Essential and Non-Essential Work of Fracture of PI/SiO2 Hybrid Thin Films

Essential work of fracture (EWF) analysis is used to study the effect of the silica doping level on fracture toughness of polyimide/silica (PI/SiO2) hybrid films. By using double-edge-notched-tension (DENT) specimens with different ligament lengths, it seems that the introduction of silica additive can improve the specific essential work of fracture (w (e) ) of PI thin films, but the specific non-essential work of fracture (beta w (p) ) will decease significantly as the silica doping level increasing from 1 to 5 wt.%, and even lower than that of neat PI. The failure process of the fracture is investigated with online scanning electron microscope (SEM) observation and the parameters of non-essential work of fracture, beta and w (p) , are calculated based on finite element (FE) method.

Low Temperature Properties of PI/SiO_2 Nanocomposite Films

In this paper, the mechanical properties of PI/Si_O, nanocomposite hybrid films with different silica doping levels are experimentally studied at low temperature. Experimental results show that the coefficient of thermal expansion (CTE) of the PI/Si_O, nanocomposite hybrid films gradually reduces when the ambiance temperature is decreased. At the liquid nitrogen temperature (77 K), the CTE value is about five times less than that at room temperature (287 K). The measured CTEs of hybrid films greatly decrease when doped with inorganic silica, especially when the silica doping level is more than 1 wt.%. However, too high silica contents (more than 10 wt.%) can cause problem to disperse effectively and the specimens become quite opaque. Experimental results also show that the effects of the pre-applied stress levels can be neglected on the CTE testing. When the ambient temperature changes from 287 to 77 K, the measured average values of the films' ultimate tensile strength (UTS) and Young's modulus increase about 60 and 90%, respectively, while the breaking elongation decreases about 42%.

Single mode Er-doped pi-phase-shifted distributed feedback fibre grating laser

A novel method incorporating the shielded method and the post-processing method has been proposed to fabricate the pi-phase-shilted fibre grating. Then an Er-doped pi-phase-shifted distributed feedback fibre grating laser has been fabricated using the grating. The laser threshold is 20 mW. When pumped with 90 mW light at 980 nm, the laser gives an output of 1.1 mW. Its signal-to-noise ratio is better than 60 dB. It is demonstrated that the laser is single mode operation by means of a Fabry-Perot scanning interferometer.

Superresolution by three-zone pure phase plate with 0, pi, 0 phase variation

Superresolution is very important in imaging and optical storage systems, and has attracted much attention. In this article, concentric three-zone phase plate with 0, pi, 0 phase variation has been investigated numerically to show that this kind of phase plate can be used to obtain three-dimensional superresolution. In addition, the number of intensity maximum, focal depth, focal shift, full-width half-maximum, and relative intensity of side lobe are listed for different radii of the phase zones, which paves the way for design of the phase plate. Therefore, one can choose values of radii for desired intensity distribution in focal region, such as for the purpose of radial superresolution with high focal depth in optical storage. (c) 2006 Elsevier Ltd. All rights reserved.

Visible blind p(+)-pi-n(-)-n(+) ultraviolet photodetectors based on 4H-SiC homoepilayers

p(+)-pi-n(-)-n(+) ultraviolet photodetectors based on 4H-SiC homoepilayers have been presented. The growth of the 4H-SiC homoepilayers was carried out in a LPCVD system. The size of the active area of the photodetectors was 300 x 300 mu m(2). The dark and illuminated I-V characteristics had been measured at reverse biases form 0 to 20 V at room temperature, and the illuminated current was at least two orders of magnitude than that of dark current below 13 V bias. The peak value zones of the photoresponse were located at 280-310 nm at different reverse biases, and the peak value located at 300 nm was 100 times greater than the cut-off response value in 380 nm at a bias of 10V, which showed the device had good visible blind performance. A small red-shift about 5 nm on the peak responsivity occurred when reverse bias increased from 5 to 15 V. (c) 2006 Elsevier Ltd. All rights reserved.

A novel quantum directional coupler based on Pi-shaped coupled electron waveguides

We explore the possibility of a quantum directional coupler based on Pi-shaped coupled electron waveguides with smooth boundaries. By calculating the transmission spectra, we propose an optimized coupler structure with a high directivity and fine uniformity. The coupler specifications, directivity, uniformity, and coupling coefficient are evaluated.

Study on the forecast effects of PI method to the north and southwest China

In this paper, the codes of Pattern Informatics (PI) method put forward by Rundle et al. have been worked out according to their algorithm published, and the retrospective forecast of PI method to North China (28.0 degrees-42.0 degrees N, 108.0 degrees-125.0 degrees E) and to Southwest China (22.0 degrees-28.3 degrees N, 98.0 degrees-106.0 degrees E) has been tested. The results show that the hit rates in different regions show a great difference. In Southwest China, 32 earthquakes with M(L)5.0 or larger have occurred during the predicted time period 2000-2007, and 26 out of the 32 earthquakes occurred in or near the hot spots. In North China, the total number of M(L)5.0 or larger was 12 during the predicted time period 2000-2007, and only 3 out of the 12 earthquakes occurred in or near the hot spots. From our results, we hold that if the PI method could be applied to all kinds of regions, the parameters associated with time points and time windows should be chosen carefully to obtain the higher hit rate. We also found that the aftershocks in a strong earthquake sequence affect the PI results obviously. Copyright (c) 2009 John Wiley & Sons, Ltd.

Study on the forecast effects of PI method to the north and southwest China

In this paper, the codes of Pattern Informatics (PI) method put forward by Rundle et al. have been worked out according to their algorithm published, and the retrospective forecast of PI method to North China (28.0 degrees-42.0 degrees N, 108.0 degrees-125.0 degrees E) and to Southwest China (22.0 degrees-28.3 degrees N, 98.0 degrees-106.0 degrees E) has been tested. The results show that the hit rates in different regions show a great difference. In Southwest China, 32 earthquakes with M(L)5.0 or larger have occurred during the predicted time period 2000-2007, and 26 out of the 32 earthquakes occurred in or near the hot spots. In North China, the total number of M(L)5.0 or larger was 12 during the predicted time period 2000-2007, and only 3 out of the 12 earthquakes occurred in or near the hot spots. From our results, we hold that if the PI method could be applied to all kinds of regions, the parameters associated with time points and time windows should be chosen carefully to obtain the higher hit rate. We also found that the aftershocks in a strong earthquake sequence affect the PI results obviously. Copyright (c) 2009 John Wiley & Sons, Ltd.