A Research on New Method of Transportation Technics for Heavy Oil and Practice in Oil Field

介绍一种可应用于高粘度稠油管输的新工艺。即用自行研制的蒸汽引射器采用无界引射方式,将蒸汽直接注入到输油管道中,利用蒸汽释放的热量提高稠油温度降低粘度,从而达到降低稠油输送压降的目的,它比间接加热输送工艺所用的蒸汽量或耗煤量大大减少。方法在辽河油田输油管线上进行了工业现场试验,取得了很好的效果。

蒸汽引射稠油输送新技术

摘要：管线输送是稠油输运的一种主要手段。由于我国一些油田原油粘度高，常温下流动性差，管输需采用特殊工艺。根据粘度随温度沿指数下降的规律，与其它工艺比较，加热输送工艺有更大的潜力。该文提出了一种蒸汽引射直接加热稠油输送的新技术。为研究其有效性，进行了性能分析，并在辽河油田φ80mm，300m输油管线上进行了现场实验，测量了三种工况下该方法对稠油的温度、压降和含水串的影响。实验结果表明该文提出的方法是可行的。

用于稠油输送的新蒸汽引射器

介绍一种自行研制的蒸汽引射器，蒸汽以自由射流形式注入到输油管中，利用蒸汽释放的热量提高稠油温度以降低黏度，从而达到低输送压降的目的。该引器具有加热效率高，防止稠油堵塞管线等优点，引射器已在辽河油田输油管线上进行了现场实验，取得了很好的效果。

稠油输送新工艺方法探索及现场试验

本文介绍一种可应用于高粘度稠油管输的新工艺。即用自行研制的蒸汽引射器采用无界引射方式，将蒸汽直接注入到输油管道中，利用蒸汽释放的热量提高稠油温度降低粘度，从而达到降低稠油输送压降的目的，它比间接加热输送工艺所用的蒸汽量或耗煤量大大减少。本方法在辽河油田输油管线上进行了工业现场试验，取得了很好的效果。

Design of a Self-Adaptive Down-Hole Layered Steam Injector and Its Application

Layered steam injection, widely used in Liaohe Oilfield at Present, is an effective recovery technique to heavy oil reserves. Which makes the steam front-peak push forward uniformly, the amount of steam injection be assigned rationally, and the effect of injection steam be obtained as expected. To maintain a fixed ratio of layered steam injection and solve the problem of nonadjustable hole diameter with the change of layer pressure in the existing injectors, a new method is proposed in this paper to design layered steam injectors based on the dynamic balance theory. According to gas-liquid two-phase flow theory and beat transfer theory, the energy equation and the heat conduction equation in boreholes are developed. By analyzing the energy equilibrium of water-steam passing through the injector hole, we find an expression to describe the relation between the cross-sectional area of injector hole and the layer pressure. With this expression, we provide a new set of calculation methods and write the corresponding computer program to design and calculate the main parameters of a steam injector. The actual measurement data show that the theoretically calculated results are accurate, the software runs reliably, and they provide the design of self-adjustable layered steam injectors with the theoretical foundation.

Design of a Self-Adaptive Down-Hole Layered Steam Injector and Its Application

Layered steam injection, widely used in Liaohe Oilfield at present, is an effective recovery technique to heavy oil reserves. Which makes the steam front-peak push forward uniformly, the amount of steam injection be assigned rationally, and the effect of injection steam be obtained as expected. To maintain a fixed ratio of layered steam injection and solve the problem of nonadjustable hole diameter with the change of layer pressure in the existing injectors, a new method is proposed in this paper to design layered steam injectors based on the dynamic balance theory According to gas-liquid two-phase flow theory and heat transfer theory, the energy equation and the heat conduction equation in boreholes are developed. By analyzing the energy equilibrium of water-steam passing through the injector hole, we find an expression to describe the relation between the cross-sectional area of injector hole and the layer pressure. With this expression, we provide a new set of calculation methods and write the corresponding computer program to design and calculate the main parameters of a steam injector. The actual measurement data show that the theoretically calculated results are accurate, the software runs reliably, and they provide the design of self-adjustable layered steam injectors with the theoretical foundation.

