Biological application of multi-component nanowires in hybrid devices powered by F-1-ATPase motors

In this paper, construction of hybrid device by integrating nanowires with F1-ATPase motors is described. The nickel nanowires and multi-segment nanowires, including gold and nickel, were fabricated by electrochemical deposition in nanoporous templates. The nickel nanowires functionalized by biotinylated peptide can be assembled directly onto F1-ATPase motors to act as the propellers. If the multicomponent nanowires, including gold and nickel, were selectively functionalized by the thiol group modified ssDNA and the synthetic peptide, respectively, the biotinylated F1- ATPase motors can be attached to the biotinylated peptide on nickel segment of the nanowires. Then, the multi-component nanowires can also be used as the propellers, and one may observe the rotations of the multi-component nanowires driven by F1-ATPase motors. Therefore, introduction of multiple segments along the length of a nanowire can lead to a variety of multiple chemical functionalities, which can be selectively bound to cells and special biomolecules. This method provides an insight for the construction of other hybrid devices with its controlling arrangement of different biomolecule on designed nanometer scale structures.

Application of Three-Dimensional Discrete Element Face-to-Face Contact Model with Fissure Water Pressure to Stability Analysis of Landslide in Panluo Iron Mine

Three-dimensional discrete element face-to-face contact model with fissure water pressure is established in this paper and the model is used to simulate three-stage process of landslide under fissure water pressure in the opencast mine, according to the actual state of landslide in Panluo iron mine where landslide happened in 1990 and was fathered in 1999. The calculation results show that fissure water pressure on the sliding surface is the main reason causing landslide and the local soft interlayer weakens the stability of slope. If the discrete element method adopts the same assumption as the limit equilibrium method, the results of two methods are in good agreement; while if the assumption is not adopted in the discrete element method, the critical phi numerically calculated is less than the one calculated by use of the limit equilibrium method for the same C. Thus, from an engineering point of view, the result from the discrete element model simulation is safer and has more widely application since the discrete element model takes into account the effect of rock mass structures.

Stability Analysis Of The Moving Interface In Piston- And Non-Piston-Like Displacements

From the macroscopic point of view, expressions involving reservoir and operational parameters are established for investigating the stability of moving interface in piston- and non-piston-like displacements. In the case of axi-symmetrical piston-like displacement, the stability is related to the moving interface position and water to oil mobility ratio. The capillary effect on the stability of moving interface depends on whether or not the moving interface is already stable and correlates with the wettability of the reservoir rock. In the case of non-piston-like displacement, the stability of the front is governed by both the relative permeability and the mobility ratio.

The geometric structure and dynamic properties of lauwerier attractor

 Introduction The strange chaotic attractor (ACS) is an important subject in the nonlinear field. On the basis of the theory of transversal heteroclinic cycles, it is suggested that the strange attractor is the closure of the unstable manifolds of countable infinite hyperbolic periodic points. From this point of view some nonlinear phenomena are explained reasonably. 更多还原

Subgrid scale fluid velocity timescales seen by inertial particles in large-eddy simulation of particle-laden turbulence

Large-eddy simulation (LES) has emerged as a promising tool for simulating turbulent flows in general and, in recent years,has also been applied to the particle-laden turbulence with some success (Kassinos et al., 2007). The motion of inertial particles is much more complicated than fluid elements, and therefore, LES of turbulent flow laden with inertial particles encounters new challenges. In the conventional LES, only large-scale eddies are explicitly resolved and the effects of unresolved, small or subgrid scale (SGS) eddies on the large-scale eddies are modeled. The SGS turbulent flow field is not available. The effects of SGS turbulent velocity field on particle motion have been studied by Wang and Squires (1996), Armenio et al. (1999), Yamamoto et al. (2001), Shotorban and Mashayek (2006a,b), Fede and Simonin (2006), Berrouk et al. (2007), Bini and Jones (2008), and Pozorski and Apte (2009), amongst others. One contemporary method to include the effects of SGS eddies on inertial particle motions is to introduce a stochastic differential equation (SDE), that is, a Langevin stochastic equation to model the SGS fluid velocity seen by inertial particles (Fede et al., 2006; Shotorban and Mashayek, 2006a; Shotorban and Mashayek, 2006b; Berrouk et al., 2007; Bini and Jones, 2008; Pozorski and Apte, 2009).However, the accuracy of such a Langevin equation model depends primarily on the prescription of the SGS fluid velocity autocorrelation time seen by an inertial particle or the inertial particle–SGS eddy interaction timescale (denoted by $\delt T_{Lp}$ and a second model constant in the diffusion term which controls the intensity of the random force received by an inertial particle (denoted by C_0, see Eq. (7)). From the theoretical point of view, dTLp differs significantly from the Lagrangian fluid velocity correlation time (Reeks, 1977; Wang and Stock, 1993), and this carries the essential nonlinearity in the statistical modeling of particle motion. dTLp and C0 may depend on the filter width and particle Stokes number even for a given turbulent flow. In previous studies, dTLp is modeled either by the fluid SGS Lagrangian timescale (Fede et al., 2006; Shotorban and Mashayek, 2006b; Pozorski and Apte, 2009; Bini and Jones, 2008) or by a simple extension of the timescale obtained from the full flow field (Berrouk et al., 2007). In this work, we shall study the subtle and on-monotonic dependence of $\delt T_{Lp}$ on the filter width and particle Stokes number using a flow field obtained from Direct Numerical Simulation (DNS). We then propose an empirical closure model for $\delta T_{Lp}$. Finally, the model is validated against LES of particle-laden turbulence in predicting single-particle statistics such as particle kinetic energy. As a first step, we consider the particle motion under the one-way coupling assumption in isotropic turbulent flow and neglect the gravitational settling effect. The one-way coupling assumption is only valid for low particle mass loading.

