Novel Mechanical Behavior Of Zno Nanorods

A novel stress-strain relation with two stages of linear elastic deformation is observed in [0 0 0 1]-oriented ZnO nanorods under uniaxial tensile loading. This phenomenon results from a phase transformation from wurtzite (WZ, P6(3)mc space group) to a body-centered tetragonal structure with four-atom rings (denoted as BCT-4) belonging to the P4(2)/mnm space group. The analysis here focuses on the effects of nanorod size and temperature on the phase transformation and the associated mechanical behavior. It is found that as size is increased from 19.5 to 45.5 angstrom, the critical stress for nucleation of the transformation decreases by 25% from 21.90 to 16.50 GPa and the elastic moduli of the WZ- and BCT-4-structured nanorods decrease by 24% (from 299.49 to 227.51 GPa) and 38% (from 269.29 to 166.86 GPa), respectively. A significant temperature effect is also observed, with the critical stress for transformation initiation decreasing 87.8% from 17.89 to 2.19 GPa as temperature increases from 300 to 1500 K. (c) 2007 Elsevier B.V. All rights reserved.

Formation of X-waves at fundamental and harmonics by infrared femtosecond pulse filamentation in air

We experimentally observe the formation of X-waves at fundamental, third harmonic, and fifth harmonic wavelengths by infrared (central wavelength at similar to 1500 nm) femtosecond laser pulse filamentation in air. By fitting the angularly resolved spectra of the fundamental and harmonic waves using X-wave relations, we confirm that all the X-waves have nearly the same group velocity, indicating that they are locked in space and time during their propagation in filament.

First report of the cyanotoxins cylindrospermopsin and deoxycylindrospermopsin from Raphidiopsis curvata (Cyantobacteria)

A strain of Raphidiopsis (Cyanobacteria) isolated from a fish pond in Wuhan, P. R. China was examined for its taxonomy and production of the alkaloidal hepatotoxins cylindrospermopsin (CYN) and deoxy-cylindrospermopsin (deoxy-CYN). Strain HB1 was identified as R. curvata Fritsch et Rich based on morphological examination of the laboratory culture. HB1 produced mainly deoxy-CYN at a concentration of 1.3 mg(.)g(-1) (dry ut cells) by HPLC and HPLC-MS/MS. CYN was also detected in trace amounts (0.56 mug(.)g(-1)). A mouse bioassay did not show lethal toxicity when tested at doses up to 1500 mg dry weight cells(.)kg(-1) body weight within 96 h, demonstrating that production of primarily deoxy CYN does not lead to significant mouse toxicity by strain BB I. The presence of deoxy-CYN and CYN in R curvata suggests that Raphidiopsis belongs to the Nostocaceae, but this requires confirmation by molecular systematic studies. Production of these cyanotoxins by Raphidiopsis adds another genus, in addition to Cylindrospemopsis, Aphanizomenon, and Umezakia, now known to produce this group of hepatotoxic cyanotoxins. This is also the first report from China of a CYN and deoxy-CYN producing cyanobacterium.

practical type checking of functions defined on context-free languages

A type checking method for the functional language LFC is presented. A distinct feature of LFC is that it uses Context-Free (CF) languages as data types to represent compound data structures. This makes LFC a dynamically typed language. To improve efficiency, a practical type checking method is presented, which consists of both static and dynamic type checking. Although the inclusion relation of CF.languages is not decidable,a special subset of the relation is decidable, i.e., the sentential form relation, which can be statically checked.Moreover, most of the expressions in actual LFC programs appear to satisfy this relation according to the statistic data of experiments. So, despite that the static type checking is not complete, it undertakes most of the type checking task. Consequently the run-time efficiency is effectively improved. Another feature of the type checking is that it converts the expressions with implicit structures to structured representation. Structure reconstruction technique is presented.

Design and operation of integrated pilot-scale dimethyl ether synthesis system via pyrolysis/gasification of corncob

