利用HS-SPME-GC技术分析环境水样中超痕量的六氯苯,DDT及其代谢产物

利用顶空固相微萃取(HSSPME)和气相色谱检测技术,通过对三种不同的SPME萃取头(PDMS,PMPVS,PA)实验条件的优化,并参照液液萃取的方法,对水相中六氯苯,DDT及其代谢产物的萃取效果进行了比较.结果表明,SPME方法比液液萃取方法在检测限和回收率上有很大的提高,其中PDMS对检测六氯苯,DDT及其代谢产物的效果较其它两种萃取头好.

新核素~(263)Hs,~(260)Bh及其α衰变链上核素的半衰期

运用推广的液滴模型(GLDM)并结合量子力学中的WKB方法计算了新核素~(263)Hs和~(260)Bh及其α衰变链上各核素的势垒贯穿概率,对该链上各原子核的α衰变半衰期进行了研究。计算结果表明:利用推广的液滴模型结合WKB方法计算出的α衰变半衰期可以很好地符合在超重核区的实验值,验证了推广的液滴模型在超重核区的适用性,能够很好地描述超重核的α衰变。同时,计算表明新核素~(260)Bh和~(263)Hs的合成及其半衰期的测量是可靠的。

Systematic study of properties of Hs nuclei

The ground-state properties of Hs nuclei are studied in the framework of the relativistic meanfield theory. We find that the more relatively stable isotopes are located on the proton abundant side of the isotopic chain. The last stable nucleus near the proton drip line is probably the (255)Hs nucleus. The alpha-decay half-lives of Hs nuclei are predicted, and together with the evaluation of the spontaneous-fission half-lives it is shown that the nuclei, which are possibly stable against spontaneous fission are (263-274)Hs. This is in coincidence with the larger binding energies per nucleon. If (271-274)Hs can be synthesized and identified, only those nuclei from the upper Z = 118 isotopic chain, which are lighter than the nucleus (294)118, and those nuclei in the corresponding alpha-decay chain lead to Hs nuclei. The most stable unknown Hs nucleus is (268)Hs. The density-dependent delta interaction pairing is used to improve the BCS pairing correction, which results in more reasonable single-particle energy level distributions and nucleon occupation probabilities. It is shown that the properties of nuclei in the superheavy region can be described with this interaction.

Experimental study of the U-238(S-36,3-5n)(269-271)Hs reaction leading to the observation of (270)Hs

The deformed doubly magic nucleus (270)Hs has so far only been observed as the four-neutron (4n) evaporation residue of the reaction Mg-26+Cm-248, where a maximum cross section of 3 pb was measured. Theoretical studies on the formation of (270)Hs in the 4n evaporation channel of fusion reactions with different entrance channel asymmetry in the framework of a two-parameter Smoluchowski equation predict that the reactions Ca-48+Ra-226 and S-36+U-238 result in higher cross sections due to lower reaction Q values, in contrast to simple arguments based on the reaction asymmetry, which predict opposite trends. Calculations using HIVAP predict cross sections for the reaction S-36+U-238 that are similar to those of the Mg-26+Cm-248 reaction. Here, we report on the first measurement of evaporation residues formed in the complete nuclear fusion reaction S-36+U-238 and the observation of (270)Hs, which is produced in the 4n evaporation channel, with a measured cross section of 0.8(-0.7)(+2.6) pb at 51-MeV excitation energy. The one-event cross-section limits (68% confidence level) for the 3n, 4n, and 5n evaporation channels at 39-MeV excitation energy are 2.9 pb, while the cross-section limits of the 3n and 5n channel at 51 MeV are 1.5 pb. This is significantly lower than the 5n cross section of the Mg-26+Cm-248 reaction at similar excitation energy.

Determination of surface pK(a) of HS(CH2)(10)COOH SAMs using an electrochemical titration method

The self-assembled monolayer(SAM) of 11-mercaptoundecanoic acid [HS(CH2)(10)COOH] was formed on a gold electrode and the effect of the charge of end group on the electrochemical response of Fe(CN)(6)(3-) at the SAM modified electrode was studied by cyclic voltammetry. At high pH, when the -COOH groups are dissociated, the current of Fe(CN)(6)(3-) is suppressed; as the solution pH is lowered, the current of Fe(CN)(6)(3-) increases. The electrochemical titration curve was obtained by correlating the currents of Fe(CN)(6)(3-) to the different pH values of electrolyte, from which the surface pK(a) was obtained to be 3. 0+/-0. 2. Furthermore, the reason of small pK(a) value was explained using SAMs of different surface coverage.

