Influence of dew on biomass and photosystem II activity of cyanobacterial crusts in the Hopq Desert, northwest China

Dew is an important water source for desert organisms in semiarid and arid regions. Both field and laboratory experiments were conducted to investigate the possible roles of dew in growth of biomass and photosynthetic activity within cyanobacterial crust. The cyanobacteria, Microcoleus vaginatus Gom. and Scytonema javanicum (Kutz.) Born et Flah., were begun with stock cultures and sequential mass cultivations, and then the field experiment was performed by inoculating the inocula onto shifting sand for forming cyanobacterial crust during late summer and autumn of 2007 in Hopq Desert, northwest China. Measurements of dew amount and Chlorophyll a content were carried out in order to evaluate the changes in crust biomass following dew. Also, we determined the activity of photosystem II(PSII) within the crust in the laboratory by simulating the desiccation/rehydration process due to dew. Results showed that the average daily dew amount as measured by the cloth-plate method (CPM) was 0.154 mm during fifty-three days and that the crust biomass fluctuated from initial inoculation of 4.3 mu g Chlorophyll a cm(-2) sand to 5.8-7.3 mu g Chlorophyll a cm(-2) crust when dew acted as the sole water source, and reached a peak value of approximately 8.2 mu g Chlorophyll a cm(-2) crust owing to rainfalls. It indicated that there was a highly significant correlation between dew amounts and crust moistures (r = 0.897 or r = 0.882, all P < 0.0001), but not a significant correlation between dew and the biomass (r = 0.246 or r = 0.257, all P > 0.05), and thus concluded that dew might only play a relatively limited role in regulating the crust biomass. Correspondingly, we found that rains significantly facilitated biomass increase of the cyanobacterial crust. Results from the simulative experiment upon rehydration showed that approximately 80% of PSII activity could be achieved within about 50 min after rehydration in the dark and at 5 degrees C, and only about 20% of the activity was light-temperature dependent. This might mean that dew was crucial for cyanobacterial crust to rapidly activate photosynthetic activity during desiccation and rehydration despite low temperatures and weak light before dawn. It also showed in this study that the cyanobacterial crusts could receive and retain more dew than sand, which depended on microclimatic characteristics and soil properties of the crusts. It may be necessary for us to fully understanding the influence of dew on regulating the growth and activity of cyanobacterial crust, and to soundly evaluate the crust's potential application in fighting desertification because of the available water due to dew. (C) 2009 Published by Elsevier Ltd.

Structural characterization of stable amorphous silicon films

A kind of hydrogenated diphasic, silicon films has been prepared by a new regime of plasma enhanced chemical vapor deposition (PECVD) in the region adjacent to the phase transition from amorphous to crystalline state. The photoelectronic and microstructural properties of the films have been investigated by the constant photocurrent method (CPM), Raman scattering and nuclear magnetic resonance (NMR). Our experimental results and corresponding analyses showed that the diphasic films, incorporated with a subtle boron compensation, could gain both the fine photosensitivity and high stability, provided the crystalline fraction (f) was controlled in the range of 0 < f < 0.3. When compared with the conventional hydrogenated amorphous silicon (a-Si:H), the diphasic films are more ordered and robust in the microstructure, and have a less clustered phase in the Si-H bond configurations. (C) 2002 Elsevier Science Ltd. All rights reserved.

一种基于模型融合的CMM实施过程建模方法

提出了一种基于模型融合的CMM实施过程建模方法.该方法使用软件过程工程元模型SPEM建立CMM过程模型CPM和企业过程模型EPM,通过融合CPM和EPM来获得CMM实施过程模型C IPM.文中利用带标记的有向图描述过程模型,给出了模型融合方法,并进行了一致性证明.最后通过一个过程模型融合原型工具和实例说明了方法的应用情况.

Characterization of diphasic nc-Si/a-Si : H thin films and solar cells

Hydrogenated silicon films with diphasic structure have been prepared by using a new regime of plasma enhanced chemical vapor deposition (PECVD) in the region adjacent to the phase transition from amorphous to crystal. line state. The photoelectronic and microstructural properties of the films have been characterized by the constant photocurrent method (CPM), Raman scattering and nuclear magnetic resonance (NMR). In comparison with typical hydrogenated amorphous silicon (a-Si:H), these diphasic films with a crystalline fraction less than 0.3 show a similar optical absorption coefficient, lower deep-defect densities and higher stability upon light soaking. By using the diphasic nc-Si/a-Si films a p-i-n junction solar cell has been prepared With an initial efficiency of 8.51 % and a stabilized efficiency of 8.02 % on an area of 0.126 cm(2) (AM1.5, 100 mW/cm(2)).