Biological activities of skin secretions of the salamander Tylototriton verrucosus

Water-soluble skin secretions of salamander Tylototriton venucosus, first described by Anderson in 1871, were studied for their biological and enzymatic activities. They were found to be toxic to mice with an intraperitoneal LD50 of 11.5 mg/kg. Using Sephadex G-75 gel filtration, it was proven that the toxic components of the secretions are proteins with molecular weights ranging from 30,000 to 50,000 Da. The secretions of T. venucosus display a wide spectrum of antimicrobial activities and also contain both proteolytic activity and trypsin inhibitory activity. In contrast, neither hemolytic nor hemorrhagic activities were found. The secretions were determined to have phospholipase A(2) activity; however, no acetylcholine esterase activity was detectable under the assay conditions.

Biochemical and biological properties of Trimeresurus jerdonii venom and characterization of a platelet aggregation-inhibiting acidic phospholipase A(2)

Several biochemical and biological activities such as phospholipase A(2), arginine esterase, proteolytic, L-amino acid oxidase, 5'nucleotidase, acetylcholinesterase, thrombin-like, anticoagulant, and hemorrhagic activities were determined for whole desiccated venom of Trimeresurus jerdonii. An acidic phospholipase (named TJ-PLA(2)) was purified by anionic exchange chromatography, gel filtration, and reverse phase HPLC. TJ-PLA(2) had a molecular weight of 16,000 and a pI of 4.8. TJ-PLA(2) was non-lethal to mice up to an i.p. dose of 15 mg/kg body weight and lacked neurotoxicity and myotoxicity. It induced edema in the footpads of mice. The purified enzyme inhibited ADP- and collagen-induced human platelet aggregation in a manner which was both dose- and time-dependent.

Purification, cloning and biological characterization of a novel disintegrin from Trimeresurus jerdonii venom

A novel disintegrin, jerdonin, was purified from the Trimeresurus jerdonii venom by means of gel filtration and reverse phase high pressure liquid chromatography. Its coding cDNA was also isolated from the venom gland. The jerdonin coding cDNA is part of

Purification, characterization and biological activity of an L-amino acid oxidase from Trimeresurus mucrosquamatus venom

An L-amino acid oxidase (TM-LAO) from the venom of Hunan Trimeresurus mucrosquamatus was purified to homogenicity by three steps including DEAE Sephadex A-50 ion-exchange chromatography, Sephadex G-75 gel filtration and Resourse Q ion-exchange chromatography. TM-LAO is composed of two identical subunits with a molecular weight of 55 kD by SDS-polyacrylamide gel electrophoresis. The molecular weight was different with that of LAO purified from the same species distributed in Taiwan that was 70 kD. The 24 N-terminal ammo acid sequence of TM-LAO is ADNKNPLEECFRETNYEEFLEIAR, which shares high similarity with other Viperid snake venom LAOs and has moderate similarity with Elapid snake venom LAOs. Further studies found that TM-LAO inhibited the growth of E. colt, S. aurues and B. dysenteriae. TM-LAO also showed cytotoxicity and platelet aggregation activity. All the biological activities were eliminated by catalase, a H2O2 scavenger. It shows that these biological effects are possibly due to the formation of H2O2 produced by TM-LAO.

Can the occurrence of rare insertion/deletion polymorphisms in human mtDNA be verified from phylogeny?

Due to its specific characteristics, such as maternal inheritance and absence of recombination, each mtDNA belongs to certain monophyletic clade in the rooted mtDNA tree (haplogroup) according to the mutations it harbors. Rare mutation (excluding parallel mutation) occurring at multiple times in different haplogroups could thus be a potential reading error according to the mtDNA phylogeny. This experience has been widely used in double-checking the credibility of the rare mutations in human mtDNA sequences. However, no test has been performed so far for the feasibility of applying this strategy to the rare insertion/deletion (indel) events in mtDNA sequences. In this study, we attempted to relate the rare indels in mtDNAs to their haplogroup status in a total of 2352 individuals from 50 populations in China. Our results show that the insertion of A at position 16259 is restricted to a subclade of haplogroup C and can be verified. The other indel polymorphisms, which occur in the repeat of the deleted or inserted nucleotide(s), may not be distinguished from phantom mutations from a phylogenetic point of view. Independently and multiply sequencing the fragment with the indel is the best and the most reliable way for confirmation.