Structure tuning of line-defect waveguides based on silicon-on-insulator photonic crystal slabs

We present fabrication and experimental measurement of a series of photonic crystal waveguides. The complete devices consist of an injector taper down from 3 mu m into a triangular-lattice air-hole single-line-defect waveguide with lattice constant from 410nm to 470nm and normalized radius 0.31. We fabricate these devices on a siliconon-insulator substrate and characterize them using a tunable laser source over a wavelength range from 1510nm to 1640nm. A sharp attenuation at photonic crystal waveguide mode edge is observed for most structures. The edge of guided band is shifted about 30nm with the 10nm increase of the lattice constant. We obtain high-efficiency light propagation and broad flat spectrum response of the photonic crystal waveguides.

Tunable Fano resonance in photonic crystal slabs

A three dimensional analysis of a special class of anisotropic materials is presented. We introduce an extension of the Scattering Matrix Method (SMM) to investigate the behavior of anisotropic Photonic Crystal Slabs (PhCS) subject to external radiation. We show how the Fano effect can play a fundamental role in the realization of tunable optical devices. Moreover, we show how to utilize electron injection, electric field and temperature as parameters to control the Fano resonance shift in both isotropic and anisotropic materials as Si and Potassium Titanium Oxide Phosphate (KTP). We will see that because Fano modes are sensitive and controllable, a broad range of applications can be considered. (c) 2006 Optical Society of America

Experimental observation of negative lateral displacements of microwave beams transmitting through dielectric slabs

It was theoretically predicted that when a beam of light travels through a thin slab of optically denser medium in the air, the emerging beam from the slab will suffer a lateral displacement that is different from the prediction of geometrical optics, that is, the Snell's law of refraction and can be zero and negative as well as positive. These phenomena have been directly observed in microwave experiments in which large angles of incidence are chosen for the purpose of obtaining negative lateral displacements. (C) 2005 Elsevier B.V. All rights reserved.

Nd：GGG激光晶体热容工作下的热致效应与冷却特性数值模拟

基于对称双侧激光二极管（LD）抽运Nd：GGG（掺钕钆镓石榴石）激光晶体板条，从热传导基本方程出发，以废热等效于内热源模型为前提，利用有限元分析软件ANSYS对Nd：GGG板条在热容工作下的瞬态温度场及应力场进行了数值模拟，分析了在不同边界条件下温度和应力随时间和空间的变化特性及其热致变形。计算结果表明：在激光发射阶段，边界非绝热使得板条在垂直光轴方向产生温度梯度，由此产生的折射率梯度和应力梯度导致距离光轴最远的板条边缘和光轴处产生约0．2μm的变形量。同时模拟了冷却阶段空气对流冷却、水循环冷却及喷雾冷却

千瓦级半导体抽运的固体热容板条激光器

报道了千瓦级激光二极管面阵抽运固体热容激光器的理论与实验研究, 分别采用Nd:YAG单板条和双板条串接的热容激光器, 利用热容激光器的理论计算模型计算了在一定的工作时间内激光输出特性, 并进行了实验验证。实验中采用的晶体尺寸均为59 mm×40 mm×4.5 mm, 对单板条进行抽运时平均功率大约为5.6 kW, 双板条串接时为11.2 kW, 重复频率为1 kHz, 占空比为20％。实验中观察了1 s的工作时间内脉冲能量输出的波动情况, 单板条时单脉冲能量输出最大为1.3 J, 在1 s后单脉冲能量输出

The impact of imperfect symmetry on band edge modes of a two-dimensional photonic crystal with square lattice

A theoretical analysis has been performed by means of the plane-wave expansion method to examine the dispersion properties of photons at high symmetry points of an InP based two-dimensional photonic crystal with square lattice. The Q factors are compared qualitatively. The mechanism of surface-emitting is due to the photon manipulation by periodic dielectric materials in terms of Bragg diffraction. A surface-emitting photonic crystal resonator is designed based on the phenomenon of slow light. Photonic crystal slabs with different unit cells are utilized in the simulation. The results indicate that the change of the air holes can affect the polarization property of the modes. So we can find a way to improve the polarization by reducing the symmetry of the structure.

