A two-step backoff scheme for improving the performance of the IEEE 802.11 distributed coordination function

This paper describes the binary exponential backoff mechanism of 802.11 distributed coordination function (DCF), and introduces some methods of modifying the backoff scheme. Then a novel backoff scheme, called Two-step Backoff scheme, is presented and illustrated. The simulation process in OPNET environment has been described also. At last, the analysis and simulation results show that the Two-step backoff scheme can enhance the performance of the IEEE 802.11 DCF.

A power-saving scheme for IEEE 802.11 Ad hoc networks

In the Wireless Local Area Networks (WLANs), the terminals are often powered by battery, so the power-saving performance of the wireless network card is a very important issue. For IEEE 802.11 Ad hoc networks, a power-saving scheme is presented in Medium Access Control (MAC) layer to reduce the power consumption by allowing the nodes enter into the sleep mode, but the scheme is based on Time-Drive Scheme (TDS) whose power-saving efficiency becomes lower and lower with the network load increasing. This paper presented a novel energy-saving mechanism, called as Hybrid-Drive Scheme (HDS), which introduces into a Message.-Drive Scheme (MDS) and combines MDS with the conventional TDS. The MDS, could obtain high efficiency when the load is heavy; meanwhile the TDS has high efficiency when the network load is small. The analysis shows that the proposed HDS could obtain high energy-efficiency whether the network load is light or heavy and have higher energy-saving efficiency than conventional scheme in the IEEE 802.11 standard.

A new frequency offset estimation for OFDM-based systems

A new carrier frequency offset estimation scheme in orthogonal frequency division multiplexing (OFDM) is proposed. The scheme includes coarse frequency offset estimation and fine frequency offset estimation. The coarse frequency offset estimation method we present is a improvement of Zhang's method. The estimation range of the new method is as large as the overall signal-band width. A new fine frequency offset estimation algorithm is also discussed in this paper. The new algorithm has a better performance than the Schmidl's algorithm. The system we use to calculate and simulate is based on the high rate WLAN standard adopted by the IEEE 802.11 stanidardization group. Numerical results are presented to demonstrate the performance of the proposed algorithm.

A new frequency offset estimation for OFDM-Based systems

A-new-carrier-frequency offset estimation scheme in orthogonal frequency division multiplexing (OFDM) is proposed. The scheme includes coarse frequency offset estimation and fine frequency offset estimation. The coarse frequency offset estimation method we present is a improvement of Zhang's method. The estimation range of the new method is as large as the overall signal-band width. A new fine frequency offset estimation algorithm is also discussed in this paper. The new algorithm has a better performance than the Schmidt's algorithm. The system we use to calculate and simulate is based on the high rate WLAN standard adopted by the IEEE 802.11 standardization group. Numerical results are presented to demonstrate the performance of the proposed algorithm.

植物激素“802”对凤眼莲耐寒及去污能力的影响

叶面喷施“８０２”能提高凤眼莲耐寒和去污能力，“８０２”的喷施浓度以１００ｍｇ／ｌ为宜，但“８０２”不能提高凤眼莲对水温的极端忍受限，水温低于５℃时凤眼莲仍会死亡。

植物激素“802”对凤眼莲耐寒及去污能力的影响

叶面喷施“８０２”能提高凤眼莲耐寒和去污能力，“８０２”的喷施浓度以１００ｍｇ／Ｌ为宜，但“８０２”不能提高凤眼莲对水温的极端忍受限，水温低于５℃时凤眼莲仍会死亡。

A direct-conversion mixer with DC-offset cancellation for IEEE 802.11a WLAN receiver

A DC-offset cancellation scheme in the 5GHz direct-conversion receiver compliant with IEEE 802.11a wireless LAN standard is described in this paper. It uses the analog feedback loop to eliminate the DC-offset at the output of the double-balanced mixer. The mixer has a simulation voltage conversion gain of IMB at 5.2GHz, noise figure of 9.67dB, IIP3 of 7.6dBm. The solution provides 39.1dB reduction according to the leakage value at LO and mixer load resistors, the additional noise figure added to mixer is less than 0.9dB, the added power dissipation is 0.1mW and was fabricated in 60GHz 0.35 mu m SiGe BiCMOS technology.

