Prototype of the Superferric Dipoles for the Super-FRS of the FAIR-Project

The FAIR China Group (FCG), consisting of the Institute of Modern Physics (IMP Lanzhou), the Institute of Plasma Physics (ASIPP, Hefei) and the Institute of Electric Engineering (IEE, Beijing) developed and manufactured in cooperation with GSI, Germany a prototype of a superferric dipole for the Super-Fragment-Separator of the FAIR-project [1]. The dipole magnets of the separator will have a deflection radius of 12.5 m, a field up to 1.6 T, a gap of at least 170 mm and an effective length of more than 2 meters to bend ion beams with a rigidity from 2 T . m up to 20 T . m. The magnets operate at DC mode. These requirements led to a superferric design with a yoke weight of more than 50 tons and a maximum stored energy of more than 400 kJ. The principles of yoke, coil and cryostat construction will be presented. We will also show first results of tests and measurements realized at ASIPP and at IMP.

Entanglement purification with higher error threshold for imperfection of local operations and bell state measurements

We analyse further the entanglement purification protocol proposed by Feng et al. (Phys. Lett. A 271 (2000) 44) in the case of imperfect local operations and measurements. It is found that this protocol allows of higher error threshold. Compared with the standard entanglement purification proposed by Bennett et al. [Phys. Rev. Lett. 76 (1996) 722], it turns out that this protocol is remarkably robust against the influences of imperfect local operations and measurements.

BLENDS OF POLY[3,3-BIS(CHLOROMETHYL)OXETANE] WITH POLY(VINYL ACETATE) .1. THERMAL AND MECHANICAL-PROPERTIES

Blends of poly[3,3-bis(chloromethyl)oxetane] (Penton) with poly(vinyl acetate) were prepared. Compatibility, morphology, thermal behavior, and mechanical properties of blends with various compositions were studied using differential scanning calorimetry (DSC), dynamic mechanical measurements (DMA), tensile tests, and scanning electron microscopy (SEM). DMA study showed that the blends have two glass transition temperatures (T(g)). The T(g) of the PVAc rich phase shifts significantly to lower temperatures with increasing Penton content, suggesting that a considerable amount of Penton dissolves in the PVAc rich phase, but that the Penton rich phase contains little PVAc. The Penton/PVAc blends are partially compatible. DSC results suggest that PVAc can act as a beta-nucleator for Penton in the blend. Marked negative deviations from simple additivity were observed for the tensile strength at break over the entire composition range. The Young's modulus curve appeared to be S-shaped, implying that the blends are heterogeneous and have a two-phase structure. This was confirmed by SEM observations.

Electrochemical and quantum chemical study of purines as corrosion inhibitors for mild steel in 1 M HCl solution

The purines and its derivatives, such as, guanine, adenine, 2,6-diaminopurine, 6-thioguanine and 2,6-dithiopurine, were investigated as corrosion inhibitors for mild steel in 1 M HCl solution by weight loss measurements, electrochemical tests and quantum chemical calculations. The polarization curves of mild steel in the hydrochloric acid solutions of the purines showed that both cathodic and anodic processes of steel corrosion were suppressed. The Nyquist plots of impedance expressed mainly as a depressed capacitive loop with different compounds and concentrations. For all these purines, the inhibition efficiency increased by increasing the inhibitor concentration, and the inhibition efficiency orders are 2,6-dithiopurine > 6-thioguanine > 2,6-diaminopurine > adenine > guanine with the highest inhibiting efficiency of 88.0% for 10(-3) M 2,6-dithiopurine. The optimized structures of purines, the Mulliken charges, molecular orbital densities and relevant parameters were calculated by quantum chemical calculations. The quantum chemical calculation results inferred that the adsorption belong to physical adsorption, which might arise from the pi stacking between the pi electron of the purines and the metal surface. (C) 2008 Elsevier Ltd. All rights reserved.

油气藏自然电位异常与油气赋存的相关性研究

The Stack Spontaneous Potential (SSP) is a direct hydrocarbon location technology and a new hydrocarbon detection method with independent intellectual property. A subsurface hydrocarbon accumulation associated with the upward hydrocarbon micro seepage induces a relatively strong negative potential abnormal zone, of which the anomaly can be measured on the surface with specially designed instruments through careful field measuring procedures. With special software programmed according to a unique geochemical and geophysical model, the original data are analyzed, processed and interpreted on the computer, and then on a series of resulting anomaly distribution maps and/or profiles, the favorable surface locations of the hydrocarbon accumulations can be easily identified. The study of the SSP has been started since 1989, and especially from 1996 to 1997, both profile and area tests were conducted in the Daqing Oilfield. On the testing line of 15kms, there are 6 wells in total, among which some are oil-producing wells, and some are water-producing wells. The final matching ratio of the favorable oil well locations and the possible water well locations predicted by the SSP to those of known wells was up to 83 percent. In the area test, of which the acreage is 800 km2, the matching ratio compared with the existing wells was 87 percent; furthermore, regarding to wells subsequently drilled after the test, the matching ratio was 85 percent. The matching ratio in the development area is more about 10 percent than those of in exploration area. The reason is that, comparing the exploration area, the development area acreage is less and the container rocks are more simplex. In development area there is not so much interference of SSP also. Since 1997 the SSP has been tested and applied all over China to a number of hydrocarbon bearing basins and known oil fields, including the Daqing, Jiangsu, Changqing, Shengli, Nanyang, Jianghan and Zhongyuan Oilfields, only to name a few. The SSP surveys in total areas of over 10,000km2 in more than 30 regions in China so far have been completed in various exploration and development stages, the satisfactory outcomes of which have further evidenced that the dependence between the SP anomaly and abundance of hydrocarbon. Up to date, a substantial amount of successful tests and actual surveys finished in exploration and development practices have evidenced that the SSP is significantly more reliable in comparison with any other similar direct hydrocarbon indication technique generally known to the oil industry, such as the Redox. The SSP can be applied to search for almost all kinds of hydrocarbon accumulations, regardless of the type of traps, such as structural, stratigraphic, buried hill traps, and so on; however, it is interesting to be noted that the SSP seems to be particularly effective in detecting the stratigraphic oil traps according to our practices. On the other hand, there is virtually no surface geographical constrains in terms of field data acquisition, except for those water covered areas, because of the inherent characteristics of the technology itself. Furthermore, utilizing the SSP requires no special considerations to subsurface geological conditions in regard to formation resistivity, since the SSP measurements will not be influenced by either overly high or overly low resistivity of formations lying above the hydrocarbon accumulations. There are two kind of theory, of which, as we know one is called hypbyssal theory such as "Redox"[61 the other is call plutonic theory such as cracking of hydrocarbon [8][9] and natural polarization [3], to describe the mechanism of SP anomaly of oil reservoir and to indicate that the dependence between the SP abnormality and abundance of hydrocarbon has be existed theoretically/The quantitative dependence, which has not been founded due to the complicity of container rocks, be discovered during the exploration and development practices is the crux to the quantitative analysis of SP Anomaly processing. Based on the thorough study of the complex of collector rocks, every kind of thickness of collector rock can be conversed to be a standard effective thickness; the thickness is called apparent effective thickness (AET). The conversation coefficient (ai, 1=1,2,3) could be determined by the variety of every collector rock storability (CRS). The discoveration of quantitative: dependence between AET and the amplitude of SSP, in the practices of exploration and development, is a promotion for the SSP supplied in the oil exploration, and make the data analysis forward to the quantitative stage.