Flood Routing Models in Confluent and Dividing Channels

By introducing a water depth connecting formula, the hydraulic equations in the dividing channel system were coupled and the relation of discharge distribution between the branches of the dividing channels can be yielded. In this manner, a numerical model for the confluent channels was established to study the variation of backwater effects with the parameters in the channel junction. The meeting of flood peaks in the mainstream and tributary can be analyzed with this model. The flood peak meeting is found to be a major factor for the extremely high water level in the mainstream during the 1998 Yangtze River flood. Subsequently the variations of discharge distribution and water level with channel parameters between each branch in this system were studied as well. As a result, flood evolution caused by Jingjiang River shortcut and sediment deposition in the entrance of dividing channels of the Yangtze River may be qualitatively elucidated. It is suggested to be an effective measure for flood mitigation to enhance regulation capability of reservoirs available upstream of the tributaries and harness branch entrance channels.

Information Preservation (IP) Method in Simulation

This paper reviews firstly methods for treating low speed rarefied gas flows: the linearised Boltzmann equation, the Lattice Boltzmann method (LBM), the Navier-Stokes equation plus slip boundary conditions and the DSMC method, and discusses the difficulties in simulating low speed transitional MEMS flows, especially the internal flows. In particular, the present version of the LBM is shown unfeasible for simulation of MEMS flow in transitional regime. The information preservation (IP) method overcomes the difficulty of the statistical simulation caused by the small information to noise ratio for low speed flows by preserving the average information of the enormous number of molecules a simulated molecule represents. A kind of validation of the method is given in this paper. The specificities of the internal flows in MEMS, i.e. the low speed and the large length to width ratio, result in the problem of elliptic nature of the necessity to regulate the inlet and outlet boundary conditions that influence each other. Through the example of the IP calculation of the microchannel (thousands long) flow it is shown that the adoption of the conservative scheme of the mass conservation equation and the super relaxation method resolves this problem successfully. With employment of the same measures the IP method solves the thin film air bearing problem in transitional regime for authentic hard disc write/read head length ( ) and provides pressure distribution in full agreement with the generalized Reynolds equation, while before this the DSMC check of the validity of the Reynolds equation was done only for short ( ) drive head. The author suggests degenerate the Reynolds equation to solve the microchannel flow problem in transitional regime, thus provides a means with merit of strict kinetic theory for testing various methods intending to treat the internal MEMS flows.

Information preservation (IP) method in simulation of internal rarefied gas flows in MEMS

This paper reviews firstly methods for treating low speed rarefied gas flows: the linearised Boltzmann equation, the Lattice Boltzmann method (LBM), the Navier-Stokes equation plus slip boundary conditions and the DSMC method, and discusses the difficulties in simulating low speed transitional MEMS flows, especially the internal flows. In particular, the present version of the LBM is shown unfeasible for simulation of MEMS flow in transitional regime. The information preservation (IP) method overcomes the difficulty of the statistical simulation caused by the small information to noise ratio for low speed flows by preserving the average information of the enormous number of molecules a simulated molecule represents. A kind of validation of the method is given in this paper. The specificities of the internal flows in MEMS, i.e. the low speed and the large length to width ratio, result in the problem of elliptic nature of the necessity to regulate the inlet and outlet boundary conditions that influence each other. Through the example of the IP calculation of the microchannel (thousands m ? long) flow it is shown that the adoption of the conservative scheme of the mass conservation equation and the super relaxation method resolves this problem successfully. With employment of the same measures the IP method solves the thin film air bearing problem in transitional regime for authentic hard disc write/read head length ( 1000 L m ? = ) and provides pressure distribution in full agreement with the generalized Reynolds equation, while before this the DSMC check of the validity of the Reynolds equation was done only for short ( 5 L m ? = ) drive head. The author suggests degenerate the Reynolds equation to solve the microchannel flow problem in transitional regime, thus provides a means with merit of strict kinetic theory for testing various methods intending to treat the internal MEMS flows.

IP Simulation of Micro Gas Flows under 3-D Head Sliders

Gas film lubrication of a three-dimensional flat read-write head slider is calculated using the information preservation (IP) method and the direct simulation Monte Carlo (DSMC) method, respectively. The pressure distributions on the head slider surface at different velocities and flying heights obtained by the two methods are in excellent agreement. IP method is also employed to deal with head slider with three-dimensional complex configuration. The pressure distribution on the head slider surface and the net lifting force obtained by the IP method also agree well with those of DSMC method. Much less (of the order about 10(2) less) computational time (the sum of the time used to reach a steady stage and the time used in sampling process) is needed by the IP method than the DSMC method and such an advantage is more remarkable as the gas velocity decreases.

