate that larger size structure was not always associated with higher zooplankton grazing pressure. It is likely that in aquaculture lakes crustacean zooplankton size structure was of minor importance in control of phytoplankton biomass, and it was mainly regulated by fish predation. The results showed in our study and the empirical studies might be a reflection of two different stages of lake eutrophication and fish predation intensity.

HYDROGRAPHIC VARIATIONS IN SIZE STRUCTURE OF PLANKTON BIOMASS IN A CHANGJIANG FLOODPLAIN LAKE

The size structure of the planktonic community in a Changjiang floodplain lake (Lake Chenhu, Hubei, P. R. China) was described for the inundation period of May through September 1983. The modality of the Sheldon-type size distributions changed hydrographically with the spectral profiles being bimodal during low, rising, mid-high and falling water phases, and trimodal soon after filling and shortly before falling. The modal peaks corresponded respectively to the dominant organisms of chlorophytes and nauplii, while the troughs centered on the bacteria and macrocrustacean size classes in the lake. The slope of the normalized biomass spectrum (an index of plankton size distribution) was less than -1.0 for the filling and falling phases or close to -1.0 for the high water period, indicating that the planktonic biomass tended to decrease or evenly distributes across logarithmically ordered size classes, respectively. This observed variation in the size distribution of the plankton community mainly resulted from changes in water levels and contents of particulate inorganic matter (PIM) in the lake.

Phytoplankton biomass size structure and its regulation in the Southern Yellow Sea (China): Seasonal variability

Phytoplankton size structure plays a significant role in controlling the carbon flux of marine pelagic ecosystems. The mesoscale distribution and seasonal variation of total and size-fractionated phytoplankton biomass in surface waters. as measured by chlorophyll a (Chl a), was studied in the Southern Yellow Sea using data from four cruises during 2006-2007. The distribution of Chl a showed a high degree of spatial and temporal variation in the study area. Chl a concentrations were relatively high in the summer and autumn, with a mean of 142 and 1.27 mg m(-3), respectively. Conversely, in the winter and spring. the average Chl a levels were only 098 and 0.99 mg m(-3) Total Chl a showed a clear decreasing gradient from coastal areas to the open sea in the summer, autumn and winter cruises. Patches of high Chl a were observed in the central part of the Southern Yellow Sea in the spring due to the onset of the phytoplankton bloom. The eutrophic coastal waters contributed at least 68% of the total phytoplankton biomass in the surface layer. Picophytoplankton showed a consistent and absolute dominance in the central region of the Southern Yellow Sea (>40%) in all of the cruises, while the proportion of microphytoplankton was the highest in coastal waters The relative proportions of pico- and nanophytoplankton decreased with total biomass, whereas the proportion of the micro-fraction increased with total biomass. Relationships between phytoplankton biomass and environmental factors were also analysed. The results showed that the onset of the spring bloom was highly dependent on water column stability. Phytoplankton growth was limited by nutrient availability in the summer due to the strong thermocline. The combined effects of P-limitation and vertical mixing in the autumn restrained the further increase of phytoplankton biomass in the Surface layer. The low phytoplankton biomass in winter was caused by vertical dispersion due to intense mixing. Compared with the availability of nutrients. temperature did not seem to cause direct effects on phytoplankton biomass and its size structure. Although interactions of many different environmental factors affected phytoplankton distributions. hydrodynamic conditions seemed to be the dominant factor. Phytoplankton size structure was determined mainly by the size-differential capacity in acquiring resource. Short time scale events, such as the spring bloom and the extension of Yangtze River plume, can have substantial influences, both on the total Chl a concentration and on the size structure of the phytoplankton. (C) 2009 Elsevier Ltd. All rights reserved.

Size dependence of biomass spectra and abundance spectra: the optimal distributions

