固相微萃取与色谱联用方法分析水中12种有机氯化合物

运用顶空固相微萃取与色谱联用方法(HS-SPME-GC)对水中的残留有机氯化合物进行了分析.对影响HS-SPME-GC分析灵敏度的各种实验因素如涂层种类、萃取温度、平衡时间、离子浓度等进行了讨论,并将该方法与固相萃取法(SPE)、液液萃取法(LLE)作了对比;同时考察了常见环境共存污染物直链烷基苯磺酸钠(LAS)对几种方法的影响.

Analysis of organchlorine compounds in water by solid phase microextraction and gas chromatography

In this work, both,solid phase microextraction (SPME) and solid phase extraction(SPE) were used to enrich organochlorine compounds in water samples and analyzed by gas chromatography with electron capture detector. The operating conditions of SPME have been studied and different kinds of solid phase were compared. Linear alkybenzene sulfonate(LAS) was added to the samples to investigate its effect on the analysis. The results indicated that polyacrylate was better than other commercial solid phases in extraction of moderated polar organic compounds and the sensitivity of SPME was higher than SPE. LAS affect much in liquid-liquid extraction and headspace SPME; but it has little effect on SPE and direct-SPME method. The applications showed that SPME was a fast and effective method in sample preparation.

关于肥料利用率的猜想

测算肥料利用率的同位素标记法受土壤、肥料间交互作用的影响,而通常肥料试验的差值法则既受土壤、肥料间交互作用,又可能受施肥直接抑制作物吸收土壤养分的双重影响,猜想这两种测算方法都不可能获得可靠结果.本文在给出若干假设的基础上,提出了适用于通常肥料试验估算肥料利用率的替代方法.该法可归避上述影响干扰,但其可靠性有待实验证实.

Influence of liquid bridge volume on the onset of oscillation in floating-zone convection III. Three-dimensional model

An unsteady and three-dimensional model of the floating-half-zone convection on the ground is studied by the direct numerical simulation for the medium of 10 cSt silicon oil, and the influence of the liquid bridge volume on the critical applied temperature difference is especially discussed. The marginal curves for the onset of oscillation are separated into two branches related, respectively, to the slender liquid bridge and the fat liquid bridge. The oscillatory features of the floating-half-zone convection are also discussed.

Effect of dentin tubules on the mechanical properties of dentin - part III: Numerical, analysis

Imitating a real tooth and the periodontal supporting tissues, we have established a 2D finite element model and carried out a numerical analysis based on the inhomogeneous and anisotropic (IA) stress-strain relation and strength model of dentin proposed in the preceding Parts I and II, and the conventional homogeneous and isotropic (III) model, respectively. Quite a few cases of loadings for a non-defected and a defected tooth are considered. The numerical results show that the stress level predicted by the IA model is remarkably higher than that by the III model, revealing that the effect of the dentin tubules should be taken into a serious consideration from the viewpoint of biomechanics.

Asymptotic solution of mode-iii crack in damaged softening materials

In this paper, a constitutive model of elasticity coupled with damage suggested by Lemaitre et al, [1] is used. The macroscopic stress-strain response of the model includes two stages: strain hardening and strain softening. The basic equation is derived for the anti-plane shear problem. Several lowest order asymptotic solutions are obtained, and assembled for the crack-tip fields.

The asymptotic near-tip solution for mode-iii crack in steady growth in power hardening media

Two local solutions, one perpendicular and one parallel to the direction of solar gravitational field, are discussed. The influence of gravity on the gas-dynamical process driven by the piston is discussed in terms of characteristic theory, and the flow field is given quantitatively. For a typical piston trajectory similar to the one for an eruptive prominence, the velocity of the shock front which locates ahead the transient front is nearly constant or slightly accelerated, and the width of the compressed flow region may be kept nearly constant or increased linearly, depending on the velocity distribution of the piston. Based on these results, the major features of the transient may be explained. Some of the fine structure of the transient is also shown, which may be compared in detail with observations.

遥感-岩石力学(III)——交汇断层粘滑的热红外辐射与声发射规律及其构造地震前兆意义

以构造地震孕震机制之三即交汇断层粘滑发震为模拟对象,利用双轴加载实验系统和红外热像仪对自然界经常出现的断层组合模式——不同交汇角度的组合断层的物理模型进行了室内加载实验,利用红外热像仪和声发射仪分别测定了加载过程中试样表面的红外辐射及断层活动的声发射时间序列。结果表明:(1) 声发射及红外辐射的时间序列特征受加载过程中试样的力学行为所控制,并表现出阶段性变化特点;(2) 声发射与红外辐射特征与断层几何结构有密切关系,当主应力与主断层成45°角时,红外辐射异常区主要沿主断层发育;(3) 垂直交汇的断层与斜交断层的声发射及红外辐射特征有明显差异,交汇角度(1°～90°)越大,交汇点处的红外辐射异常越明显。