IP方法模拟硬盘读写头气膜润滑问题

本论文中采用IP方法模拟硬盘读写头的气膜润滑问题，并选择耗时但精准的DSMC方法作为该问题中IP方法的检验标准，IP方法计算得到的读写头表面压力分布及读写头所受净升力为读写头的设计提供可靠的参考数据。 首先，将读写头复杂表面简化为平面并假定尺寸为微米（远小于真实的毫米），微米尺寸时可以得到DSMC的模拟结果用于比较。IP法对该问题的模拟结果与DSMC的模拟结果完全吻合。 其次，选定一个真实的读写头表面几何，但仍然假定尺寸为微米。IP法在该问题的应用过程中遇到四点困难，我们提出或采取了相应的解决办法。在复杂表面几何的读写头气膜润滑问题中，IP法的模拟结果与DSMC的模拟结果也相符一致。 最后完成真实几何、真实尺寸（毫米）的读写头气膜润滑问题的模拟，这也是本论文的最终研究目标。IP法模拟该问题时需要采用大网格，为此我们构造二维检验模型验证了大网格的合理性。 真实几何读写头气膜润滑问题的模拟结果表明，在流场的局部区域压力沿着高度方向变化显著，这意味着读写头问题的传统计算方法（即概括性雷诺方程）在该局部区域不成立，故用它计算得到的结果值得认真检验，但文献中尚未给出过这类检验。这正是该论文的研究背景和采用新方法（IP方法）的原因。 本论文研究的问题属于过渡领域、低速流动问题，故本论文还介绍了该领域另外一种粒子模拟方法（LVDSMC方法）以及我们对该方法提出的一些改进。 关键词：硬盘读写头，气膜润滑，概括性雷诺方程，IP方法，DSMC方法，过渡领域，LVDSMC方法

Optical two-dimensional SW-banyan network: Optical implementation, routing control, and determination of permissible permutations

A 2-D SW-banyan network is introduced by properly folding the 1-D SW-banyan network, and its corresponding optical setup is proposed by means of polarizing beamsplitters and 2-D phase spatial light modulators. Then, based on the characteristics and the proposed optical setup, the control for the routing path between any source-destination pair is given, and the method to determine whether a given permutation is permissible or not is discussed. Because the proposed optical setup consists of only optical polarization elements, it is compact in structure, its corresponding energy loss and crosstalk are low, and its corresponding available number of channels is high. (C) 1996 Society of Photo-Optical Instrumentation Engineers.

Routing scheme, permutation properties, and optical implementation of a four-shuffle-exchange-based Omega network

The routing scheme and some permutation properties of a four-shuffle-exchange-based Omega network are discussed. The corresponding optical setup, which is composed of 2-D phase spatial light modulators and calcite plates, is proposed and demonstrated through mapping the inputs to a 2-D array. Instead of one shuffle-exchange followed by one switching operation as in ordinary Omega networks, in our presented system, the shuffle interconnection embraced in the switches is accomplished simply by varying the switching structure of each stage. For the proposed polarization-optical modules, the system is compact in structure, efficient in performance, and insensitive to the environment. (C) 1997 Society of Photo-Optical Instrumentation Engineers.

IP协议栈的ASIC设计与实现

Submitted by zhangdi (zhangdi@red.semi.ac.cn) on 2009-04-13T11:45:31Z

用于IP追踪的包标记的注记

拒绝服务攻击是一类最难对付的网络安全问题.近来,人们提出了多种对策.其中由Savage等人提出的一类基于概率的包标记方案比较有研究价值.这里先对拒绝服务攻击的对策作一简述,然后分析了几种包标记方案,指出了它们的一些缺陷,并提出了一些改进措施.其中,对基本型概率包标记方案的一个修改使得计算量大大减少.

IP追踪中的自适应包标记

拒绝服务(DoS)攻击是目前最难处理的网络难题之一.最近,研究人员针对DoS攻击提出了多种方案,这些方案都各有优缺点.其中,由Savage等人提出的概率包标记方案受到了广泛的重视,也有不少的变种出现.在这一类的标记方案中,路由器以固定的概率选择是否标记一个数据包,这导致受害需要较多的数据包进行攻击路径的重构.本文提出一种自适应的标记策略,经实验验证受害者用较少的数据包即可重构攻击路径,这不仅为受害者及早地响应攻击争取了更多的时间,还限制了攻击者的伪造能力.