Decomposition of emergent macrophyte roots and rhizomes in a northern prairie marsh

Dry mass, nitrogen and phosphorus content in belowground litter of four emergent macrophytes (Typha glauca Godr., Phragmites australis (Cav.) Trin., Scolochloa festucacea (Willd.) Link and Scirpus lacustris L.) were followed for 1.2 years in a series of experimental marshes, Delta Marsh, Manitoba. Litter bags containing roots and rhizome materials of each species were buried in unflooded soil, or soil flooded at three water depths (1–30, 31–60, > 60 cm). There were few differences in dry mass loss in unflooded or flooded soils, and depth of flooding also had little effect on decomposition rates. In the flooded sites, Scolochloa and Phragmites roots lost more mass (48.9–63.8% and 59.2–85.5%, respectively) after 112 days than Typha and Scirpus (36.3–43.6 and 37.0–47.2%, respectively). These differences continued through to the end of the study, except in the shallow sites where Scirpus roots lost more mass and had comparable mass remaining as Scolochloa and Phragmites. In the unflooded sites, there was little difference between species. All litters lost nitrogen (22.9–90.0%) and phosphorus (46.3–92.7%) during the first 112 days, then levels tended to remain constant. Decay rates for our belowground root and rhizome litters were comparable to published literature values for aboveground shoot litter of the same species, except for Phragmites roots and rhizomes which decomposed at a faster rate (−k = 0.0014−0.0032) than shoots (−k = 0.0003−0.0007, [van der Valk, A.G., Rhymer, J.M., Murkin, H.R., 1991. Flooding and the decomposition of litter of four emergent plant species in a prairie wetland. Wetlands 11, 1–16]).

Boundary Characterization Experiment Series Overview

Ocean acoustic propagation and reverberation in continental shelf regions is often controlled by the seabed and sea surface boundaries. A series of three multi-national and multi-disciplinary experiments was conducted between 2000-2002 to identify and measure key ocean boundary characteristics. The frequency range of interest was nominally 500-5000 Hz with the main focus on the seabed, which is generally considered as the boundary of greatest importance and least understood. Two of the experiments were conducted in the Mediterranean in the Strait of Sicily and one experiment in the North Atlantic with sites on the outer New Jersey Shelf (STRATAFORM area) and on the Scotian Shelf. Measurements included seabed reflection, seabed, surface, and biologic scattering, propagation, reverberation, and ambient noise along with supporting oceanographic, geologic, and geophysical data. This paper is primarily intended to provide an overview of the experiments and the strategies that linked the various measurements together, with detailed experiment results contained in various papers in this volume and other sources

Image Ratio Features for Facial Expression Recognition Application

Video-based facial expression recognition is a challenging problem in computer vision and human-computer interaction. To target this problem, texture features have been extracted and widely used, because they can capture image intensity changes raised by skin deformation. However, existing texture features encounter problems with albedo and lighting variations. To solve both problems, we propose a new texture feature called image ratio features. Compared with previously proposed texture features, e. g., high gradient component features, image ratio features are more robust to albedo and lighting variations. In addition, to further improve facial expression recognition accuracy based on image ratio features, we combine image ratio features with facial animation parameters (FAPs), which describe the geometric motions of facial feature points. The performance evaluation is based on the Carnegie Mellon University Cohn-Kanade database, our own database, and the Japanese Female Facial Expression database. Experimental results show that the proposed image ratio feature is more robust to albedo and lighting variations, and the combination of image ratio features and FAPs outperforms each feature alone. In addition, we study asymmetric facial expressions based on our own facial expression database and demonstrate the superior performance of our combined expression recognition system.

Defoliation, nitrogen, and competition: effects on plant growth and resource allocation of Cleistogenes squarrosa and Artemisia frigida

Two species, Artemisia frigida Willd. (C-3, semishrub, and dominant on overgrazed sites) and Cleistogenes squarrosa (Trin.) Keng (C-4, perennial bunchgrass, and dominant or codominant on moderately grazed sites) were studied to determine the effects of defoliation, nitrogen (N) availability, competition, and their interactions on growth, biomass, and N allocation in a greenhouse experiment. The main treatments were: two nitrogen levels (NO = 0 mg N pot(-1), N1 = 60 mg N pot(-1)), two defoliation intensities (removing 60% of total aboveground biomass and no defoliation), and three competitive replacement series (monocultures of each species and mixtures at 0.5:0.5). Our results were inconsistent with our hypothesis on the adaptive mechanisms of A. frigida regarding the interactive effects of herbivory, N, and competition in determining its dominant position on overgrazed sites. Cleistogenes squarrosa will be replaced by A. frigida on over-grazed sites, although C. squarrosa had higher tolerance to defoliation than did A. frigida. Total biomass and N yield and N-15 recovery of C. squarrosa in mixed culture were consistently lower than in monocultures, whereas those of A. frigida grown in mixtures were consistently higher than in monocultures, suggesting higher competitive ability of A. frigida. Our results suggest that interspecific competitive ability may be of equal or greater importance than herbivory tolerance in determining herbivore-induced species replacement in semi-arid Inner Mongolian steppe. In addition, the dominance of A. frigida on overgrazed sites has been attributed to its ability to shift plant-plant interactions through (lap colonization, root niche differentiation, and higher resistance to water stress.