稠油污染土壤高级氧化-生物耦合修复研究

稠油中的胶质和沥青质是导致稠油污染土壤难以彻底降解的关键要素，而目前传统的生物修复方法很难满足其处理要求。针对这一难题，本文研究了高级氧化-生物耦合修复方法处理稠油污染土壤，达到了使稠油中胶质和沥青质高效去除的目的。 本文采用蛭石模拟土壤，研究稠油污染土壤的高级氧化（臭氧、芬顿）-生物耦合处理方法。分析了氧化时间、水土比、污染土壤陈化时间和污染浓度对臭氧氧化效率的影响，以及H2O2加入量和H2O2/Fe2+摩尔比对芬顿预处理效率的影响；同时优化了高级氧化与微生物混合菌之间的耦合条件；并根据稠油成分的变化，探讨了稠油降解机制。 实验结果表明，模拟稠油污染土壤的最佳臭氧-生物耦合条件为：臭氧氧化30min，生物段采用混合菌1降解14d，此时，土壤中总石油烃、饱和烃、芳烃、胶质和沥青质的降解率分别为60.78%、65.59%、82.74%、26.61％；芬顿-生物耦合处理的最佳条件为：H2O2 加入量为27ml，H2O2与Fe2+的摩尔比为10：1，此时，模拟土壤中稠油总石油烃、饱和烃、芳烃、胶质和沥青质的降解率分别为35.41%，9.33%，49.82%，45.19%。 高级氧化预处理不仅能够减小生物段负荷，而且能够提高胶质和沥青质的生物可利用性，微生物可将胶质和沥青质降解为饱和烃、芳烃或其他物质，降解效率取决于预处理的程度。高级氧化-生物耦合处理降解效率高于单独采用氧化预处理、生物处理效率，因而高级氧化-生物耦合修复方法是一种可行的稠油污染土壤修复方法。

叠前叠后联合反演技术及其在QHD32-6油田的应用研究

What geophysical inversion studied includes the common mathematics physical property of inversion and the constitution and appraisal method of solution in geophysics domain, i.e. using observed physical phenomenon from the earth surface to infer space changing and physical property structure of medium within the earth. Seismic inversion is a branch of geophysical inversion. The basic purpose of seismic inversion is to utilizing seismic wave propagating law in the medium underground to infer stratum structure and space distribution of physical property according to data acquisition, processing and interpretation, and then offer the vital foundation for exploratory development. Poststack inversion is convenient and swift, its acoustic impedance inversion product can reflect reservoir interior changing rule to a certain degree, but poststack data lack abundant amplitude and travel time information included in prestack data because of multiple superimpose and weaken the sensitiveness which reflecting reservoir property. Compared with poststack seismic inversion, prestack seismic inversion has better fidelity and more adequate information. Prestack seismic inversion, including waveform inversion, not only suitable for thin strata physical property inversion, it can also inverse reservoir oil-bearing ability. Prestack seismic inversion and prestack elastic impedance inversion maintain avo information, sufficiently applying seismic gathering data with different incident angle, partial angle stack, gradient and intercept seismic data cube. Prestack inversion and poststack inversion technology were studied in this dissertation. A joint inversion method which synthesize prestack elastic wave waveform inversion, prestack elastic impedance inversion and poststack inversion was proposed by making fully use of prestack inversion multiple information and relatively fast and steady characteristic of poststack inversion. Using the proposed method to extract rock physics attribute cube with clear physical significance and reflecting reservoir characterization, such as P-wave and S-wave impedance, P-wave and S-wave velocity, velocity ratio, density, Poisson ratio and Lame’s constant. Regarding loose sand reservoir in lower member of Minghuazhen formation, 32-6 south districts in Qinhuangdao,as the research object, be aimed at the different between shallow layer loose sand and deep layer tight sand, first of all, acquire physical property parameters suitable for this kind of heavy oil pool according to experimental study, establishing initial pressure and shear wave relational model; Afterwards, performing prestack elastic wave forward and inversion research, summarizing rules under the guidance of theoretical research and numerical simulation, performing elastic impedance inversion, calculating rock physics attributes; Finally, predicting sand body distribution according to rock physics parameters, and predicting favorable oil area combine well-logging materials and made good results.

