Response amplitude and hydrodynamic force for a buoy over a convex

A buoy as an offshore structure is often placed over a convex such as a caisson or a submerged island. The hydrodynamic fluid/solid interaction becomes more complex due to the convex compared with that on the flat. Both the buoy and the convex are idealized as vertical cylinders. Linear potential theory is used to investigate the response amplitude and the hydrodynamic force for a buoy over a convex due to diffraction and radiation in water of finite depth. These are derived from the total velocity potential. A set of theoretical added mass, damping coefficient, and exciting force expressions have been proposed. Analytical results of the response amplitude and hydrodynamic force are given. Finally, the numerical results show that the effect of the convex on the response amplitude and hydrodynamic force for the buoy is ignored if the size of the convex is relatively smaller.

A QUASI-SIMPLEX METHOD FOR STRICTLY CONVEX QUADRATIC PROGRAMMING

本文提出一个不用 Kuhn- Tucker条件而直接搜索严格凸二次规划最优目标点的鲁棒方法 .在搜索过程中 ,目标点沿约束多面体边界上的一条折线移动 .这种移动目标点的思想可以被认为是线性规划单纯形法的自然推广 ,在单纯形法中 ,目标点从一个顶点移到另一个顶点。

Extremum principle of crystal plasticity

An analytical method for determining slip shear rate under prescribed stress rate or prescribed strain rate has been presented on the basis of the incremental theory of crystal plasticity. The problem has been reduced to a quadric convex programming.In order to analyse the plastic response of crystals subjected to external load, two new extremum principles are proposed. They are equivalent to the boundary-value problem of crystal plasticity. By the new extremum principles, the slip shear rates are independent function which can be obtained from the variational equation.

透镜自重变形引起波像差的有限元分析

在用大口径、长焦距平行光管模拟激光远场特性时，其光组透镜在重力作用下的变形不能忽略，为了分析对出射光束质量的影响，采用有限元分析软件“ANSYS”建立了平行光管光组中声400mm平凸透镜的有限元模型，给出一种分析透镜轴向变形引起的波像差的方法，在不同工况下，计算了平凸透镜在重力作用下轴向变形的峰谷值和均方根值，对轴向变形量均方根值最小工况画出了透镜表面变形的等值线图，计算了声350mm通光口径内的波像差峰谷值和均方根值，对平行光管光组的波像差做出估计，验证了设计的合理性。

利用石英晶体平凸透镜实现激光束的空间整形

基于石英晶体的旋光特性，我们提出利用石英晶体平凸透镜和偏振片来实现线偏振光的空间强度整形，通过控制入射光的偏振方向可以方便地改变输出激光的空间强度分布。

Offner展宽器曲面镜误差对输出脉冲对比度的影响

在ffner展宽器的设计研究中,对曲面镜曲率半径的误差研究非常重要,它直接影响输出脉冲的质量。因此有必要分析ffner展宽器中曲面镜曲率半径的误差对输出脉冲对比度的影响。参考ffner展宽器的光线追迹模型,建立了ffner展宽器中曲面镜曲率半径存在误差时的光线追迹模型;根据建立的模型,详细分析了曲面镜曲率半径的误差对输出脉冲质量的影响;发现在目前曲面镜曲率半径的加工误差在0.2%~0.5%的情况下,完全可以满足神光II拍瓦激光装置中对展宽器的要求;同时发现如果曲面镜曲率半径存在误差时,应该尽量使两曲面镜之间的距离保持为凹面反射镜曲率半径的一半,而不是使两曲面镜保持同心。

机载测深激光雷达千赫兹全固态激光器设计及特性研究

将千赫兹高功率全固态Nd：YAG激光器的增益介质当作厚透镜处理，使用矩阵的方法对等效热透镜腔进行分析。采用多条半导体激光列阵侧向紧凑抽运结构设计，提高了增益介质光抽运的均匀性。根据实际抽运功率，通过模拟计算，设计了平凸非稳腔。选择的凸面全反镜的最佳曲率半径有效地补偿了增益介质热透镜效应，激光器实现了动态稳腔运转，激光脉冲能量输出斜度效率大于13％，光束发散角优于1.3mrad。

Yb：Ca5（PO4）3F激光晶体的生长缺陷

采用提拉法生长了质量优异的Yb：Ca5（PO4）2F（Yb：FAP）晶体。运用化学腐蚀，光学显微镜、扫描电子显微镜以及能量散射光谱仪观察了该晶体中的生长条纹和包裹物等宏观缺陷，以及晶体的位错腐蚀形貌、位错密度及其分布情况，同时观察了晶体中亚晶界的形态。由晶体中位错的径向变化以及生长条纹可知：晶体在生长过程中为微凸界面生长。高温下CaF2的挥发造成了在晶体生长后期熔体中组分偏离化学计量比，出现组分过冷，形成包裹物。且位错密度显著增加。Yb：FAP晶体的各向异性使得晶体在（10 10）面的位错蚀坑形状、大小以

铝酸钇晶体中的生长小面

采用提拉法生长了掺Ce、掺Yb和掺Mn的铝酸钇(YAlO3,YAP)晶体,晶体均完整透明,无肉眼可见的气泡、散射和包裹物等宏观缺陷。通过化学腐蚀和同步辐射白光形貌实验检测了YAP晶体中的生长小面缺陷。结果表明:晶体生长过程中,由于凸向熔体的固-液界面,造成了小面生长现象。沿[101]方向生长的YAP晶体中出现的小面为(102),(201),(121)和(121)奇异面。X射线摇摆曲线表征的结果表明:生长小面的存在严重破坏了晶体的微观结构完整性和均匀性,并导致了小角度晶界缺陷的产生。