The integrated pilot-scale dimethyl ether (DME) synthesis system from corncob was demonstrated for modernizing utilization of biomass residues. The raw bio-syngas was obtained by the pyrolyzer/gasifier at the yield rate of 40-45 Nm(3)/h. The content of tar in the raw bio-syngas was decreased to less than 20 mg/Nm(3) by high temperature gasification of the pyrolysates under O-2-rich air. More than 70% CO2 in the raw bio-syngas was removed by pressure-swing adsorption unit (PSA). The bio-syngas (H-2/CO approximate to 1) was catalytically converted to DME in the fixed-bed tubular reactor directly over Cu/Zn/Al/HZSM-5 catalysts. CO conversion and space-time yield of DME were in the range of 82.0-73.6% and 124.3-203.8 kg/m(cat)(3)/h, respectively, with a similar DME selectivity when gas hourly space velocity (GHSV, volumetric flow rate of syngas at STP divided by the volume of catalyst) increased from 650 h(-1) to 1500 h(-1) at 260 degrees C and 4.3 MPa. And the selectivity to methanol and C-2(+) products was less than 0.65% under typical synthesis condition. The thermal energy conversion efficiency was ca. 32.0% and about 16.4% carbon in dried corncob was essentially converted to DME with the production cost of ca. (sic) 3737/ton DME. Cu (111) was assumed to be the active phase for DME synthesis, confirmed by X-ray diffraction (XRD) characterization.

P wave velocity of the pumice from the Okinawa Trough at high temperature and high pressure.

P wave velocity of the pumice sample from the middle Okinawa Trough and andesite sample from vicinity Yingdao volcanic island, Kyushu Japan were measured at temperature (from room temperature to 1500 C) and pressure (from room pressure to 2.4GPa) using a multi-anvil pressure apparatus called the YJ-3000 press. The measured data shows that at low temperature and low pressure (<1GPa, <800degreesC), the P wave velocity of pumice is lower than that of andesite, while at high temperature and high pressure (>1GPa, >800degreesC) the P wave velocity of pumice and andesite. becomes consistent (5.9km/s). The paper points out that 1GPa/800degreesC is the point of thermodynamic phase transformation Okinawa Trough pumice and vicinity andesite, and the point is deeper than 18km.

On the western boundary currents in the Philippine Sea

In this study we describe the velocity structure and transport of the North Equatorial Current (NEC), the Kuroshio, and the Mindanao Current (MC) using repeated hydrographic sections near the Philippine coast. A most striking feature of the current system in the region is the undercurrent structure below the surface flow. Both the Luzon Undercurrent and the Mindanao Undercurrent appear to be permanent phenomena. The present data set also provides an estimate of the mean circulation diagram (relative to 1500 dbar) that involves a NEC transport of 41 Sverdrups (Sv), a Kuroshio transport of 14 Sv, and a MC transport of 27 Sv, inducing a mass balance better than 1 Sv within the region enclosed by stations. The circulation diagram is insensitive to vertical displacements of the reference level within the depth range between 1500 and 2500 dbar. Transport fluctuations are, in general, consistent with earlier observations; that is, the NEC and the Kuroshio vary in the same phase with a seasonal signal superimposed with interannual variations, and the transport of the MC is dominated by a quasi-biennial oscillation. Dynamic height distributions are also examined to explore the dynamics of the current system.

Organochlorine micropollutants in the Jiulong River Estuary and Western Xiamen Sea, China

Organochlorine contaminants including 12 polychlorinated biphenyl (PCB) congeners and 18 insecticides were determined in water, pore water and sediments of the Jiulong River Estuary and Western Xiamen Sea, China. The results showed that the levels of the total PCBs ranged from non-detectable to 1500 ngl(-1) in water, from 209 to 3870 ngl(-1) in pore water, and from 2.78 to 14.8 ng g(-1) dry weight in sediments. Total organochlorine insecticide concentrations were from below the limit of detection to 2480 ngl(-1) in water, from 267 to 33400 ngl(-1) in pore water, and from 4.22 to 46.3 ng g(-1) dry weight in sediments. Concentrations of PCBs and insecticides in pore water were significantly higher than those in surface water, due to the high affinity of these hydrophobic compounds for sediment phase. The PCB congeners with the highest concentrations were CB153, CB180 and CB194, which together accounted for 68-87% of total PCBs in water, pore water and sediment. Among the hexachlorocyclohexane (HCH) compounds, beta-HCH was found to be a major isomer. Analysis of 1,1,1-trichloro-2,2-bis-chlorophenyl-ethane (DDT) and its metabolites showed that 1, 1-dichloro-2[o-chlorophenyl]-2[p-chlorophenyl]-ethylene (DDE) was dominant in the group. In comparison to a 1998 study in the Western Xiamen Sea, levels of organochlorines were enhanced due probably to recent inputs and changes in sediments. (c) 2004 Elsevier Ltd. All rights reserved.

combining cfg and recursive functions to get a new language

We propose a new functional programming language(FPL) which differs in some aspects from most well known FPLs[l].We descrihc the prohlmm domain,the language,explain why we need it.