Experimental and numerical study on power consumptions in a double-tube-socket pneumatic conveying system

A new methodology is proposed in this paper to predict the lowest power consumption for a double-tube-socket (DTS) pneumatic conveying system. This methodology is established on both experimental work and numerical simulation. After parametric studies by numerical simulation, the desired conveying cases which have the lowest power consumption were obtained. Finally those cases were carried out in our experimental system. The measured power consumption was close to that predicted. In this paper the experimental work is discussed and the numerical simulation introduced. (c) 2010 Elsevier B.V. All rights reserved.

Effect of liquid bridge volume on the instability in small-Prandtl-number half zones

A perturbation method is used to examine the linear instability of thermocapillary convection in a liquid bridge of floating half-zone filled with a small Prandtl number fluid. The influence of liquid bridge volume on critical Marangoni number and flow features is analyzed. The neutral modes show that the instability is mainly caused by the bulk flow that is driven by the nonuniform thermocapillary forces acting on the free surface. The hydrodynamic instability is dominant in the case of small Prandtl number fluid and the first instability mode is a stationary bifurcation. The azimuthal wave number for the most dangerous mode depends on the liquid bridge volume, and is not always two as in the case of a cylindrical liquid bridge with aspect ratio near 0.6. Its value may be equal to unity when the liquid bridge is relatively slender.

Analytical Methods of Residual Strength in Injecting Water Pipeline

In this paper, common criterions about residual strength evaluation at home and abroad are generalized and seven methods are acquired, namely ASME-B31G, DM, Wes-2805-97, CVDA-84, Burdekin, Irwin and J integral methods. BP neural network are Combined with Genetic Algorithm (GA) named by modified BP-GA methods to successfully predict residual strength and critical pressure of injecting water, corrosion pipelines. Examples are shown that calculation results of every kind of method have great difference and calculating values of Wes-2805-97 criterion, ASME-B31G criterion, CVDA-84 criterion and Irwin fracture mechanics model are conservative and higher than, those of J integral methods while calculating values of Burdiken model and DM fracture mechanics model are dangerous and less than those of J integral methods and calculating values of modified BP-GA methods are close and moderate to those of J integral methods. Therefore modified BP-GA methods and J integral methods are considered better methods to calculate residual strength and critical pressure of injecting water corrosion pipelines

Statistical approach to bulk inclusion initialized damage in films

In experiments, we have found an abnormal relationship between probability of laser induced damage and number density of surface inclusion. From results of X-ray diffraction (XRD) and laser induced damage, we have drawn a conclusion that bulk inclusion plays a key role in damage process. Combining thermo-mechanical damage process and statistics of inclusion density distribution, we have deduced an equation which reflects the relationship between probability of laser induced damage, number density of inclusion, power density of laser pulse, and thickness of films. This model reveals that relationship between critical sizes of the dangerous inclusions (dangerous inclusions refer to the inclusions which can initialize film damage), embedded depth of inclusions, thermal diffusion length and tensile strength of films. This model develops the former work which is the statistics about surface inclusion. (c) 2006 Elsevier B.V. All rights reserved.

薄膜体内缺陷对损伤概率的影响

由实验中得到的激光损伤概率与表面杂质密度的关系出发，结合XRD测试和激光损伤测试的结果，得到体缺陷或杂质破坏起主导作用的损伤机理．将激光作用时杂质吸收的热学和力学过程与杂质分布的统计规律结合起来，得到了深埋于薄膜内部的杂质诱导薄膜损伤概率与杂质密度、激光功率密度以及薄膜厚度的关系．该模型认为能诱导薄膜破坏的杂质尺寸范围与杂质填埋深度有关，所以不同深度处能诱导薄膜损伤的杂质密度不一样，理论结果与实验结果符合得很好．该理论模型还可以很好地解释损伤形貌．

Microcystin accumulation in freshwater bivalves from Lake Taihu, China, and the potential risk to human consumption

The potential risk through ingestion of microcystins (MC) in contaminated mollusks has not been well studied. The present paper studied seasonal changes of MC content (determined by liquid chromatography-mass spectrometry) in various organs of three species of bivalves (Cristaria plicata, Hyriopsis cumingii, and Lamprotula leai) in Lake Taihu, China, where toxic cyanobacterial blooms occurred. Coinciding with peaks of seston MC (maximum, 5.7 mu g/L) and MC in cyanobacterial blooms (maximum, 0.534 mg/g), most organs showed sharp MC peaks during the summer, indicating both fast uptake and fast depuration by bivalves. Because hepatopancreas and intestine had considerably higher MC content than other organs, they are the most dangerous for human consumption. Both the present and previous studies show that the hepatopancreatic MC and total tissue MC often are correlated in various aquatic invertebrates. During the peak of the cyanobacterial blooms, C. plicata had higher hepatopancreatic MC content than the other bivalves, whereas H. cumingii had higher intestinal MC content than the other bivalves. Estimated daily intakes for humans from the consumption of whole tissues of the three bivalves were 0.48 to 0.94 mu g MC-LR equivalent/kg body weight (12- to 23.5-fold the tolerable daily intake value proposed by the World Health Organization), which indicates a high risk for humans consuming these bivalves.