Superelastic And Spring Properties Of Si3N4 Microcoils

Silicon nitride with helical structure was prepared on a large scale by CVD. On the microscale, these coiled Si3N4 ceramics still possess superelasticity and can recover their original shapes after cyclic loadings without noticeable deformations. These results suggest helical microcoils could have potential in microdevices for MEMS, motors, electromagnets, generators, and related equipment.

Dynamic Fracture Instability Of Tough Bulk Metallic Glass

We report the observations of a clear fractographic evolution from vein pattern, dimple structure, and then to periodic corrugation structure, followed by microbranching pattern, along the crack propagation direction in the dynamic fracture of a tough Zr41.2Ti13.8Cu12.5Ni10Be22.5 (Vit.1) bulk metallic glass (BMGs) under high-velocity plate impact. A model based on fracture surface energy dissipation and void growth is proposed to characterize this fracture pattern transition. We find that once the dynamic crack propagation velocity reaches a critical fraction of Rayleigh wave speed, the crack instability occurs; hence, crack microbranching goes ahead. Furthermore, the correlation between the critical velocity of amorphous materials and their intrinsic strength such as Young's modulus is uncovered. The results may shed new insight into dynamic fracture instability for BMGs. (C) 2008 American Institute of Physics.

Theoretical analysis for mechanical erosion of carbon-base materials in ablation

This article derives and provides a theoretical analysis for the mechanical erosion of carbon-base materials in ablation. The theory of mechanical erosion based on a nondimensional critical roughness parameter is proposed, The important parameters in this analytical method are independent of the test, The analysis accounts for the heating, pressure, and shear forces acting on material particles exposed to the boundary-layer flow. For the validity of a theoretical analytical method a computational example is given. The theoretical results agree fairly with the experimental data.

An optimal theory for an expansion of flow quantities to capture the flow structures

An optimal theory on how database analysis to capture the flow structures has been developed in this paper, which include the POD method as its special case. By means of the remainder minimization method in the Sobolev space, for more general optimal conditions the new theory has the potential to overcome an inherent limitation of the POD method, i.e., it cannot be used to the situations in which the optimal condition is other than the inner product global one. As an example, using the new theory, the database of a two-dimensional flow over a backward-facing step is analyzed in detail, with velocity and vorticity bases.

A unified law of motion of lithospheric plates and the driving mechanism

From observed data on lithospheric plates, a unified empirical law for plate motion,valid for continental as well as oceanic plates, is obtained in the following form: The speedof plate motion U depends linearly on a geometric parameter T_d, ratio of the sum of effectiveridge length and trench arc length to the sum of area of continental part of plate and total areaof cold sinking slab. Based on this unified law, a simple mechanical analysis shows that, themain driving forces for lithospheric plates come from push along the mid-ocean ridge andpull by the cold sinking slab, while the main drag forces consist of the viscous traction beneaththe continental part of plate and over both faces of the sinking slab. Moreover, the specific-push along ridge and pull by slab are found to be of equal magnitude.

Number of phase levels of a Talbot array illuminator

The number of phase levels of a Talbot array illuminator is an important factor in the estimation of practical fabrication complexity and cost. We show that the number it) of phase levels of a Talbot array illuminator has a simple relationship to the prime number. When there is an alternative pi -phase modulation in the output array, the relations are similar. (C) 2001 Optical Society of America OCIS codes: 070.6760, 050.1950, 050.1980.

PIXE and ICP-AES analysis of early glass unearthed from Xinjiang (China)

Early glasses (about 1066 BC-220 AD) unearthed from Xinjiang of China were chemically characterized by using PIXE and ICP-AES. It was found that these glasses were basically attributed to PbO-BaO-SiO2 system, K2O-SiO2 system, Na2O-CaO-SiO2 system and Na2O-CaO-PbO-SiO2 system. The results from the cluster analysis showed that some glasses had basically similar recipe and technology. The PbO-BaO-SiO2 glass and the K2O-SiO2 glass were thought to come from the central area and the south of ancient China, respectively. The part of the Na2O-CaO-SiO2 glass (including the Na2O-CaO-PbO-SiO2 glass) might be imported from Mesopotamia, while the other part might be locally produced. (c) 2005 Elsevier B.V. All rights reserved.