Ecophysiological characteristics of four intertidal marine macroalgae during emersion along Shantou coast of China, with a special reference to the relationship of photosynthesis and CO2

Intertidal marine macroalgae experience periodical exposures during low tide due to their zonational distribution. The duration of such emersion leads to different exposures of the plants to light and aerial CO2, which then affect the physiology of them to different extents. The ecophysiological responses to light and CO2 were investigated during emersion in two red algae Gloiopeltis furcata and Gigartina intermedia, and two brown algae Petalonia fascia and Sargassum hemiphyllum, growing along the Shantou coast of China. The light-saturated net photosynthesis in G. furcata and P. fascia showed an increase followed by slightly desiccation, whereas that in G. intermedia and S. hemiphyllum exhibited a continuous decrease with water loss. In addition, the upper-zonated G. furcata and P. fascia, exhibited higher photosynthetic tolerance to desiccation and required higher light level to saturate their photosynthesis than the lower-zonated G. intemedia and S. hemiphyllum. Desiccation had less effect on dark respiration in these four algae compared with photosynthesis. The light-saturated net photosynthesis increased with increased CO2 concentrations, being saturated at CO2 concentrations higher than the present atmospheric level in G. furcata, G. intermedia and S. hemiphyllum during emersion. It was evident that the relative enhancement of photosynthesis by elevated CO, in those three algae increased, though the absolute values of photosynthetic enhancement owing to CO2 increase were reduced when the desiccation statuses became more severe. However, in the case of desiccated P. fascia (water loss being greater than 20 %), light saturated net photosynthesis was saturated with current ambient atmospheric CO2 level. It is proposed that increasing atmospheric CO2 will enhance the daily photosynthetic production in intertidal macroalgae by varied extents that were related to the species and zonation.

Effects of Cu-Wire Surface Fluctuations on Early Failures

Different chemical mechanical polishing （CMP） slurries are used to obtain single-damascene Cu-wires with different surface fluctuations as well as pre-existing surface-defects in wires with rougher surfaces. The presence of such pre-existing defects strongly increases the rate of early failures to almost 100%, reduces electromigration lifetime rapidly to the level of early failures, and changes the multimodal failure distribution into monomodal. The activation energy （0. 74±0.02eV） for the failure mechanism associated with these pre-existing defects confirms a dominant surface diffusion. It shows how a weakest link approximation analysis can he applied to a single wire by dividing the wire into relevant segments and assigning different failure mechanisms to the various segments. The analysis confirms that, although surface-defects are not the fastest early failure mechanism, the ten times higher surface-defectdensity in the rougher wires is responsible for the observed high early-failure rate and unreliable performance.

Genesis of Th-230 excess in basalts from mid-ocean ridges and ocean islands: Constraints from the global U-series isotope database and major and rare earth element geochemistry

Based on Th-230-U-238 disequilibrium and major element data from mid-ocean ridge basalts (MORBs) and ocean island basalts (OIBs), this study calculates mantle melting parameters, and thereby investigates the origin of Th-230 excess. (Th-230/U-238) in global MORBs shows a positive correlation with Fe-8, P (o), Na-8, and F-melt (Fe-8 and Na-8 are FeO and Na2O contents respectively after correction for crustal fractionation relative to MgO = 8 wt%, P (o)=pressure of initial melting and F (melt)=degree of melt), while Th-230 excess in OIBs has no obvious correlation with either initial mantle melting depth or the average degree of mantle melting. Furthermore, compared with the MORBs, higher (Th-230/U-238) in OIBs actually corresponds to a lower melting degree. This suggests that the Th-230 excess in MORBs is controlled by mantle melting conditions, while the Th-230 excess in OIBs is more likely related to the deep garnet control. The vast majority of calculated initial melting pressures of MORBs with excess Th-230 are between 1.0 and 2.5 GPa, which is consistent with the conclusion from experiments in recent years that D (U)> D (Th) for Al-clinopyroxene at pressures of > 1.0 GPa. The initial melting pressure of OIBs is 2.2-3.5 GPa (around the spinel-garnet transition zone), with their low excess Ra-226 compared to MORBs also suggesting a deeper mantle source. Accordingly, excess Th-230 in MORBs and OIBs may be formed respectively in the spinel and garnet stability field. In addition, there is no obvious correlation of K2O/TiO2 with (Th-230/U-238) and initial melting pressure (P (o)) of MORBs, so it is proposed that the melting depth producing excess Th-230 does not tap the spinel-garnet transition zone. OIBs and MORBs in both (Th-230/U-238) vs. K2O/TiO2 and (Th-230/U-238) vs. P (o) plots fall in two distinct areas, indicating that the mineral phases which dominate their excess Th-230 are different. Ce/Yb-Ce curves of fast and slow ridge MORBs are similar, while, in comparison, the Ce/Yb-Ce curve for OIBs shows more influence from garnet. The mechanisms generating excess Th-230 in MORBs and OIBs are significantly different, with formation of excess Th-230 in the garnet zone only being suitable for OIBs.

