AlGaInAs narrow stripe selective growth on substrates patterned with different mask designs

We have performed a narrow stripe selective growth of oxide-free A1GaInAs waveguides on InP substrates patterned with pairs of SiO2 mask stripes under optimized growth conditions. The mask stripe width varied from 0 to 40 mu m, while the window region width between a pair of mask stripes was fixed at 1.5, 2.5 or 3.5 mu m. Flat and smooth A1GaInAs waveguides covered by specific InP layers are successfully grown on substrates patterned with different mask designs. The thickness enhancement ratio and the photoluminescence (PL) spectrum of the A1GaInAs narrow stripe waveguides are strongly dependent on the mask stripe width and the window region width. In particular, a large PL wavelength shift of 79 nm and a PL FWHM of less than 64 meV are obtained simultaneously with a small mask stripe width varying from 0 to 40 mu m when the window region width is 1.5 mu m. We present some possible interpretations of the experimental observations in considering both the migration effect from a masked region and the lateral vapour diffusion effect.

An adaptive controller for a class of nonlinear system using direction basis function

For a class of nonlinear dynamical systems, the adaptive controllers are investigated using direction basis function (DBF) in this paper. Based on the criterion of Lyapunov' stability, DBF is designed which guarantees that the output of the controlled system asymptotically tracks the reference signals. Finally, the simulation shows the good tracking effectiveness of the adaptive controller.

Quantum well controller

A quantum well controller (QWC) consisting of a direct-gap/indirect-gap quantum well and a doping interface is proposed to control the dynamic operation of the Gunn active layer. Through the Monte Carlo simulation a new relaxation mode for this new device is found. The oscillation and amplification behavior of the Gunn active layer under the control of the QWC is investigated theoretically and experimentally. All work demonstrates the great control capacity of the QWC and provides a new way to improve the performance of semiconductor devices. A new oscillation diode made of the QWC and a Gunn active layer has been designed and fabricated. In the 8 mm band the highest pulse output power of these diodes is 2.55 W and the highest conversion efficiency is 18%.

HIRFL-CSR前端总线控制器的SD驱动

The HIRFL-CSR EVME bus controller, which runs Embedded Linux OS, is based on AT91RM9200 microprocessor, whose core is ARM920T. There are hardware interface electronic circuits connecting AT91RM9200 microprocessor and Security Digital Memory Card (SD Card). This article analyzes Operation System kernel and Linux device driver’s structure, designs SD Card driver based on Embedded Linux, which runs on AT91RM9200 microprocessor.中文文摘：简要论述了用于兰州重离子加速器冷却储存环(HIRFL-CSR)控制系统的前端总线控制器。该控制器是基于ARM920T核心的AT91RM9200处理器,运行嵌入式Linux操作系统。描述了AT91RM9200处理器与Security Digital MemoryCard(SD卡)的硬件接口电路,分析了操作系统内核和Linux驱动程序结构,设计和实现了嵌入式Linux下基于AT91RM9200处理器的SD卡驱动程序。

同步加速器高频系统前端控制器改进设计；Improvement Design of RF Front-end Controller for Synchrotron RF System

介绍了在CSR同步加速器高频控制系统改进项目中,高频前端控制器的改进设计。根据系统改进的具体要求,采用DSP+FPGA双电路板的体系结构,对高频前端控制器各个部分做了详细的设计,并给出了具体的资源消耗结果和设计图。

CSRe团簇内靶温度闭环控制器设计；Design of Closed Loop Temperature Controller for CSRe Internal Target System

介绍了国家重大科学工程项目——兰州重离子加速器冷却存储环(HIRFL-CSR)的实验环(CSRe)团簇内靶温度闭环控制器的设计。该控制器给气体喷嘴处测温电阻提供长时间稳定度为0.1%的1mA恒定电流,通过12位ADC得到喷嘴温度,并通过混合信号处理器MSP430F149来实现制冷/加热闭环操作。在多种不同实验气体的情况下,该控制器的温度控制精度小于0.5K。目前,该控制器在现场工作良好。

The Application of Toolkit of Optimization in Designs of Accelerator Magnets

The traditional design of accelerator magnet usually involves many time consuming iterations of the manual analysis process. A software platform to do these iterations automatically is proposed in this paper. In this platform, we use DAKOTA (a open source software developed by Sandia National Laboratories) as the optimizing routine, which provides a variety of optimization methods and algorithms, and OPERA (software from Vector Fields) is selected as the electromagnetic simulating routine. In this paper, two examples of designs of accelerator magnets are used to illustrate how an optimization algorithm is chosen and the platform works.

仿人机器人系统的研究与实现

针对仿人机器人的结构和控制性能的要求,设计开发了机器人的关节控制器,并利用CAN总线把各个关节和力传感器及上位机连接在一起,构成了有效可靠的分布式控制系统;利用无线局域网技术,实现了语音、视频等多媒体信息的传输,构成了仿人机器人完整的控制系统。最后提出了一些设想以提高系统的性能。

基于CAN的仿人机器人控制器的设计与实现

本文针对仿人机器人的结构和控制性能的要求,设计并实现了基于CAN的关节控制器,并利用CAN把各个关节和力传感器及上位机连接在一起,构成了有效可靠的控制系统。主要包括仿人机器人的总体结构、控制器的硬件与软件的设计实现、控制系统的拓扑结构等,并提出了一些设想以提高系统的性能。

Optimal Fuzzy PID Controller with Incomplete Derivation and Its Simulation Research on Application of Intelligent Artificial Legs

提出了一种新的最优模糊PID控制器，它由两部分组成，即在线模糊推理机构和带有不完全微分的常规PID控制器，在模糊推理机构中，引入了三个可调节因子xp,xi和xd，其作用是进一步修改和优化模糊推理的结果，以使控制器对一个给定对象具有最优的控制效果，可调节因子的最优值采用ITAE准则及Nelder和Mead提出的柔性多面体最优搜索算法加以确定，这种PID控制器被用来控制由作者设计的智能人工腿中的一个直流电机，仿真结果表明该控制器的设计是非常有效的，它可被用于控制各种不同的对象和过程。