Balitora nantingensis (Teleostei : Balitoridae), a new hillstream loach from Salween drainage in Yunnan, Southwestern China

A new species of hillstream loach genus Balitora Gray is discovered from Nanting River drainage, which drains to Salween, Yongde County, Yunnan, China. Balitora nantingensis can be distinguished from B. lancangjiangensis by a triangle-like blotch in nape absent vs. present; area from halfway of pelvicfin ray to anus covered by scales vs. no scales in this area; the first pectoral ray thickened vs. not; posterior end of pelvic-fin surpasses middle point from posterior end of pelvic-fin base to anal-fin origin vs. the end from posterior extremity of pelvic-fins to anus; fewer lateral line scales, 59-64 vs. 66-70; slightly longer head, SL 4.2-5.1 (4.6) times of HL vs. 5.0-5.9 (5.4); slightly larger eyes, HL 4.0-6.4 (5. 1) times of eye diameter vs. 5.5-7.5 (6.3). Balitora nantingensis can be distinguished from B. burmanica by body rounded vs. slender in dorsal view; pointed snout vs. blunt in dorsal view; a deeper body, body depth 12.5-16.9% of SL vs. 10-12%; a deeper caudal-peduncle, length of caudal-peduncle 2.0-2.8 times of its depth vs. 3.0-4.2; a shorter caudal-peduncle, 14.3-15.6% of SL vs. 16-21%; the average ratio of body width at pelvic-fin origin and distance between inner pelvic-fin base 2.0 vs. 3.4; body width 1.1-1.5 times of body depth vs. 1.5-1.6; posterior end of pelvic-fin almost one or slight more than one eye diameter from anus vs. closet to anus; outside rays of pelvic-fin extend more posteriorly than inside rays and make posterior outline of fin acclivitous and straight vs. the outside ones almost equal to the inside ones and make the fin slightly convex.

Foraging habitats and utilization distributions of Black-necked Cranes wintering at the Napahai Wetland, China

One of the most endangered populations of Black-necked Cranes (Grus nigricollis), the central population, is declining due to habitat loss and degradation, but little is known about their space use patterns and habitat preferences. We examined the space use and habitat preferences of Black-necked Cranes during the winter of 2007-2008 at the Napahai wetland in northwest Yunnan, China, where approximately 300 Black-necked Cranes (>90% of the total central population) spent the winter. Euclidean distance analysis was employed to determine the habitat preferences of Black-necked Cranes, and a local nearest-neighbor, convex-hull construction method was used to examine space use. Our results indicate that Black-necked Cranes preferred shallow marsh and wet meadow habitats and avoided farmland and dry grassland. Core-use areas (50% isopleths) and total-use areas (100% isopleths) accounted for only 1.2% and 28.2% of the study area, respectively. We recommend that habitat protection efforts focus on shallow marsh and wet meadow habitats to maintain preferred foraging sites. Core-use areas, such as the primary foraging areas of Black-necked Cranes, should be designated as part of the core zone of the nature reserve. Monthly shifts in the core-use areas of the cranes also indicate that the reserve should be large enough to permit changes in space use. In addition to preserving habitat, government officials should also take measures to decrease human activity in areas used by foraging Black-necked Cranes.

Pseudobagrus brachyrhabdion, a new catfish (Teleostei : Bagridae) from the middle Yangtze River drainage, South China

Pseudobagrus brachyrhabdion sp. nov., from the Yuan Jiang and Xiang Jiang of the middle Yangtze River drainage in Hunan and Guizhou Provinces, South China, is described herein. It is distinguished from all other Pseudobagrus species with a truncate or slightly emarginated caudal fin by an unique combination of the following characters: supraoccipital plate and nuchal plate broadly interspaced and covered with skin; nasal barbels only at most reaching anterior margin of eye; maxillary barbels reaching slightly beyond posterior margin of eye; outer mandibular barbels extending to posterior margin of eye; dorsal fin with a somewhat convex distal margin, origin nearer to pectoral-fin insertion than to pelvic-fin insertion; dorsal-fin spine shorter than pectoral spine, with a somewhat serrated posterior margin; pectoral-fin spine with a smooth anterior margin; anal fin with 20-23 rays, base length 23.8-32.0% of standard length, posterior end of anal-fin base anterior to posterior end of adipose fin base; no longitudinal black band extending along flank; eyes large, diameter 16.3-23.7% of head length; and number of vertebrae 5 + 43-46.

Redescription of Myxobolus pyramidis chen, 1958 (Myxosporea : Bivalvulida)

Redescription of Myxobolus pyramidis Chen, 1958, from gill lamellae of allogynogenetic gibel carp, Carassius auratus gibelio (Bloch), is presented in this paper to complete Chen's description. The diagnostic characters of the myxosporidia are: ovoid round, greyish-white polysporous plasmodia, averaging (159 +/- 21)x(72 +/- 6.5) mu m in size; spore pyriform in front view with smooth surface and symmetrical valves, convex-shaped in sutural view with straight and thick sutural line, averaging (10.5 +/- 1.1)x(10.3 +/- 0.9)x(6.1 +/- 0.2) mu m in size; two equal pyriform polar capsules averaging (5.5 +/- 0.7)x(3.5 +/- 0.2) mu m in size with distinct intercapsular process and polar filament wounded in five to six coils. The histological effects of the pathogen were observed by light microscopy, and the parasite-host relationship was discussed.