Based on the hypothesis of self-optimization, we derive four models of biomass spectra and abundance spectra in communities with size-dependent metabolic rates. In Models 1 and 2, the maximum diversity of population abundance in different size classes subject to the constraints of constant mean body mass and constant mean respiration rate is assumed to be the strategy for ecosystems to organize their size structure. In Models 3 and 4, the organizing strategy is defined as the maximum diversity of biomass in different size classes without constraints on mean body mass and subject to the constant mean specific respiration rate of all individuals, i.e. the average specific respiration rate over all individuals of a community or group, which characterizes the mean rate of energy consumption in a community. Models 1 and 2 generate peaked distributions of biomass spectral density whereas Model 3 generates a fiat distribution. In Model 4, the distributions of biomass spectral density and of abundance spectral density depend on the Lagrangian multipler (lambda (2)). When lambda (2) tends to zero or equals zero, the distributions of biomass spectral density and of abundance spectral density correspond to those from Model 3. When lambda (2) has a large negative value, the biomass spectrum is similar to the empirical fiat biomass spectrum organized in logarithmic size intervals. When lambda (2) > 0, the biomass spectral density increases with body mass and the distribution of abundance spectral density is an unimodal curve. (C) 2001 Elsevier Science B.V. All rights reserved.

Temperature-Dependent Growth and Life Cycle of Nemoura sichuanensis (Plecoptera: Nemouridae) in a Chinese Mountain Stream

Plecoptera constitute a numerically and ecologically significant component in mountain streams all over the world, but little is known of their life cycles in Asia. The life cycle of Nemoura sichuanensis and its relationship to water temperature was investigated during a 4-year study in a headwater stream (known as the Jiuchong torrent) of the Xiangxi River in Central China. Size structure histograms suggest that the life cycle was univoltine, and the relationships between the growth of Nemoura sichuanensis, physiological time, and effective accumulated water temperature were described using logistic regressions. The growth pattern was generally similar within year classes but growth rates did vary between year-classes. Our field data suggest a critical thermal threshold for emergence in Nemoura sichuanensis, that was close to 9 degrees C. The total number of physiological days required for completing larval development was 250 days. The effective accumulated water temperature was 2500 degree-days in the field. Development during the life cycle increased somewhat linearly with the physiological time and the effective accumulated water temperature, but some non-linear relationships were best developed by logistic equations.

黄土丘陵区油松天然次生林林窗特征与更新动态

研究了黄土丘陵区油松天然次生林林窗的形状、大小结构、分布、形成木特征及其更新状况.结果表明:在油松天然次生林中,林冠林窗(CG)和扩展林窗(EG)面积均呈以小林窗为主的偏态分布.CG平均面积为31.15 m2,以20~40 m2林窗的数量比和面积比最大,分别为38.24%和30.50%;EG平均面积为58.04 m2,以30~60 m2的数量比和面积比最大,分别为36.77%和27.79%,且CG的平均面积占EG平均面积的53.67%;林窗形状多呈椭圆形,高度多在14~16 m;林窗形成年龄以10~20年为主,占33.82%.林窗中基折和枯立木分别占形成木总数的47.66%和23.44%.林窗形成的主要因素是人为间伐或盗伐,树木衰老等引起的抗性下降、干旱、病虫害等也是导致树木死亡的原因之一;每个林窗中平均有1.89个形成木,其中以2株形成木的林窗最多.林窗形成木主要是油松,其次为山杨、白桦和辽东栎等.形成木的径级呈明显的偏态分布,以10~20 cm和21~30 cm径级最为普遍,分别占总数的25.0%和45.31%,与林窗面积偏态分布吻合;林窗内林木的更新状况好于林下,且油松幼苗不存在断层,而油松林下幼苗在年...

Synthesis of Pt/Ag bimetallic nanorattle with Au core

A straightforward combination of the seeding growth method and replacement reaction allowed for the formation of a nanorattle composed of a gold core and Pt/Ag shell. The size, structure, and composition of the Pt/Ag rattle-type nanostructure were confirmed by scanning electron microscopy, transmission electron microscopy and X-ray photoelectron spectrometry.

Restructuring of a zooplankton community by perturbation from a wind-forced coastal jet

The impact of transient wind events on an established zooplankton community was observed during a, field survey in a, coastal region off northern Norway in May 2002. A transient wind event induced a coastal jet/filament intrusion of warm, saline water into our survey area where a semi-permanent eddy was present. There was an abrupt change in zooplankton community structure within 4-7 days of the wind event, with a change in the size structure, an increase in lower size classes less than 1 mm in equivalent spherical diameter (ESD) and a decrease in larger size classes greater than 1.5 mm in ESD. The slope of zooplankton biovolume spectra changed from -0.6 to -0.8, consistent with the size shifting towards smaller size classes. This study shows that even well established zooplankton communities are susceptible to restructuring during transient wind events, and in particular when wind forcing induces horizontal currents or filaments.

