Construction of cytoplasmic molecular markers distinguishing Danio rerio from Gobiocypris rarus at high identity domains based on MP-PCR strategy and Sybr Green I detection

To distinguish the cytoplasm of Danio rerio from that of Gobiocypris rarus, we cloned G. rarus COXI and constructed cytoplasmic molecular markers at the high identity domains of COXI by mutated primer PCR (MP-PCR for short). Then Sybr Green I was used to detect the single amplicon. As a result, we succeeded in getting the cytoplasmic molecular markers, G.M COXI and Z.M COXI, by MP-PCR strategy. They were used to detect the sperm-derived mtDNA in the sexual hybrid embryos (D. rerio female x G. rarus male) before the sphere stage. In the present study, all results demonstrate that MP-PCR approach and Sybr Green I detection are feasible to construct the molecular markers to identify genes that shared high identity.

Distinguishing the sources of Asian dust based on electron spin resonance signal intensity and crystallinity of quartz

IEECAS SKLLQG

i-Motif Quadruplex DNA-Based Biosensor for Distinguishing Single- and Multiwalled Carbon Nanotubes

The increasing worldwide demand for carbon nanotubes (CNTs) and increasing concern regarding how to safely develop and use CNTs are requiring a low-cost, simple, and highly sensitive CNT detection assay for toxicological evaluation and environmental monitoring. However, this goal is still far from being achieved. All the current CNT detection techniques are not,applicable for automation and field analysis because they are dependent on highly expensive special instruments and complicated sample preparation. On the basis of the capability of single-walled carbon nanotubes (SWNTs) to specifically induce human telomeric i-motif formation, we design an electrochemical DNA (E-DNA) sensor that can distinguish single- and multiwalled carbon nanotubes both in buffer and in cell extracts. The E-DNA sensor can selectively detect SWNTs; with a direct detection limit of 0.2 ppm and has been demonstrated in cancer cell extracts. To the best of our knowledge, this is the first demonstration of a biosensing technique that can distinguish different types of nanotubes. Our work will provide new insights into how to design a biosensor for detection of carbon nanotubes.

New method of mass spectrometry for distinguishing ephedrine and isoephedrine

Ephedrine and isoephedrine were first distingshed by electrospy ionization mass spectrometry and in-sourice collision-induced dissociation technique. Based on this observation, a unkown sample was identified for ephedrine.

Quantitatively distinguishing sediments from the Yangtze River and the Yellow River using delta Eu-N-I REEs pound plot

Sediment samples were collected from the lower channel of the Yangtze River and the Yellow River and the contents of rare earth elements (REEs) were measured. In addition, some historical REEs data were collected from published literatures. Based on the delta Eu-N-I REEs pound plot, a clear boundary was found between the sediments from the two rivers. The boundary can be described as an orthogonal polynomial equation by ordinary linear regression with sediments from the Yangtze River located above the curve and sediments from the Yellow River located below the curve. To validate this method, the REEs contents of sediments collected from the estuaries of the Yangtze River and the Yellow River were measured. In addition, the REEs data of sediment Core 255 from the Yangtze River and Core YA01 from the Yellow River were collected. Results show that the samples from the Yangtze River estuary and Core 255 almost are above the curve and most samples from the Yellow River estuary and Core YA01 are below the curve in the delta Eu-N-I REEs pound plot. The plot and the regression equation can be used to distinguish sediments from the Yangtze River and the Yellow River intuitively and quantitatively, and to trace the sediment provenance of the eastern seas of China. The difference between the sediments from two rivers in the delta Eu-N-I REEs pound plot is caused by different mineral compositions and regional climate patterns of the source areas. The relationship between delta Eu-N and I REEs pound is changed little during the transport from the source area to the river, and from river to the sea. Thus the original information on mineral compositions and climate of the source area was preserved.

