青藏高原东缘川西云杉林皆伐后灌木生长、繁殖与更新的研究

植物群落及其环境在干扰后的演替格局和过程的研究，是群落和生态系统动态研究的一个热点。选取青藏高原东缘山原区川西云杉林皆伐后，从草地过渡到灌丛的关键阶段的4 个皆伐迹地（恢复时间为8 a、10 a、16 a 和21 a），研究皆伐及自然恢复过程对林下典型灌木银露梅（Potentilla glabra）和唐古特忍冬（Lonicera tangutica）的生长与繁殖能力的影响以及灌木植物在迹地上的更新情况，分析灌木在不同生境中的适应对策和适应能力的差异,为揭示青藏高原东缘山原区迹地植被从草甸到灌丛演替的过程和特点及促进迹地演替与植被恢复进程提供理论依据和技术支撑。研究主要结论如下：1）皆伐后银露梅生长和繁殖能力显著提高，但对唐古特忍冬的影响不明显。皆伐后银露梅丛基径、高度和各部分生物量都显著增加（P < 0.05），但唐古特忍冬只有叶生物量和地下生物量增加，总生物量和其余构件生物量无显著变化。皆伐后，银露梅的结实数量、结实株数、不结实株数和结实株/不结实株比例显著增加（P < 0.05）。自然恢复过程中，银露梅和唐古特忍冬生长能力以及银露梅的结实量都表现出降低的趋势。随着迹地自然恢复时间的增加，银露梅和唐古特忍冬的基径、高度、丛叶片数和各部分生物量有减少的趋势。银露梅的结实株数增加, 但结实数量减少。2）皆伐对银露梅和唐古特忍冬生物量分配模式影响不一致。原始林和迹地中（除CT85）银露梅的生物量大小关系皆为：地下>茎>侧枝>叶。唐古特忍冬在原始林中的生物量大小关系为：茎＞地下部分＞侧枝＞叶,而皆伐后生物量的分配情况改变，生物量大小关系变为：地下部分＞茎＞侧枝＞叶。随着自然恢复时间的增加，银露梅减少了地下生物量的分配，而唐古特忍冬增加了地下生物量的分配。3）皆伐和恢复时间的增加改变了迹地物种组成，促使阳性乔、灌木在迹地上定居。4 个迹地上共出现了灌木15 种，乔木3 种，没有出现天然云杉和冷杉幼苗。随着恢复时间的增加，迹地上的灌木物种由原始林下的耐阴物种逐步发展为以针刺悬钩子（Rubus pungens）为主的阳性灌木。4）影响灌木幼苗密度和幼树密度的因子不一致。灌木幼苗密度与灌木层盖度显著负相关，与苔藓层盖度显著正相关。幼树密度与草本层盖度正相关，与苔藓层盖度、灌木层盖度和高度负相关。5）研究发现在青藏高原东缘山原区皆伐15～20 a 后，迹地仍以草本植物为主，推测皆伐后至少20 a 以上迹地才可能向灌丛阶段过渡，比高山峡谷地区的演替进程至少推迟了20 a。银露梅和唐古特忍冬在皆伐后自然恢复过程中表现出不同的生长与繁殖策略是由两个物种的生物学特性的差异引起的。银露梅比唐古特忍冬更适应迹地退化环境。促进青藏高原东缘山原林区迹地森林恢复一方面是尽量减少人为活动的破坏，另一方面，可以通过在迹地中播种适当的乡土乔、灌木种子（如白桦、银露梅）等人工措施，以加快演替进程。The succession pattern and process of plant community and their environments is a hot spotin community and ecosystem dynamic study. Four clearcuts were chosen in Rangtang(recovery time of 8 a、10 a、16 a and 21 a), which represented the key stage of thecommunity evolved from grass stage to shrub stage in the eastern margin of theQinghai-Tibetan Plateau. The growth and reproduction of the Potentilla glabra andLonicera tangutica and the natural regeneration of shrub plants in the primary Piceabalfouriana forest and 4 clearcuts were studied to explore how clear cutting andnatural recovery process affected the understory shrub species during the 21 years inthe eastern margin of the Qinghai-Tibetan Plateau. The main results were below.1) The growth and reproduction of P. glabra significantly increased after forestclear cutting.. But it was not so significant as to the L. tangutica. The organismbiomass and total biomass of P. glabra were increased obviously after clear cutting（P< 0.05）. But only leaves and underground biomass of L. tangutica increasedsignificantly after clear cutting（P < 0.05）. The number of fruit and growth of P. glabraincreased significantly after clear cutting too（P < 0.05）. The ramet height, basaldiameter , organism biomass and friut number of P. glabra and L. tangutica reducedas the increase of recovery time.2) The biomass allocation patterns varied between P. glabra and L. tangutica inthe primary forest and clearcuts. The biomass allocation of P. glabra both in primary forest and clearcuts was followed as: underground part > stem > branch > leaves.However, the biomass allocation of L. tangutica had changed after the clear cutting.The biomass allocation of L. tangutica in the primary forest was followed as: stem >underground part > branch > leaves and it was underground part > stem > branch >leave in clearcuts. The biomass allocation of P. glabra and L. tangutica varied amongclearcuts. Aboveground biomass was increased while underground biomass decreasedfor P. glabra with the increase of recovery period. However, the L. tangutica showedthe reverse changing pattern.3) Clear cutting and recovery time had changed the species composition of theclearcuts. There were 15.shruby species and 3 tree species in the four clearcuts. Nospruce and fir seedlings were found. In the early stage after clear cutting, there wereonly understory shrub species from the primary Picea balfouriana forest. The sunnyspecies, especieally Rubus pungens invaded intensly as the increase of recovery time.4) There was a significant negative relationship between density of seedlingswith shrub layer coverage and positive correlation with moss coverage. The saplingshad significantly positive correlation with herb layer coverage and negativecorrelation with moss coverage, shrub layer coverage and height.5）Comparing to studies in Miyalou, a nearby high mountain and canyon area,the secondary sucession in this subalpine plateau areas lagged at least 20 years.P. glabra and L. tangutica showed different growth and reproduction strategies toclear cutting and natural recovery , which may associated with the difference of theirbiological characters. P. glabra was more adaptive to the clear cutting than the L.tangutica. Two suggestions were probably recommended to promote the recoveryprogress in the subalpine plateau areas based on the results of this study. Limitanthropogenic disturbance, and meanwhile sow native tree and shrub seeds inclearcuts.