大型反倾岩体变形破坏机制及稳定性分析———以金沙江宽谷坝址龙蟠边坡为例

A large number of catastrophic accidents were aroused by the instability and destruction of anti-dip rock masses in the worldwide engineering projects, such as hydropower station, mine, railways and so on. Problems in relation to deformation and failure about anti-dip rock slopes are significant for engineering geology research. This dissertation takes the Longpan slope in the Jinsha River as a case to study the deformation mechanism of large-scale anti-dip rock masses and the slope stability analysis method. The primary conclusions are as follows. The Dale Reach of Jinsha River, from Longpan to the debouchment of Chongjiang tributary, is located in the southeastern margin of the Qinghai-Tibet Plateau. Longpan slope is the right embankment of Dale dam, it is only 26 km to the Shigu and 18 km to Tiger Leaping Gorge. The areal geology tectonic structures here area are complicated and blurry. Base on the information of geophysical exploration (CSAMT and seismology) and engineering geological investigation, the perdue tectonic pattern of Dale Reach is put forward for the first time in this paper. Due to the reverse slip of Longpan fault and normal left-rotation of Baihanchang fault, the old faulted valley came into being. The thick riverbed sediments have layered characters of different components and corresponding causes, which attribute to the sedimentary environments according with the new tectonic movements such as periodic mountain uplifting in middle Pleistocene. Longpan slope consists of anti-dip alternate sandstone and slate stratums, and the deformable volume is 6.5×107m3 approximately. It was taken for an ancient landslide or toppling failure in the past so that Dale dam became a vexed question. Through the latest field surveying, displacement monitoring and rock masses deforming characters analyses, the geological mechanism is actually a deep-seated gravitational bending deformation. And then the discrete element method is used to simulate the deforming evolution process, the conclusion accords very well with the geo-mechanical patterns analyses. In addition strength reduction method based on DEM is introduced to evaluate the factor of safety of anti-dip rock slope, and in accordance with the expansion way of the shear yielding zones, the progressive shear failure mechanism of large-scale anti-dip rock masses is proposed for the first time. As an embankment or a close reservoir bank to the lower dam, the stability of Longpan slope especially whether or not resulting in sliding with high velocity and activating water waves is a key question for engineering design. In fact it is difficult to decide the unified slip surface of anti-dip rock slope for traditional methods. The author takes the shear yielding zones acquired form the discrete element strength reduction calculation as the potential sliding surface and then evaluates the change of excess pore pressure and factor of stability of the slope generated by rapid drawdown of ponded water. At the same time the dynamic response of the slope under seismic loading is simulated through DEM numerical modeling, the following results are obtained. Firstly the effective effect of seismic inertia force is resulting in accumulation of shear stresses. Secondly the discontinuous structures are crucial to wave transmission. Thirdly the ultimate dynamic response of slope system takes place at the initial period of seismic loading. Lastly but essentially the effect of earthquake load to bringing on deformation and failure of rock slope is the coupling effect of shear stresses and excess pore water pressure accumulation. In view of limitations in searching the critical slip surface of rock slope of the existing domestic and international software for limit equilibrium slope stability analyses, this article proposes a new method named GA-Sarma Algorithm for rock slope stability analyses. Just as its name implies, GA-Sarma Algorithm bases on Genetic Algorithm and Sarma method. GA-Sarma Algorithm assumes the morphology of slip surface to be a broken line with traceability to extend along the discontinuous surface structures, and the slice boundaries is consistent with rock mass discontinuities such as rock layers, faults, cracks, and so on. GA-Sarma Algorithm is revolutionary method that is suitable for global optimization of the critical slip surface for rock slopes. The topics and contents including in this dissertation are closely related to the difficulties in practice, the main conclusions have been authorized by the engineering design institute. The research work is very meaningful and useful for the engineering construction of Longpan hydropower station.