5.2 GHz variable-gain amplifier and power amplifier driver for WLAN IEEE 802.11a transmitter front-end

A 5.2 GHz variable-gain amplifier (VGA) and a power amplifier (PA) driver are designed for WLAN IEEE 802.11a monolithic RFIC. The VGA and the PA driver are implemented in a 50 GHz 0.35 μm SiGe BiCMOS technology and occupy 1.12×1.25 mm~2 die area. The VGA with effective temperature compensation is controlled by 5 bits and has a gain range of 34 dB. The PA driver with tuned loads utilizes a differential input, single-ended output topology, and the tuned loads resonate at 5.2 GHz. The maximum overall gain of the VGA and the PA driver is 29 dB with the output third-order intercept point (OIP3) of 11 dBm. The gain drift over the temperature varying from -30 to 85℃ converges within±3 dB. The total current consumption is 45 mA under a 2.85 V power supply.

The W-11-4A platform comprehensive strength monitoring system

A comprehensive strength monitoring system used on a fixed jacket platform is presented in this paper. The long-term monitoring of W-11-4A platform achieved. Structural responses (strain and acceleration) at selected locations, as well as associated environmental parameters, have been obtained. The emphasis of the paper is placed on the system design, and the instrumentation and operation methodology employed in the monitoring of the structural responses. The performance of the system and the characteristic results obtained during its 13-month operation are also summarized.

涠11-4平台结构动态响应监测结果分析(涠11-4平台原位监测研究之二)

本文总结了针对涠１１－４平台一年多时间的应变和加速度监测数据的处理分析工作，详细介绍了所用的数据处理方法，给出了应变数据的统计结果及长期分布规律。通过对应变和加速度信号进行频谱分析，揭示了平台在多种环境条件下的振动特性。

涠11-4平台综合强度监测技术及实施运行系统(涠11-4平台结构原位监测研究之一)

本文介绍了一种固定式导管架平台综合强度监测系统，它用于对涠１１－４平台关键部位的应力、加速度及与结构响应相关的环境参数进行长期监测。讨论的重点内容是结构响应的测量方案、设备及实施方法，并对运行结果作了说明

Molecular dynamics studies on the local disordering of σ3 and σ11 grain boundaries in aluminium bicrystal

Molecular dynamics (MD) simulations using Morse interaction potential are performed in studies of [110] symmetrical tilt grain boundary (GB) structures with mis-orientation angles 50.5 degrees(Sigma 11), 129.5 degrees(Sigma 11), 70.5 degrees(Sigma 3) and 109.5 degrees(Sigma 3) at various tempratures. The GB structures are found to start local disordering at about 0.5T(m)(T-m is the melting point of aluminium) for 50.5 degrees(Sigma 11), 0.32T(m) for 129.5 degrees(Sigma 11) and 0.38T(m) for 70.5 degrees(Sigma 3), respectively. These results agree with conclusions deduced from the anelastic measurements. But, for twin-boundary structure 109.5 degrees(Sigma 3), this disordering has not been found even when temperature increases up to 0.9T(m).

TiC原位增强块状Cu_(47)Ti_(34)Zr_(11)Ni_8非晶合金复合材料

在电弧炉中利用吸铸法制备了直径1-4 mm的原位生成TiC和β-Ti枝晶联合增强的块状Cu47Ti34Zr11Ni8非晶合金复合材料.DSC热分析结果表明,原位生成TiC颗粒的引入,没有影响基体合金的非晶形成能力.用OM,XRD,SEM,EDS等方法研究了复合材料的相组成、微观组织以及成分分布,结果表明,TiC颗粒作为异质形核中心促进了β-Ti枝晶的形成,形成了TiC颗粒和β-Ti枝晶联合增强的块状Cu47Ti34Zr11Ni8非晶合金复合材料,而且β-Ti枝晶的尺寸和数量与TiC颗粒的多少以及试样的尺寸有关.室温压缩试验表明,同单相非晶合金相比,块状Cu47Ti34Zr11Ni8非晶合金复合材料提高了抗压强度及塑性.

第11届国际快淬和亚稳材料会议简介

第11届国际快淬和亚稳材料会议于2002年8月24~30日在英国牛津大学召开，本次会议由牛津大学材料系承办． 200多名来自欧洲、美国、加拿大、日本、韩国、印度、巴西、澳大利亚、新西兰、中国等29个国家的代表参加了本次大会．会议宣读口头报告244篇，张贴论文117篇，其中包括大会报告11篇，邀请报告31篇．会议论文经严格评审后由Materials Science and Engineering A杂志选择收录．下届会议将于2005年在韩国举行．