松辽盆地河流-三角洲体系高分辩率层序地层学、储层构形及非均质模型研究

This dissertation tries to combine the new theories of high-resolution sequence stratigraphy and reservoir architecture with fine sedimentology to form a integral theory system -"high-resolution sequence sedimentology", which can be applied widely ranging from the early petroleum exploration to the tertiary recovery stage in marine and terrestrial basin. So the west slope area in south of Songliao basin, in which, early-fine exploration have been developed, and Xingnan area of Daqing placantictine in high water-bearing and tertiary recovery stage, are selected as target areas to research and analyze. By applying high-resolution sequence stratigraphy theory as well as analysis of source area-facies, the west slope area has been divided into two source areas and three drainage systems and the following conclusions have been drawn: three high values sandstone areas, two sandstone pinchout zones and one stratigraphic pinchout overlap; the facies between Baicheng-Tongyu drainage system is frist ascertained as large-scale argillaceous filled plain facies; fine-grained braided channel-delta depositional system has been found; plane sedimentary facies and microfacies maps of different-scale sequence have been completed, and then twenty-eight lithologic traps have been detected in the east of Taobao-Zhenlai reverse fault zone; In no exploration area of the west, large-scale stratigraiphic overlap heavy oil reservoirs has first been found, which has become an important prograss. In Xingnan area, in the view of high-resolution sequence stratigraphy, the surface of unconformity (the bottom of SSC13) in P I group has been identified, and the following method and technique have been advanced: the division and correlation methods of short-scale base-level cycle sequence (SSC); the comprehensive research methods of SSC plane microfacies; the division technique of hierarchy and type of flow unit, the origin of large-scale composite sandbody and flow unit; And ,on the basis of these, 103 monosandstone bodies and 87 flow units of the third levels have been identified, and four levels of flow units model of five sandstone-bodies types have been established. Because it is a very difficult task all over the world to research architecture in subsurface monosandstone body, brings forward a series of techniques as follows: technique of researching architecture of thin interbed in subsurface monosandstone body; classification, type and liquid-resisting mechanism of thin interbed; multiple-remember vertical subsequence model of remaining oil in monosadstone body. Models of heterogeneity and architecture of thin interbed in five types of monosandstone body have been established. Applying these techniques, type and distribution of remaining oil in different types of monosandstone bodies have been predicated.

Alpha-decay for heavy nuclei in the ground and isomeric states

The alpha-decay half-lives of nuclei in the ground states and Isomeric states have been calculated within the WKB approximation and Royer's formulas. The barrier in the quasimolecular shape path is determined within a generalized liquid drop model (GLDM). in which the centrifugal potential energy has been introduced to study the unfavored a-decay The agreement between the calculated results and experimental data indicates the reliability of studying alpha-decay of isomeric states with the generalized liquid drop model We find that their is no significant difference of preformation probability between Isomeric states and the corresponding ground states generally in favored alpha-decay Additionally. we extended Royer's formulas by taking account of the role of centrifugal harrier to study the unfavored alpha-decay, and some predicts oil the a decay half-lives of Isomers are made Finally. the effects of angular momontum transfer and Q(alpha) on alpha-decay half-life have been discussed Crown Copyright (C) 2009 Published by Elsevier B.V. All rights reserved

Experimental study and simulation principles of an oil-gas multiphase transportation system

Presented is an experimental study on the performance of an oil-gas multiphase transportation system, especially on the multiphase flow patterns, multiphase pumping and multiphase metering of the system. A dynamic simulation analysis is conducted to deduce simulation parameters of the system and similarity criteria under simplified conditions are obtained. The reliability and feasibility of two-phase flow experiment with oil and natural gas simulated by water and air are discussed by using the similarity criteria.

Simulations of oil spread on a water surface

Numerical simulation of an oil slick spreading on still and wavy surfaces is described in this paper. The so-called sigma transformation is used to transform the time-varying physical domain into a fixed calculation domain for the water wave motions and, at the same time, the continuity equation is changed into an advection equation of wave elevation. This evolution equation is discretized by the forward time and central space scheme, and the momentum equations by the projection method. A damping zone is set up in front of the outlet boundary coupled with a Sommerfeld-Orlanski condition at that boundary to minimize the wave reflection. The equations for the oil slick are depth-averaged and coupled with the water motions when solving numerically. As examples, sinusoidal and solitary water waves, the oil spread on a smooth plane and on still and wavy water surfaces are calculated to examine the accuracy of simulating water waves by Navier-Stokes equations, the effect of damping zone on wave reflection and the precise structures of oil spread on waves.