CSR控制系统—前端现场服务器系统的COM控制组件库

HIRFL-CSR（童话垂离子冷却储存环）是国家重点实验室之一。CSR控制系统是保证CSR正常运行的重要环节。作为这样一个大型的控制系统，是由多个子系统分别组成的。在CSR新的控制方案中，我们允许用户通过访问网页来控制设备和获知设备的当前运行情况。本文主要描述了三个子系统中设备控制的实现和设备监控程序的实现，分别采用了COM组件技术和Win32应用程序。本文首先介绍了Windows编程，win32应用程序，开发COM组件工具ATL，和COM组件的基本概念。随后详细介绍了在实现设备控制和设备监控程序中所应用的各种技术，包括：多线程的实现、川州访问远立湍数据库、串日通信的实现，对硬件板卡的访问。其次，还介绍了各个子系统控制软件的结构和总体设计，包括了被控设务的COM组件的设计，监控程序的设计和功能实现方案。主要以电子冷却控制系统为例，详细介绍了分别用于控制常压端和高压端设备的COM组件功能实现和常压端监控程序、高压端监控程序功能的实现。整个论文的工作完成了CSR控制系统中子系统的CPM组件和设备监控程序的软件编制，调试。为以后开发和实现控制系统的COM组件和设备监控程序提供了一个原型。

一些含半夹心结构ⅥB族金属的1,1’-二硫(硒)二茂铁化合物的合成

CpCr(NO)(CO)_2与Fe(C_5H_4S)_2S反应,形成氧化-还原产物CpCr(NO)(SC_5H_4)_2Fe(1)。双杂核二茂铁化合物CpM(NO)(EC_5H_4)_2Fe[M=Mo,E=S(2a),Se(2b);M=W,E=S(4a),Se(4b)]、CpMo(NO)(SC_5H_4)_2Fe(3)、Cp_2Mo(SeC_5H_4)_2Fe(6)和Cp_2W(SC_5H_4)_2Fe(7)可通过Fe(C_5H_4ELi)_2·2THF(E=S,Se)与CpM(NO)I_2(M=Mo,W)、[CpMo(NO)I_2]_2或Cp_2MCl_2(M=Mo,W)反应制得。三核杂原子二茂铁化合物[CpCr(NO)_2]_2(EC_5H_4)_2Fe[E=S(8a),Se(8b)],由Fe(C_5H_4ELi)_2·2THF(E=S,Se)与二倍摩尔量的CpCr(NO)_2I反应制备。通过AgBF_4氧化2a得到二茂铁离子型化合物[CpMo(NO)(SC_5H_4)_2Fe]~+BF_4~-(5)。采用元素分析、红外光谱、~1H和~(13)C NMR谱以及EI-MS表征了所合成的新型化合物。

Half-sandwich metal diselenolate complexes Cp#M(NO)(SePh)(2) (M = Mo or W; Cp# = Cp or MeCp) as ligands. Synthesis of selenolate-bridged heterobimetallic compounds

The reactions of half-sandwich diselenolate Mo and W complexes (CpM)-M-#(NO)(SePh)(2) (M = Mo; Cp-# = Cp' (1a), MeCp (1b); M = W; Cp-# = Cp' (1c)) with (Norb)Mo(CO)(4), Ni(COD)(2) and Fe(CO)(5) have been investigated. Treatment of (1a), (1b) and (1c) with (Norb)Mo(CO)(4) in PhMe gave the bimetallic complexes: Cp'Mo(NO)(mu -SePh)(2)Mo(CO)(4) (2a), MeCpMo(NO)(mu -SePh)(2)Mo(CO)(4) (2b) and Cp'W(NO)(mu -SePh)(2)Mo(CO)(4) (2c) in moderate yields. Irradiation of (1a) and (1c) in the presence of Fe(CO)(5) gave heterobimetallic complexes Cp'Mo(CO)(mu -SePh)(2)Fe(CO)(3) (3a) and Cp'W(NO)(mu -SePh)(2)Fe(CO)(3) (3c). Ni(COD)(2) reacts with two equivalents of (1a), (1b) and (1c) to give [Cp'Mo(NO)(mu -SePh)(2)](2)Ni (4a), [MeCpMo(NO)(mu -SePh)(2)](2)Ni (4b) and [Cp'W(NO)(mu -SePh)(2)](2)Ni (4c) in good yields. The new heterobimetallic complexes were characterized by i.r., H-1-n.m.r., C-13-n.m.r. and EI-MS spectroscopy.

可重构装配系统开放式组织结构的研究

为了克服传统装配线的不足,在基于功能对象的产品族建模基础上,提出了主干线和装配模块相结合的可重构装配系统开放式组织结构。这种分形相似的组织结构具有能力柔性、鲁棒性、功能扩展能力等特点,并能通过模块的局部调整快速响应市场的需求。利用网络法,针对鲁棒性和增容性问题,提出了相应的重构优化算法。