喜马拉雅西构造结区岩石圈演化三维有限元动力学数值模拟

The past three decades have seen numerous attempts to numerically model stress and strain patterns in the lithosphere of the Earth on both global and regional scales. This efforts have been indispensable in identifying the features we need to include in our endeavour to develop better models of our planet’s lithosphere and they have also raised our awareness for the many unresolved issue in the deep geodynamical issues that need to be addressed in the future. Nonetheless, in most models, the lithosphere is treated as a single layer with depth-averaged properties, and as the same distribution in the stress and strain fields, and as deforming under plane strain. All these above make a great hander for its reality and degree of recognition. As the beginning in this paper, some principal numerical models and results on the evolution of Tibetan plateau are reviewed and analyzed. Then, the geological and geophysical expedition on the Western Himalayan Syntaxis is briefly reviewed. Furthermore, we analysis the feature in deep geophysical field studies in this area and adjacent regions. Because, for most continents, stress models driven by plate boundary forces have successfully reproduced the main characteristics of the stress and strain field, we present a set of three-dimensional models of lithosphere system for a simplified geometry of the Western Himalayan Syntaxis area and its adjacent regions, where we try to match the first-order characteristics of the stress and strain fields of lithosphere since 10 Ma, and deformation and geodynamical evolution process in former 2Ma. Of course, the kinematic boundary conditions of the stress models driven by plate boundary forces were applied. The rheology plays a significant role in the lithospheric tectonics, which lead to different rheological parameters were used in different works although the have the same constitutive equations in models. So, in this paper we do not aim to produce all characteristics of the Western Himalayan Syntaxis areas’ stress and strain fields by the choices of various parameters, but rather the dynamic response between various rheological parameters and stress and strain fields. We have chosen to concentrate on the importance of rheology and lateral strength variations for lithospheric stress and strain patterns and use our findings to build a model of the Western Himalayan Syntaxis areas. In doing so, we want to go beyond purely elastic models or purely viscoelastic models. Compared the results of the crust viscosity in the Western Himalayan Syntaxis areas, we believed that, when various viscoelastic models are adopted, the selection of the coefficient of viscosity in the Western Syntaxis area has important influence on the its uplifts and evolutions. A wider uplift ranges and gently elevation was observed at the same time when a lower viscosity was used in our models, and vice versa. Data of stress magnitudes are not available, but it is clear that the stress levels must be at or below the failure threshold of rock under compression. Under these criteria, the calculation results show that the viscosity in the Western Syntaxis area should be smaller than 1023Pa.s When elastic model is adopted in relatively rigid Tarim basin, obvious changes are induced to the stress and strain fields of the whole Western Syntaxis area. We found that rigid block of lithosphere reduced stress levels within its interior and that, at the edges of such regions, stress orientation can change. Furthermore there is no evidence that such rigid regions act as stress barriers in that they shield areas in opposite sides of the structure from the influence of one another. In our models, the upper crustal material of the Western Syntaxis area does not turns to move westward. Whereas, because of the stress and strain fields have been decoupling at the interior of the lithosphere, we can get the results that the deep material must not move westward.