Temperature Dependence of the Tribological Properties of Laser Re-Melted Al-Cu-Fe Quasicrystalline Plasma Sprayed Coatings

The aim of this study was to investigate the effect of temperature on tribological properties of plasma-sprayed Al-Cu-Fe quasicrystal (QC) coating after laser re-melting treatment. The laser treatment resulted in a more uniform, denser and harder microstructure than that of the as-sprayed coatings. Tribological experiments on the coatings were conducted under reciprocating motion at high frequency in the temperature range from 25 to 650 degreesC. Remarkable influence of temperature on the friction behavior of the coating was recorded and analyzed. Microstructural analysis indicated that the wear mechanisms of the re-melted QC coatings changed from abrasive wear at room temperature, to adhesive wear at 400 degreesC and severe adhesive wear at 650 degreesC owing to the material transfer of the counterpart ball. It was also observed that the ratio of the icosahedral (i)-phase to beta-Al-50(Fe,CU)(50) phase in the coating was higher after test at 400 'C than that at 650 'C. The variation of the ratio UP of coating and of the property of the counterpart ball and coating with the temperature are the two main factors influencing the wear mechanisms and value of the friction coefficient.

EDTA溶胶凝胶法制备La_2Ni_(1-x)M_xO_4(M=Cu,Fe)稀土复合氧化物

本文以EDTA溶胶凝胶法合成K2NiF4型稀土复合氧化物La2Ni1-xMxO4(M=Cu,Fe),并对反应生成粉体分别进行SEM表征与XRD测试。结果表明,选取合适的制备工艺,可以形成La2Ni1-xMxO4(M=Cu,Fe)稀土复合氧化物材料;随着掺杂离子半径增大,生成材料晶格常数a增大同时,c减少,粉体颗粒粒径较大,同时少量杂相存在。

Assembly of the transition metal substituted polyoxometalates ZnW11M(H2O)O-39(n-) (M = Mn, Cu, Fe, Co, Cr, Ni, Zn) on 4-aminobenzoic acid modified glassy carbon electrode and their electrochemical study

Through layer-by-layer assembly, a series of undecatungstozincates monosubstituted by first-row transition metals, ZnW11M(H2O)O-39(n-) (M=Cr, Mn, Fe, Co, Ni, Cu. or Zn) were first successfully immobilized on a 4-aminobenzoic acid modified glassy carbon electrode surface. The electrochemical behaviors of these polyoxometalates were investigated. They exhibit some special properties in the films different from those in homogeneous aqueous solution. The Cu-centered reaction mechanism in the ZnW11Cu multilayer film was described. The electrocatalytic behaviors of these multilayer film electrodes to the reduction of H2O2 and BrO3- were comparatively studied.

火焰原子吸收光谱法测定明胶中Mg、Ca、Cu、Fe等杂质

明胶是感光工业基本原料之一,其质量的好坏直接影响照像性能,因此对明胶中的杂质进行分析研究具有重要的实际意义。本文采用火焰原子吸收光谱法测定明胶中Mg、Ca、Cu、Fe四个元素。明胶样品经灰化除去有机成分后进行酸溶,然后定容到

Preparation and transport properties of a bulk icosahedral quasicrystalline Ti45Zr35Ni17Cu3 alloy

A bulk alloy which consists of the single icosahedral quasicrystalline phase (I-phase) in Ti45Zr35Ni17CU3 alloy has been fabricated by mechanical alloying and subsequent pulse discharge sintering technique. Crystallographic structure analyses show that the bulk alloy is an I-phase. The transport properties of the bulk alloy are examined, and the results show that the room-temperature thermal conductivity is 5.347 W K-(1) m(-1), and the electrical conductivity decreases with increasing the temperature from 300 to 450K. The Seebeck coefficient is negative at the temperature range from 300 to 360K, and changes to positive from 370 to 450K. Hall effect measurements indicate the bulk I-phase alloy has a high carrier concentration. The specific heat capacity increases when the temperature increases from 280 to 324 K.

特大暴雨下油松林根系对土壤元素迁移的影响

根际是元素由土壤进入植物体的主要界面，降水对根际土壤元素的迁移有显著影响。本文用原状土柱淋滤实验装置及大型挖掘剖面壁法，定量分析了特大暴雨下不同深度土层油松林根系影响土壤元素的稳定输出通量的剖面特征，旨在探索黄土区林木根系对土壤养分生物有效性的提高途径。研究结果表明，特大降雨条件下，油松林地的元素随土层深度增加呈明显的递减规律，在农地土壤剖面中变异不明显。油松林地元素稳定输出通量的平均值显著大于无根系土壤。油松林0-30cm土壤剖面中的元素输出通量占总剖面元素输出通量的96．32％；油松林根系对常量元素K、Na、Mg、Ca、有益元素Si、微量营养元素Mn有明显稳定强化作用的土层深度范围为0-30cm，对有益元素Al和微量元素Cu、Fe有明显稳定强化作用的土层深度范围为0-45cm。