Spatial analysis for spring bloom and nutrient limitation in Xiangxi bay of three Gorges Reservoir

The spatial and temporal dynamics of physical variables, inorganic nutrients and phytoplankton chlorophyll a were investigated in Xiangxi Bay from 23 Feb. to 28 Apr. every six days, including one daily sampling site and one bidaily sampling site. The concentrations of nutrient variables showed ranges of 0.02-3.20 mg/L for dissolved silicate (Si); 0.06-2.40 mg/L for DIN (NH4N + NO2N + NO3N); 0.03-0.56 mg/L for PO4P and 0.22-193.37 mu g/L for chlorophyll a, respectively. The concentration of chlorophyll a and inorganic nutrients were interpolated using GIS techniques. The results indicated that the spring bloom was occurred twice in space during the whole monitoring period (The first one: 26 Feb.-23 Mar.; the second one: 23 Mar.-28 Apr.). The concentration of DIN was always high in the mouth of Xiangxi Bay, and PO4P was high in the upstream of Xiangxi Bay during the whole bloom period. Si seems no obvious difference in space in the beginning of the spring bloom, but showed high heterogeneity in space and time with the development of spring bloom. By comparing the interpolated maps of chlorophyll a and inorganic variables, obvious consumptions of Si and DIN were found when the bloom status was serious. However, no obvious depletion of PO4P was found. Spatial regression analysis could explained most variation of Chl-a except at the begin of the first and second bloom. The result indicated that Si was the factor limiting Chl-a in space before achieved the max area of hypertrophic in the first and second bloom period. When Si was obviously exhausted, DIN became the factor limiting the Chl-a in space. Daily and bidaily monitoring of Site A and B, representing for high DIN: PO4P ratio and low DIN:PO4P ratio, indicated that the concentration of Si was decreased with times at both site A and B, and the dramatically drop of DIN was found in the end monitoring at site B. Multiple stepwise regression analysis indicated that Si was the most important factor affect the development of spring bloom both at site A and B in time series.

The status and causes of alien species invasion in China

Data of classification, origin, pathway and environmental impacts of invasive alien micro-organisms, invertebrates, amphibians and reptiles, fish, birds, mammals, weeds, trees, and marine organisms in terrestrial, aquatic and marine ecosystems of China, were analyzed, based on literature retrieval, field survey and consultation. Some 283 invasive alien species were recorded in China, including 19 invasive alien micro-organisms, 18 aquatic plants, 170 terrestrial plants, 25 aquatic invertebrates, 33 terrestrial invertebrates, 3 amphibians and reptiles, 10 fish, and 5 mammals. Of the invasive alien species, 55.1% originated from North and South America, 21.7% from Europe, 9.9% from Asia, 8.1% from Africa and 0.6% from Oceania. Many institutions and individuals in China lack adequate knowledge of ecological and environmental consequences caused by invasive alien species, with some ignorance of the dangerous invasion in the introduction of alien species. For instance, 50.0% of invasive alien plants were intentionally introduced as pasture, feedingstuff, ornamental plants, textile plants, medicinal plants, vegetables, or lawn plants, 25% of alien invasive animals were intentionally introduced for cultivation, ornament, or biological control, In addition, more efforts are being made in the introduction of alien species, and little attention is paid on the management of introduced alien species, which may cause their escape into natural environment and potential threats to the environment. There were also gaps in quarantine system in China. All microorganisms were unintentionally introduced, through timber, seedling, flowerpot, or soil; 76.3% of alien invasive animals invaded through commodity or transportation facility because of the failure of quarantine. Therefore, quarantine measures should be strictly implemented; and meanwhile the intentional introduction of alien species should be strictly managed and a system of risk assessment should be implemented.

