Experimental investigation of parallel optical data storage using pyrrylfulgide photochromic material

The optical storage characteristics of a new kind of organic photochromic material-pyrrylfulgide were experimentally investigated in the established parallel optical data storage system. Using the pyrrylfulgide/PMMA film as a photon-mode recording medium, micro-images and encoded binary digital data were recorded, readout and erased in this parallel system. The storage density currently reaches 3 x 10(7) bit/cm(2). The recorded information on the film can be kept for years in darkness at room temperature.

Fatigue-crack closure measurements on 2024-t3 sheet specimens

A computer-controlled procedure has been developed for automatic measurement of the crack opening stress S-op during fatigue tests. A crack opening displacement gauge (GOD meter) is used to obtain digital data on the load versus COD curves. Three methods for deriving S-op from the data sets are compared: (1) a slope method, (2) a tangent lines intersecting method, and (3) a tangent point method. The effect of the position of the COD meter with respect to the crack tip on S-op is studied in tests of 2024-T3 specimens. Results of crack growth and S-op are presented for CA loading with an overload, and with an overload followed by an underload.

Riboflavin sensitized photopolymer materials for holographic storage

Riboflavin is employed as the photosensitizer of a novel photopolyrner material for holographic recording, This material has a broad absorption spectrum range (More than 200nm) due to the addition of this dye. The experimental results show that our material has high diffraction efficiency and large refractive index modulation. The maximum diffraction efficiency of the photopolymer is about 56%. The digital data pages are stored in this medium and the reconstructed data page has a good fidelity, with the bit-error-ratio of about 1.8 X 10(-4). it is found that the photopolymer material is suitable for high-density volume holographic digital storage.

古龙咀周围海区沉积物粒度特征及海底地形变化

对古龙咀周围浅海区沉积物的粒度进行了测试与分析，结合相关的地质水文资料，探讨了海岸形态对沉积物粒度的影响。研究区表层沉积物平均粒径在海湾浅海区呈带状由岸向海变细，中等水深和岬角处分布着细粒区，向外海粒径相对变粗；除险岛湾砂质区外，分选差；偏态多数为正偏或近正态；整体峰形极窄，峰型多样。底质类型以粘土质粉砂和砂质粉砂为主，由东北经古龙咀岬角向西南形成S形粘土质粉砂分布带，险岛湾地区沉积物呈带状由砂逐渐过渡到粉砂。潮汐和波浪是本区沉积物输运的主要水动力，岬角的存在影响了沉积物粒度的分布。粒度趋势分析表明沉积物整体有向岬角汇聚的输运趋势。 对收集到基于1954年、1969年、1982年测量绘成的地形图水深数据进行数字化，结合2005年测量的水深数据，分别建立各时期DEM图，在此基础上分析研究区的地形特征。四个时期海底DEM呈现出大体一致的趋势，在险岛湾及白沙口海湾内为浅水区，水深值在-1～-4 m之间，深水区主要分布在南黄岛南端至古龙咀连线以南区域，呈扇形展布，水深由南黄岛两侧向中间逐渐加深，水深值在-10～ -17 m之间。从整体上看，研究区海底地形呈NW-SE方向逐渐加深。 将数字化后的水深数据统一校正到1956黄海高程系，分别建立DEM，运用GIS的栅格计算分析得出冲淤变化图。相关结果表明：1954～1969年研究区整体近岸为冲（险岛湾除外），离岸海域为淤；1969～1982年研究区总体处于弱淤积状态；1982-2005研究区海域近岸为淤，外海以弱冲刷状态为主。

Behavioural reaction of root vole (Microtus oeconomus pallas) males of different social ranks to familiar and novel odour of conspecific males

In this experiment, we tested the hypothesis that males of root voles (Microtus oeconomus Pallas) of different social ranks display different behavioural strategies. To document behavioural differences between social ranks, we investigated patterns in the behavioural responses to urine cues from familiar and novel individu in a choice maze. Ten pairs of male voles were efectively used in this experiment. All behaviour was recorded with OBSERVER 5.0. When experiment was finished, video tapes were transformed into digital data. Then all data were analyzed by SPSS. The results showed that the approach latency of subordinates was shorter for familiar odours than novel ones, dominant individuals preferentially entered the strange odourant box, subordinates preferred familiar odours over novel ones, subordinates spent more time visiting familiar odours compared to the novel odours, dominants preferred novel odours to familiar ones, subordinates approached familiar odours more frequently than novel ones and self-groomed more often in the familiar odourant box than in the novel box, and dominant and subordinate individuals showed significantly different countermarking behaviours to familiar and novel odours. In conclusion, the dominants and subordinates displayed different behaviour patterns when faced to familiar and novel conspecific males' urine cues. The data support our hypothesis that differences in social rank induce differences in behavioural patterns.