High efficiency operation of butt joint line-defect-waveguide microlaser in two-dimensional photonic crystal slab

Butt joint line-defect-waveguide microlasers are demonstrated on photonic crystal slabs with airholes in a triangular lattice. Such microlaser is designed to increase the output power from the waveguide edge directly. The output power is remarkably enhanced to 214 times higher by introducing chirped structure in the output waveguide. The lasing mode operates in the linear dispersion region of the output waveguide so that the absorption loss due to the band-edge effect is reduced. The laser resonance is illustrated theoretically using the finite difference time domain method. A practical high power efficiency of 20% is obtained in this microlaser. (C) 2008 American Institute of Physics.

Surface recombination in GaAs thin films with two-dimensional photonic crystals

The dynamics of spontaneous emission from GaAs slabs with photonic crystals etched into them are investigated both theoretically and experimentally. It is found that the intensity of spontaneous emission decreases significantly and that photonic crystals significantly shorten the lifetime of emission. The mechanics of enhancement and the reduction of emission from photonic crystals are analyzed by considering the surface recombination of GaAs. The measured and calculated lifetimes agree at a surface recombination velocity of 1.88x10(5) cm/s.

Optical response of high-order band gap photonic crystal applying in-plane in one-dimensional integration

A new broadband filter, based on the high-order band gap in one-dimensional photonic crystal (PCs) of the form Si vertical bar air vertical bar Si vertical bar air vertical bar Si vertical bar air vertical bar Si vertical bar air vertical bar Si vertical bar air vertical bar Si, has been designed by the plane wave expansion method (PWEM) and transfer matrix method (TMM) and fabricated by lithography. The optical response of this filter to normal-incident and oblique-incident light proves that utilizing the high-order band gaps of PCs is an efficient method to lower the difficulties of fabricating PCs, increase the etching depth of semiconductor materials, and reduce the coupling loss at the interface between optical fibers and PC device. (c) 2007 Elsevier B.V. All rights reserved.

Design of two-dimensional photonic crystal edge emitting laser for photonic integrated circuits

An edge emitting laser based on two-dimensional photonic crystal slabs is proposed. The device consists of a square lattice microcavity, which is composed of two structures with the same period but different radius of air-holes, and a waveguide. In the cavity, laser resonance in the inner structure benelits from not only the anomalous dispersion characteristic of the first band-edge at the M point in the first Brillouin-zone but also zero photon states in the outer structure. A line defect waveguide is introduced in the outer structure for extracting photons from the inner cavity. Three-dimensional finite-difference time-domain simulations apparently show the in-plane laser output from the waveguide. The microcavity has an effective mode volume of about 3.2(lambda/eta(slab))(3) for oscillation -mode and the quality factor of the device including line defect waveguide is estimated to be as high as 1300.

Light-propagation characteristics of photonic crystal waveguide based on SOI materials at different polarized states

Straight single-line defect optical waveguides in photonic crystal slabs are designed by the plane wave expansion method and fabricated into silicon-on-insulator (SOI) wafer by 248-nm deep UV lithography. We present an efficient way to measure the light transmission spectrum of the photonic crystal waveguide (PhC WG) at given polarization states. By employing the Mueller/Stokes method, we measure and analyse the light propagation properties of the PhC WG at different polarized states. It is shown that experimental results are in agreement with the simulation results of the three-dimensional finite-difference-time-domain method.

Interfaces in heterostructures of AlInGaN/GaN/Al2O3

Rutherford backscattering/channeling (RBS/C) and X-ray diffraction (XRD) are used to comprehensively characterize a heterostructure of AlInGaN/GaN/Al2O3(0001). The AlInGaN quaternary layer was revealed to process a high crystalline quality with a minimum yield of 1.4% from RBS/C measurements. The channeling spectrum of (1 (2) under bar 13) exhibits higher dechanneling than that of (0001) at the interface of AlInGaN/GaN. XRD measurements prove a coherent growth of AlInGaN on the GaN template layer. Combining RBS/C and XRD measurements, we found that the interface of GaN/Al2O3 is a nucleation layer, composed of a large amount of disorders and cubic GaN slabs, while the interface of AlInGaN/GaN is free of extra disordering (i.e. compare with the GaN layer). The conclusion is further evidenced by transmission electron microscopy (TEM). (c) 2005 Elsevier Ltd. All rights reserved.