Comparative Study Of The Influence Of Natural Convection On Directional Solidification Of Al-3.5 Wt% Ni And Al-7 Wt% Si Alloys

We present numerical simulations of thermosolutal convection for directional solidification of Al-3.5 wt% Ni and Al-7 wt% Si. Numerical results predict that fragmentation of dendrite arms resulting from dissolution could be favored in Al-7 wt% Si, but not in Al-3.5 wt% Ni. Corresponding experiments are in qualitative agreement with the numerical predictions. Distinguishing the two fragmentation mechanisms, namely dissolution and remelting, is critical during experiments on earth, when fluid flow is dominant. (C) 2007 COSPAR. Published by Elsevier Ltd. All rights reserved.

Direct dynamical test for deterministic chaos and optimal embedding of a chaotic time-series

We propose here a local exponential divergence plot which is capable of providing an alternative means of characterizing a complex time series. The suggested plot defines a time-dependent exponent and a ''plus'' exponent. Based on their changes with the embedding dimension and delay time, a criterion for estimating simultaneously the minimal acceptable embedding dimension, the proper delay time, and the largest Lyapunov exponent has been obtained. When redefining the time-dependent exponent LAMBDA(k) curves on a series of shells, we have found that whether a linear envelope to the LAMBDA(k) curves exists can serve as a direct dynamical method of distinguishing chaos from noise.

在激波波面中氧分子的非平衡离解

对强激波作用下双原子分子振动与离解耦合的非平衡离解过程进行了理论计算.本工作的特点是将计算起点建立在分子基本参数上,采用主方程理论处理振动与离解的耦合,振动跃迁几率用SSH理论计算,在离解限附近考虑多量子数跃迁并计及原子复合的影响.对O2-Ar体系,计算给出了在正激波后O2分子振动能级分布、振动弛豫时间、离解孕育时间、离解产物浓度、离解速率系数等物理量随时间的演化.计算结果分别与Camac和Wray的实验相符.计算显示,在激波作用的后期,有准稳态的振动能级布居分布.计算结果显示,Park模型低估了非平衡离解速率系数,Hansen模型则高估了非平衡离解速率系数.

Microstructure Evolution of Laser Pulse processed Ductile Iron Surface

Pulsed laser beam was used to modify surface processing for ductile iron. The microstructures of processed specimen were observed using optical microscope (OM). Nanoindentation and micro-hardness of microstructures were measured from surface to inner of sample. The experimental results show that, modification zone is consisted of light melted zone, phase transformation hardening area and transient area. The light melt area is made up of coarse dendrite crystalline with a thickness less than 20um, phase transformation hardening area mainly of laminal or acicular martensite, retained austenite and graphite, i.e. M+A prime+ G. The cow-eye microstructure around graphite sphere always is formed in phase transformation hardening area zone, which consisting of a variety structure with the distance from the surface. So, it maybe as a obvious sign distinguishing modification zone border. Finally, the microstructures evolution of laser pulse processed ductile iron was analyzed coupling with beam energy distribution in space and laser pulse heating procession characteristics. The analysis shows that energy distribution of laser pulse has an important effect on microstructure during laser pulse modified ductile iron. Multi-scale and interlace arrangement are the important features for laser pulse modified ductile iron. Of microstructure.

MANDIBULAR MORPHOMETRICS AMONG MACAQUES - THE CASE OF MACACCA-THIBETANA

Recent field studies suggest that Macaca thibetana, a large endemic Chinese macaque, may be quite folivorous, distinguishing it from most other macaque species, which tend to be primarily frugivorous. To understand how this diet affects its masticatory system, we conducted a comparative morphometric study of mandibular dimensions. We took linear measurements from male and female mandibles of this species as well as four other macaques-M. fascicularis, M. nemestrina, M. arctoides, and M. assamensis-and four species of Presbytis-P. obscura, P. rubicunda, P. cristata, and P. phayrei-and subjected to them to a variety of analyses. Based on analyses of variances and discriminant analyses on each sex individually, the mandible of M. thibetana corresponds to expected patterns for folivorous primates with respect to its wide condyles and thick corpora: However, the height of the corpus and symphysis are lower, and the anteroposterior length of the condyle is longer than predicted for a folivore. In addition to interpretations specifically relating to M. thibetana, we also discuss the functional morphology of the other species in light of what is published about their diets.