天山南北山前盆地中-新生代沉积记录及其动力学分析

It has been long known that intense multiple Mesozoic-Cenozoic intracontinental deformations have controlled the grand scale basin-range structural evolution of the Tianshan and its adjacent basins. So it is important to study the sedimentary records of the piedmont basins along the two sides of the Tianshan synthetically for the continental geodynamic research.We carried out a magnetostratigraphy study on Cretaceous- Tertiary succession and U-Pb dating analysis of detrital zircons from the representative sandstone samples of the Mesozoic-Cenozoic deposits in Kuqa Subbasin, northern Tarim Basin, combining our previous results of multiple depositional records from different profiles including paleocurrent data, conglomerate clast, sandstone framswork grains, detrital heavy minerals and geochemistry analysis, so the multiple intracontinental tectonic processes of Tianshan and their depositional response in the Kuqa Subbasin can be revealed. The results show that the tectonic evolution of the Tianshan Orogen and the sedimentary processes of the Kuqa Subbasin can be divided into four periods: early Triassic(active period), from middle Triassic to late Jurassic(placid period), from early Cretaceous to Tertiary Paleocene(active period) and from Neogene to present (intensely active period). Simultaneously，the depositional records reveal the provenance types and tectonic attributes in different periods. As follows, the lower Triassic with a dominant age ranging from 250 to 290Ma of the Zircons, which were principally derived from alkali feldspar granites and alkaline intrusion obviously, relative to the magma activity in Permian. In middle Triassic-late Jurassic, the two samples collected from the Taliqike formation and the Qiakemake formation respectively show the age peak at 350～450Ma, which was relative to the subduction of the Tarim Block to Yili-Central Tianshan Plate. In this period the provenance of the Kuqa deposits was the Central Tianshan arc orogenic belts distantly with little height predominance.During early Cretaceous-Paleogene, two major zircons age spectra at 240~330Ma and 370~480Ma have been acquired, with some other not dominant age ranges, indicating complicated provenance types. In Neogene, the detrital zircons age dating ranges from 460 to 390 Ma primarily. What’s more, the newer chronology of the stratigraphy and the older source age, indicating that Tianshan was uplifted and exhumated further strongly. Further study on the heavy mineral and the detrital zircons age dating of the Mesozoic-Paleogene representative profiles in southern Junggar Basin, combined with the published results of the sandstone framework grains, we consider that it occurred obvious sedimentary and tectonic changes occurred in the inside of Jurassic, from late Jurassic to early Cretaceous and form early Cretaceous to late Cretaceous. On this faces, there are remarkable changes of the steady minerals and unstable minerals, the sandstone maturity and the age spectra of the detrital zircons. Compared the sedimentary records from the two sides of the Tianshan, We find that they are different obviously since Middle Jurassic. It can be concluded that Tianshan have uplifted highly enough to influence the paleo-climatic. According to the current strata division, the structural activity apparently showed a migration from north to south. That is to say, the South Tianshan uplift later than the north, especially from late Jurassic to early Cretaceous , but it was uplifted and exhumated more strongly. Furthermore, correlating the depositional records and tectonic styles in the Kuqa-South Tianshan basin-range conjugation site in the east with the west, the obvious differentiation between the west and the east from the Cretaceous especially in Tertiary along the Tianshan-Kuqa belt was revealed, probably showing earlier uplifting in the east while greater exhumation depth and sediment rates in the west. In addition, the contacting style of Kuqa subbasin to the Tianshan Orogenic belts and the basement structure are also inconsistent at different basin-range conjugation sites. It is probably controlled by a series of N-S strike adjusting belts within the Kuqa subbasin, or probably correlated with the material difference at the complicated basin-range boundary. The research on the Mesozoic-Cenozoic tectonic-depositional response in the piedmont basins along the two sides of the Tianshan shows that the basin-filling process was controlled by the intracontinental multicyclic basin-range interactions, especially affected by the intense tectonic differentiations of basin-range system, which can’t be illuminated using a single evolutionary model.