Effect of Rock Mass Structure and Block Size on the Slope Stability-Physical Modeling and Discrete Element Simulation

This paper studies the stability of jointed rock slopes by using our improved three-dimensional discrete element methods (DEM) and physical modeling. Results show that the DEM can simulate all failure modes of rock slopes with different joint configurations. The stress in each rock block is not homogeneous and blocks rotate in failure development. Failure modes depend on the configuration of joints. Toppling failure is observed for the slope with straight joints and sliding failure is observed for the slope with staged joints. The DEM results are also compared with those of limit equilibrium method (LEM). Without considering the joints in rock masses, the LEM predicts much higher factor of safety than physical modeling and DEM. The failure mode and factor of safety predicted by the DEM are in good agreement with laboratory tests for any jointed rock slope.

Edge and Size Effects in Micro Composite Structure

Because of the load transfer effect of interface layer, the stress distribution inside the composite structure of film/substrate can be very different from the Timoshenko's model. In this paper, we give the derivation and analysis of such load transfer effect of shear-lag (S-L) model. The micro-structure size (boundary conditions) effect together with interface load transfer effect becomes more and more important as the microstructure size including the three dimensions of thickness, width and length shrinks. The microstructure size is also responsible for the so-called edge-induced stress. The edge effect and difference of S-L model and Timoshenko model are also demonstrated.

The Effects of Grain Size Distribution and Structure on Mechanical Behavior of Silt

Abstract: In order to investigate the effects of the grain size distribution and the micro-structure of soils on the mechani- cal characteristics, some static triaxial compression tests were carried out, and then the relationship of stress-strain and the strength behavior of silty sand were compared among undisturbed samples with different grain size distribution, undis- turbed and remolded samples with the same grain size distribution, and reconstituted samples (or called mixed samples) with different grain size distribution. The effects of grain size distribution and structure on the mechanic behavior of silty sands were mainly analyzed. It is shown that the obvious differences of the mechanical characteristics between undis- turbed soils and remolded soils are caused by the differences of soil structures. Although the grain size distribution are different between two soil samples, their mechanical characteristics may be close to each other, or may have obvious differences because of the effects of micro-structure.

Size tolerance analysis of a 4X4 tapered multimode interference coupler in a silicon-on-insulator structure

Size tolerance of a 4X4 general interference tapered multimode interference (MMI) coupler in a silicon-on-insulator (SOI) structure is investigated by means of a 2-D finite difference beam propagation method (2D-FDBPM), together with an effective refractive index method (EIM). The results show that the tapered multimode interference coupler exhibits relatively larger size tolerance when light is launched from the edgeport than from midport, though it has much better output power uniformity when light is launched from midport. Besides that, it can reduce the device length greatly. The 4X4 general interference tapered MMI coupler has a slightly larger size tolerance compared with a conventional straight multimode interference coupler. (C) 2003 Society of Photo-Optical Instrumentation Engineers.

Band crossing in isovalent semiconductor alloys with large size mismatch: First-principles calculations of the electronic structure of Bi and N incorporated GaAs

For large size- and chemical-mismatched isovalent semiconductor alloys, such as N and Bi substitution on As sites in GaAs, isovalent defect levels or defect bands are introduced. The evolution of the defect states as a function of the alloy concentration is usually described by the popular phenomenological band anticrossing (BAC) model. Using first-principles band-structure calculations we show that at the impurity limit the N-(Bi)-induced impurity level is above (below) the conduction- (valence-) band edge of GaAs. These trends reverse at high concentration, i.e., the conduction-band edge of GaAs1-xNx becomes an N-derived state and the valence-band edge of GaAs1-xBix becomes a Bi-derived state, as expected from their band characters. We show that this band crossing phenomenon cannot be described by the popular BAC model but can be naturally explained by a simple band broadening picture.

Design of Tapered Rib Spot-Size Converter with Double-Cladding Structure

A novel structure of spot-size converter is designed to allow low loss and large alignment tolerance between single-mode rib waveguide devices and fiber arrays theoretically. The spot-size converter consists of a tapered rib core region and a double-cladding region. Through optimizing parameters,an expanded mode field can be tightly confined in the inner cladding and thus radiation loss be reduced largely at the tapered region. The influence of refractive index and thickness of the inner cladding on coupling loss is analyzed in particular. A novel,easy method of fabricating tapered rib spot-size converter based on silicon-on-insulator material is proposed.