Phase-step calibration technique based on a two-run-times-two-frame phase-shift method

A novel phase-step calibration technique is presented on the basis of a two-run-times-two-frame phase-shift method. First the symmetry factor M is defined to describe the distribution property of the distorted phase due to phase-shifter miscalibration; then the phase-step calibration technique, in which two sets of two interferograms with a straight fringe pattern are recorded and the phase step is obtained by calculating M of the wrapped phase map, is developed. With this technique, a good mirror is required, but no uniform illumination is needed and no complex mathematical operation is involved. This technique can be carried out in situ and is applicable to any phase shifter, whether linear or nonlinear. (c) 2006 Optical Society of America.

Time response of optical switching properties of Sb thin films under focused laser pulses

The time response of optical switching properties of Sb thin films under focused laser pulses is investigated. The results show that the response course can be divided into onset, opening, and closing stages. Formulas for their lengths are given. The onset and opening times decrease with increasing pumping light power density. The closing time is about 150 ns. For optical memory, if the power density of the readout and recording lasers changes from 5 x 10(9) to 15 x 10(9) W/m(2), the onset time changes from 2.5 to 0.30 mus, and the opening time is on the nanosecond scale. (C) 2003 Society of Photo-Optical Instrumentation Engineers.

Coupling between elytra of some beetles: Mechanism, forces and effect of surface texture

Lightweight materials, structures and coupling mechanisms are very important for realizing advanced flight vehicles. Here, we obtained the geometric structures and morphologies of the elytra of beetles and ascertained its coupling zone by using the histological section technique and SEM. We set up a three-dimensional motion observing system to monitor the opening and closing behaviour of elytra in beetles and to determine the motion mechanism. We constructed a force measuring system to measure the coupling forces between elytra. The results show that elytra open and close by rotating about a single axle, where the coupling forces may be as high as 160 times its own bodyweight, the elytra coupling with the tenon and mortise mechanism, surface texture and opening angle between elytra heavily influence the coupling forces. These results may provide insights into the design mechanism and structure for future vehicles of flight.

Resonance-enhanced group delay times in an asymmetric single quantum barrier

It is shown that transmission and reflection group delay times in an asymmetric single quantum barrier are greatly enhanced by the transmission resonance when the energy of incident particles is larger than the height of the barrier. The resonant transmission group delay is of the order of the quasibound state lifetime in the barrier region. The reflection group delay can be either positive or negative, depending on the relative height of the potential energies on the two sides of the barrier. Its magnitude is much larger than the quasibound state lifetime. These predictions have been observed in microwave experiments. (c) 2005 Elsevier B.V. All rights reserved.

MODELING OF ELECTRON-TUNNELING TIMES IN ASYMMETRIC DOUBLE QUANTUM-WELLS

A scattering process modeled by an imaginary potential V(I) in the wide well of an asymmetric double quantum well structure (DQWS) is used to model the electron tunneling from the narrow well. Taking V(I) approximately -5 meV, the ground resonant level lifetimes of the narrow well in the DQWS are in quantitative agreement with the experimental resonance and non-resonance tunneling times. The corresponding scattering time 66 fs is much faster than the intersubband scattering time of LO-photon emission.

COMPARISONS OF PHASE TIMES WITH TUNNELING TIMES BASED ON ABSORPTION PROBABILITIES

The times spent by an electron in a scattering event or tunnelling through a potential barrier are investigated using a method based on the absorption probabilities. The reflection and transmission times derived from this method are equal to the local Larmor times if the transmission and reflection probability amplitudes are complex analytic functions of the complex potential. The numerical results show that they coincide with the phase times except as the incident electron energy approaches zero or when the transmission probability is too small. If the imaginary potential covers the whole space the tunnelling times are again equal to the phase times. The results show that the tunnelling times based on absorption probabilities are the best of the various candidates.

Pub/Sub系统中分布式复合事件检测技术研究

随着信息技术的发展，Pub/Sub系统由于具有异步和松耦合的特点，被越来越广泛的应用到金融、供应链管理、物流等领域。在这些应用中，用户对具有各种特定逻辑或时序关系的复合事件的订阅需求越来越迫切，这使得Pub/Sub系统中的分布式复合事件检测技术成为研究的热点，分布式复合事件检测技术包括复合订阅语言、复合匹配算法、以及订阅和事件的路由算法。 目前已有的Pub/Sub系统提供的复合订阅语言比较简单，对时序支持较弱，不能满足实际应用的需要，已有的复合匹配算法也不能有效的支持具有丰富时序关系的复合事件的检测。在路由方面，基于内容的Pub/Sub系统大都是在树结构或者无环图结构的覆盖网络上，采用基于过滤的原子路由方法，该路由方法需要将原子订阅传遍几乎整个网络，以减少订阅匹配的延迟，但这种路由方法很难适应网络的拓扑变化。而目前基于事件空间划分的路由方法不支持事件空间的动态划分和事件空间在不同服务器之间的移动，并且没有提供专门针对事件空间划分的复合事件检测方法。 本文在调研了各种应用需求的基础上，提出了能够表达事件丰富的时序关系、逻辑关系和事件实例关系的复合订阅语言，并且定义了两种事件排序方式。在消费语义采用配对模式的情况下，给出了该语言在两种事件排序方式下的检测结果集的定义。针对该复合订阅语言提出并实现了图结构和时间事件发生器相结合的复合匹配算法，该匹配算法使图结构可以有效的支持时序关系和非触发式事件的检测。在路由方面，首先实现了基于过滤的逆向路径转发的原子路由方法，并在此基础上，实现了就近检测协议，该协议优化了复合订阅匹配结构在网络中的部署。最后，设计和实现了基于事件空间划分的原子路由方法，该路由方法实现了事件空间的动态划分，并可以根据系统中服务器的负载情况实现事件空间的移动，从而有效的平衡服务器的负载。在此基础上，通过对复合订阅的拆分，并利用可移动的复合事件检测器实现了复合订阅的分布式部署和复合事件的分布式检测，同时通过对复合事件检测器的复用，进一步减少了网络负载和服务器的匹配负载。本文还通过实验验证了匹配算法和两种路由方法的性能和开销。