Fatigue fracture-behavior of carbon-fiber-reinforced modified bismaleimide composites

The fracture toughness and fatigue fracture behaviour of carbon-fiber-reinforced modified bismaleimide (BMI) composites have been studied. These composites were found to have higher fracture toughnes, better damage tolerance and longer fatigue life than carbon-fiber composites with epoxy matrices. Delamination is the major mode of failure in fatigue and it is controlled by the properties of the matrix and interface. The improved performance is dire to the presence of thermoplastic particles in the modified BMI matrix which gives rise to enhanced fiber/matrix adhesion and more extensive plastic deformation. The fatigue behaviour also depends on the stacking sequence, with the multidirectional [45/90/-45/0] fiber-reinforced modified BMI composite having a lower crack propagation rate and longer fatigue life than the unidirectional laminate. This arises because of the constraint on the damage processes due to the different fiber orientation in the plies.

Tolerance analysis for incident angle of volume phase holographic grating used in optical channel performance monitor

Transmission Volume Phase Holographic Grating (VPHG) is adopted as spectral element in the real-time Optical Channel Performance Monitor (OCPM), which is in dire need in the Dense Wavelength -division-multiplexing(DATDM) system. And the tolerance of incident angle, which can be fully determined by two angles: 6 and (p, is finally inferred in this paper. Commonly, the default setting is that the incident plane is perpendicular to the fringes when the incident angle is mentioned. Now the situation out of the vertical is discussed. By combining the theoretic analysis of VPHG with its use in OCPM and changing 6 and (0 precisely in the computation and experiment, the two physical quantities which can fully specify the performance of VPHG the diffraction efficiency and the resolution, are analyzed. The results show that the diffraction efficiency varies greatly with the change of 6 or (p. But from the view of the whole C-band, only the peak diffraction efficiency drifts to another wavelength. As for the resolution, it deteriorates more rapidly than diffraction efficiency with the change of (p, while more slowly with the change of theta. Only if \phi\less than or equal to+/-1degrees and alpha(B) -0.5 less than or equal to theta less than or equal to alpha(B) + 0.5, the performance of the VPHG would be good enough to be used in OCPM system.

贝尔凹陷苏德尔特构造带古潜山构造与储层研究

With the develop ment of oil and gas exploration, the conventional struc ture exploration era has gradually been substituted by the concealed reser voir exploration technology. Hill poll becomes one of the most important areas in the future exploration. This paper is based on the three-dimensional seismic interpretation of Sudeerte structure. In terms of the overall character istics of Sudeerte structure, we use the coherent cube and the time slice to interpret the fault in plane. For the interpretation，we especially used the well to adjust the interpretation results. The results of seismic attribution analysis, spectrum decomposition and post- stack seismic inversion forecast that hill pools reservoir are dist ributed in several bands along the north-northeast to northeast-east. Xing'anling Group shows that the potential reser voirs are mainly distributed along Bei 14 –Bei 40 and De (99-212) - Bei (16-1) and Budate Group distributed along Bei 14 –Bei 40 in northwestern direction and De (99-212) - Bei (16-1) in north eastern direction. At the same time, by analyzing the structure and the reservoir, and combining with other data, three models are built. The characteristics of reservoirs dist ribution are concl uded，and potent ional favorable exploration dire ctions are predi cted.