Influence of thermal isolating grooves on the performance of the Mach-Zehnder interferometer-type thermo-optic variable optical attenuator

Two types of silicon-on-insulator thermo-optic variable optical attenuators (VOAs) based on a Mach-Zehnder interferometer and a multimode-interference coupler are fabricated, one with thermal isolating grooves to improve heating efficiency and the other without Comparison of optical and electrical properties, such as insertion losses, the maximum attenuation levels and the corresponding power consumptions, and the response times, is carried out between the two types of VOAs. The comparison results Indicate that use of thermal isolating grooves leads to better values for most characteristics and is an effective way to improve the performance of Mach-Zehnder interferometer-type thermo-optic devices. (c) 2005 Society of Photo-Optical Instrumentation Engineers.

危险弹药销毁用聚能引爆器设计

为解决炸药包殉爆销毁存在的诸多问题,适应新形势下部队训练保障要求,依据前人关于聚能装置设计经验和聚能效应原理,着重阐述了炸药、药型罩、炸高、外壳等重要参数设计原则及其选取依据,设计了一种用于危险弹药销毁的新型装置.为检验聚能引爆器侵彻引爆销毁危险弹药的能力,选取了5种典型弹药进行实弹销毁试验.试验结果表明:该装置能够引爆不同弹丸装药、不同弹体材料、不同弹丸壁厚的危险弹药,用于销毁危险弹药是可行的

NEW METHODOLOGY FOR THE ESTIMATION OF ENERGY CONSUMPTION IN A DOUBLE-TUBE-SOCKET (DTS (R)) PNEUMATIC CONVEYING

A new methodology based on the use of CFD is proposed to estimate the energy consumptions in a DTS (DOUBLE-TUBE-SOCKET) pneumatic conveying. A simple computational program based on this methodology is developed. It can directly give the lowest energy consumption and the compatible gas consumption by only input the distance of conveying and the conveying tonnage. This computational program has been validated through our experimental work.

Photo-sensitized oxidation in natural water via .OH radicals

A method is presented for determining production and consumption rates of .OH radicals produced photochemically in natural surface waters. It is based on the determination of the kinetics by which the concentration of a specified trace compound decreases during irradiation. In samples from Lake Greifensee (Switzerland) low production rates for .OH limit its possible effects. In addition, fast consumptions by the natural dissolved organic solutes and by the bicarbonate protect organic micropollutants from oxidation by .OH. Neither direct nor indirect H2O2 photolysis was a significant source of .OH in the lakewater studied lacking iron, whereas nitrate photolysis could have been a source. Comparison with reaction kinetic formulations allows generalizations for other types of waters.

渭北旱塬冬小麦水·肥·产量关系研究

探讨了不同供水条件下土壤水分与作物产量的关系。[方法]以冬小麦品种长旱58为试材,设肥力和水分2因子高、中、低3水平9个处理组合,通过试验资料分析了不同养分和水分条件下作物的产量响应。利用2006年9月~2007年7月的气象资料研究了冬小麦不同生育期耗水量。[结果]各生育期耗水量占全生育期总耗水量的百分比以孕穗灌浆期最大,达45.6%,其次为拔节期,约21.5%,越冬期最小,约8.4%。底墒对旱作作物产量具有重要影响,施肥量过量会影响农田水分循环过程,使得高产农田的产量随降水量的变化而波动。[结论]提高作物土壤耗水量和土壤底墒利用率是黄土高原旱地农业实现高产稳产的关键。

Antihyperlipidemic effects of different molecular weight sulfated polysaccharides from Ulva pertusa (Chlorophyta)

Ulvan, a sulfated polysaccharide from Ulva pertusa, was degraded to yield two low molecular weight fractions U1 and U2. The molecular weights of ulvan and its fractions were determined and varied from 151.6 to 28.2 kDa. They were fed to rats on a hypercholesterolemic diet for 21 days to evaluate and compare the antihyperlipidemic actions. Ulvan-based diet significantly lowered the levels of serum total cholesterol (-45.2%, P < 0.05) and low density lipoprotein cholesterol (LDL-cholesterol, -54.1%, P < 0.05). While U1- and U2-based diets significantly elevated the levels of serum high density lipoprotein cholesterol (HDL-cholesterol, +22.0% for U1, not significant; +61.0% for U2; P < 0.05) and reduced triglyceride (TG, -82.4% for U1, -77.7% for U2; P < 0.05) in rats as compared to control diet. In addition, consumptions of various ulvans significantly increased fecal bile acid excrement. The results indicated that ulvans with different molecular weights exhibited diverse effects on lipid metabolism. The high molecular weight ulvan was effective in serum total and LDL-cholesterol, whereas low molecular weight fractions were in TG and HDL-cholesterol. The fractions were considered to be more beneficial to hyperlipidemia associated with diabetes over ulvan. (C) 2003 Elsevier Ltd. All rights reserved.