Crack Patterns in Ceramic Plates after Quenching

The crack patterns generated in a real ceramic plate and in a plate stacked by ceramic slabs under quenching are experimentally studied. The results here reveal that there are some distinct differences between the two crack patterns. The reasons that caused the differences are the size and boundary effects of the slabs. These crack patterns are very useful to understand the failure mechanisms of ceramic materials in thermal shock.

长白山火山成因—物理机制和化学演化

This thesis is one of the contributions to NSFC project, “The Changbaishan Volcanism and its Links to the Northeast Asia Tectonic System”. The thesis presents our most recent works on Changbaishan Volcanism, on two aspects as (1) the chemical evolution of the Cenozoic volcanism and the physical links of magma genesis, (2) the Holocene activity of the Tianchi Volcano and risks of potential eruption. 1. Chemical evolution and physical links to the Changbaishan Volcanism Physical links to the Chanbaishan Volcanism, just like origins of most of the volcanisms in eastern China, has long been an enigma. A large scale of volcanic activity has dominated many places of eastern China in Meso-Cenozoic. Activity of these volcanisms in eastern China covers several quite different blocks, covers variety of tectonics, and covers a period of time over 200 million years. Such a large-scale and long-lived volcanism in a continental area challenges our knowledge on dynamics of the Earth’s interior. Some works on “Diwa” hypothesis and “lithospheric thinning” hypothesis present possible links between volcanisms and dynamic evolutions of the earth’s interior, but still cannot interpret where are the sources of the heat and fluid, which are essential to the volcanisms. Based on the study of this thesis, we suggest that dynamics of the deep subduction of western Pacific Plate is the critical factor to the Changbaishan Volcanism and volcanisms in NE China, and maybe even essential to most of the Meso-Cenozoic volcanisms in eastern China. In NE China, stagnant slabs flatted in the mantle transition zone (MTZ, ca. 660 km deep) transport and release significant hydrous fluid to the upper mantle. Metamorphism of the deep-subducted slabs and hence a series of mineral phases play an important role in the water transport, exchange, restore, and release. Dehydrated fluid of the wet slab ascending from the MTZ fertile the upper mantle, and also provide upward heat flow which is essential to the magma genesis. Then magma and volcanism occur with the deep subduction from Mesozoic to mordern time in eastern China. To discribe the exact chemical characteristics of the deep subduction releated volcanics is very difficult, because few researches has contributed to the chemical behaviors of fluid and trace elments in the very deep interior of the Earth, such 660 km deep, 410km or 350km where the fluid may ascend and react. However we can still find some chemical characteristics of oceanic subduction. Basalts of the Changbaishan Volcanism have siginficant characteristics of potassium rich, and even can be called a potassic igneous province. If there are only two possible ways, recycled continentical crust or oceanic crust, to fertile the mantle potossium element as we know now, it’s easy to attribute this to the deep-subducted of the west Pacific Plate. To the eastern China, fluid inclusions in mantle xenoliths from the Cenozic basalts also reveal potassium-rich characteristics. This reveals that the same potassium feritle agents may occur in the mantle sources of eastern China. 2. Holocene activiy of the Tianchi Volcano As one of the large volcanic center and complex volcanic cone, the Tianchi Volcano is a dangerous active volcano, with several Holocene eruptions. Among these eruptions, the Millennium Eruption is regardede as one of the biggist eruptions in the world in the last 2000 years. To estimate the potential danger of volcanic eruption, we discuss two essential factors, as (i) volcanic history of Holocene eruptions, including volcanic geolgy, chronnology and chemistry, (ii) state, evolution and relationship of the magma chambers in mantle and crust beneath the Tianchi Volcano.