人工源频率域大地电磁法正反演研究

The CSAMT method is playing an important role in the exploration of geothermal and the pre-exploration in tunnel construction project recently. In order to instruct the interpretation technique for the field data, the forward method from ID to 3D and inversion method in ID and 2D are developed in this paper for the artificial source magnetotelluric in frequency domain. In general, the artificial source data are inverted only after the near field is corrected on the basis of the assumption of half-homogeneous space; however, this method is not suitable for the complex structure because the assumption is not valid any more. Recently the new idea about inversion scheme without near field correction is published in order to avoid the near field correction error. We try to discuss different inversion scheme in ID and 2D using the data without near field correction.The numerical integration method is used to do the forward modeling in ID CSAMT method o The infinite line source is used in the 2D finite-element forward modeling, where the near-field effect is occurred as in the CSAMT method because of using artificial source. The pseudo-delta function is used to modeling the source distribution, which reduces the singularity when solving the finite-element equations. The effect on the exploration area is discussed when anomalous body exists under the source or between the source and exploration area; A series of digital test show the 2D finite element method are correct, the results of modeling has important significant for CSAMT data interpretation. For 3D finite-element forward modeling, the finite-element equation is derived by Galerkin method and the divergence condition is add forcedly to the forward equation, the forward modeling result of the half homogeneous space model is correct.The new inversion idea without near field correction is followed to develop new inversion methods in ID and 2D in the paper. All of the inversion schemes use the data without near field correction, which avoid introducing errors caused by near field correction. The modified grid parameter method and the layer-by-layer inversion method are joined in the ID inversion scheme. The RRI method with artificial source are developed and finite-element inversion method are used in 2D inversion scheme. The inversion results using digital data and the field data are accordant to the model and the known geology data separately, which means the inversion without near field correction is accessible. The feasibility to invert the data only in exploration area is discussed when the anomalous body exists between the source and the exploration area.

Elimination of zero-order diffraction in digital holography

A simple method to suppress the zero-order diffraction in the reconstructed image of digital holography is presented. In this method, the Laplacian of a detected hologram is used instead of the hologram itself for numerical reconstruction by computing the discrete Fresnel integral. This method can significantly improve the image quality and give better resolution and higher accuracy of the reconstructed image. The main advantages of this method are its simplicity in experimental requirements and convenience in data processing. (C) 2002 Society of Photo-optical Instrumentation Engineers.

Analog-digital and digital-analog converters using single-electron and MOS transistors

This paper proposes two kinds of novel single-electron analog-digital conversion (ADC) and digital-analog conversion (DAC) circuits that consist of single-electron transistors (SETs) and metal-oxide-semiconductor (MOS) transistors. The SET/MOS hybrid ADC and DAC circuits possess the merits of the SET circuit and the MOS circuit. We obtain the SPICE macro-modeling code of the SET transistor by studying and fitting the characteristics of the SET with SPICE simulation and Monte Carlo simulation methods. The SPICE macro-modeling code is used for the simulation of the SET/MOS hybrid ADC and DAC circuits. We simulate the performances of the SET/MOS hybrid 3-b ADC and 2-b DAC circuits by using the H-SPICE simulator. The simulation results demonstrate that the hybrid circuits can perform analog-digital and digital-analog data conversion well at room temperature. The hybrid ADC and DAC circuits have advantages as-follows: 1) compared with conventional circuits, the architectures of the circuits are simpler; 2) compared with single electron transistor circuits, the circuits have much larger load capability; 3) the power dissipation of the circuits are lower than uW; 4) the data conversion rate of the circuits can exceed 100 MHz; and 5) the resolution of the ADC and DAC circuits can be increased by the pipeline architectures.

A direct digital frequency synthesizer with fourth-order phase domain Delta Sigma noise shaper and 12-bit current-steering DAC

This paper presents a direct digital frequency synthesizer (DDFS) with a 16-bit accumulator, a fourth-order phase domain single-stage Delta Sigma interpolator, and a 300-MS/s 12-bit current-steering DAC based on the Q(2) Random Walk switching scheme. The Delta Sigma interpolator is used to reduce the phase truncation error and the ROM size. The implemented fourth-order single-stage Delta Sigma noise shaper reduces the effective phase bits by four and reduces the ROM size by 16 times. The DDFS prototype is fabricated in a 0.35-mu m CMOS technology with active area of 1.11 mm(2) including a 12-bit DAC. The measured DDFS spurious-free dynamic range (SFDR) is greater than 78 dB using a reduced ROM with 8-bit phase, 12-bit amplitude resolution and a size of 0.09 mm(2). The total power consumption of the DDFS is 200)mW with a 3.3-V power supply.

A Compact Direct Digital Frequency Synthesizer for System-on-chip

A compact direct digital frequency synthesizer (DDFS) for system-on-chip (SoC) is developed in this paper. For smaller chip size and lower power consumption, the phase to sine mapping data is compressed by using sine symmetry technique, sine-phase difference technique, quad line approximation (QLA) technique and quantization and error read only memory (QE-ROM) technique. The ROM size is reduced by 98 % using the techniques mentioned above. A compact DDFS chip with 32-bit phase storage depth and a 10-bit on-chip digital to analog converter(DAC) has been successfully implemented using standard 0.35um CMOS process. The core area of the DDFS is 1.6mm(2). It consumes 167 mW at 3.3V, and its spurious free dynamic range (SFDR) is 61dB.

A Compact Direct Digital Frequency Synthesizer for the Rubidium Atomic Frequency Standard

A compact direct digital frequency synthesizer （DDFS） for system-on-chip implementation of the high precision rubidium atomic frequency standard is developed. For small chip size and low power consumption, the phase to sine mapping data is compressed using sine symmetry technique, sine-phase difference technique, quad line approximation technique,and quantization and error read only memory （QE-ROM） technique. The ROM size is reduced by 98% using these techniques. A compact DDFS chip with 32bit phase storage depth and a 10bit on-chip digital to analog converter has been successfully implemented using a standard 0.35μm CMOS process. The core area of the DDFS is 1.6mm^2. It consumes 167mW at 3.3V,and its spurious free dynamic range is 61dB.

Application of digital image analysis to the study of banded spherulite during growing and melting process

A digital image analysis(DIA) technique can be applied directly to the image obtained by polarizing microscope. The time-resolved DIA apparatus including image collecting, showing and data analysis has been home-made. As an example, it has been used to study the banded spherulite in the blends of poly(epsilon-caprolactone) (PCL) and poly(styrene-ran-acrylonitrile) (SAN).