Md Simulation Of Dislocation Mobility During Cutting With Diamond Tip On Silicon

By means of Tersoff and Morse potentials, a three-dimensional molecular dynamics simulation is performed to study atomic force microscopy cutting on silicon monocrystal surface. The interatomic forces between the workpiece and the pin tool and the atoms of workpiece themselves are simulated. Two partial edge dislocations are introduced into workpiece Si, it is found that the motion of dislocations does not occur during the atomic force microscopy cutting processing. Simulation results show that the shear stress acting on dislocations is far below the yield strength of Si. (c) 2008 Elsevier Ltd. All rights reserved.

Molecular Dynamics Study Of Mechanical Behaviour Of Screw Dislocation During Cutting With Diamond Tip On Silicon

By means of Tersoff and Morse potentials, a three-dimensional molecular dynamics simulation is performed to study atomic force microscopy cutting on silicon monocrystal surface. The interatomic forces between the workpiece and the pin tool and the atoms of workpiece themselves are calculated. A screw dislocation is introduced into workpiece Si. It is found that motion of dislocations does not occur during the atomic force microscopy cutting processing. Simulation results show that the shear stress acting on dislocation is far below the yield strength of Si.

Comparison of laser performances of 5at.% Yb : Gd2xY2(1-x)SiO5 crystals between different cutting directions

We investigate the laser actions of 5at.% Yb:Gd2xY2(1-x)SiO5 (Yb:GYSO; x = 0.1) crystals with different cutting directions, parallel and vertical to the growth axis. Our results show that the cutting direction of the sample plays an astonished role in the laser operation. The sample cut vertically to the growth axis possesses the favourable lasing characteristics. Its output power reaches 3.13W at 1060nm with a slope efficiency of 44.68% when the absorbed pump power is 8.9 W. In contrast, the sample cut parallel reaches only 1.65 W at 1044 nm with a slope elLiciency of 33.76% with absorbed pump power of 7.99 W. The absorption and emission spectra of the two samples are examined and the merit factor M is calculated. Our analysis is in agreement well with the experimental results. The wavelength tuning range of the superior sample covers from 1013.68 nm to 1084.82 nm.