Nonlinear Analysis of Submarine Pipelines During Single Point Lifting

基于管道微单元体平衡建立了海管单点提升的非线性力学模型的控制微分方程组,使用变弧长的无量纲代换将动边界问题化为固定边界的两点边值问题,利用maple环境下编制的两点边值问题的打靶法程序得到了该问题在各个提升阶段的数值解答和在单点提升过程中管道的极限弯矩约为0.71q~{1/3}(EI)~{2/3}。

Study of three elastic-plastic constitutive models by non-proportional finite deformations of OFHC copper

Experimental stress-strain data of OFHC copper first under torsion to 13% and then under torsion-tension to about 10% are used to study the characteristics of three elastic-plastic constitutive models: Chaboche's super-positional nonlinear model, Dafalias and Popov's two surface model and Watanabe and Atluri's version of the endochronic model. The three models, originally oriented for infinitesimal deformation, have been extended for finite deformation. The results show (a) the Mises-type yield surface used in the three models brings about significant departure of the predictions from the experimental data; (b) Chaboche's and Dafalias' models are easier than Watanabe and Atluri's model in determining the material parameters in them, and (c) Chaboche's and Watanabe & Atluri's models produce almost the same prediction to the data, while Dafalias' model cannot accurately predict the plastic deformations when a loading path changes in its direction. Copyright (C) 1996 Elsevier Science Ltd

Experiments about Simple Liquid Flows in Microtubes

The behavior of micro-scale flow is significant for the performance of Micro-Electro-Mechanical- Systems (MEMS) devices. Some experiments about liquid flow through microtubes with diameters about 3similar to20mum are presented here. The liquids used in our experiments include some simple liquids with small molecules, such as non-ion water and several kinds of organic liquids (CCL4, C6H5C2H5 and Isopropanol etc.). The flow rate and the normalized friction cocfficients were measured in micro-flow experimental apparatus. The results show that when the driven pressure varies from 0 to 1Mpa, the flow behaviors in 20mum microtube for both polar and non-polar liquids are in agreement with Hagen-Poiseuille law of the classical theory. It means that N-S equation based on continuous medium still acts well in this case. For higher pressure drop from 1 to 30Mpa, in the microtubes with diameter of 3similar to10mum, the normalized friction coefficients of organic liquids can't keep constant with pressure increases. However the non-ion water reveals different trends.

大长细比圆柱体顺流向与横向耦合涡激振动的研究

针对大长细比圆柱体的涡激振动问题,建立了柱体顺流向与横向耦合的涡激振动模型,在尾流振子模型的基础上,引入了柱体振动的加速度耦合项,同时考虑到柱体振动瞬时速度的变化,引入了非线性流体力模型.采用有限差分法求解柱体的振动方程,计算结果与实验结果的对比显示,该文模型能较好地模拟大长细比圆柱体涡激振动的重要特性,包括振动频率、振动模态、驻波与行波的特征等.柱体在顺流向的变形曲率与横向的变形曲率在同一量级,说明两个方向的振动对于结构疲劳破坏的贡献同等重要.

Phase-locking of two large-core fibre lasers with 60W of coherent output power

A phase-locking fibre laser array with up to 60 W of coherent output power based on two large-core fibre is reported. The slope efficiency of the in-phase mode is 37%. For two cases of spacings between the cores, steady high-contrast interference stripes are observed. When the whole system operates under a high pump power level, no thermal effects for the spatial filter have been observed, which means that we can increase the coherent output power further by increasing the individual fibre laser power.

355 nm脉冲激光诱导等离子体开关削波

利用激光诱导等离子体开关技术,对355 nm脉冲激光自削波进行了实验和理论研究。分别采用5种不同焦距的透镜,集中讨论了透镜焦距及激光器输出单脉冲能量对脉宽压缩的影响,发现采用焦距为200 mm的透镜能够获得最佳的脉冲压缩效果。在聚焦透镜焦距200 mm,单脉冲能量160 mJ时,获得最短脉宽3.47 ns；在激光电离Cu小孔内壁表面及空气击穿共同作用下,获得了脉宽最短达2.11 ns的脉冲激光输出。此外,根据实验结果得到了355 nm激光空气击穿阈值,并与理论估算值进行比较,两者结果较为一致。

Radially polarized and pulsed output from passively Q-switched Nd:YAG ceramic microchip laser

For the first time, to the best of our knowledge, a radially polarized laser pulse was produced from a passively Q-switched Nd:YAG ceramic microchip laser with a piece of Cr4+:YAG crystal as the saturable absorber and multilayer concentric subwavelength grating as the polarization-selective output coupler. The averaged laser power reached 450 mW with a slope efficiency of 30.2%. The laser pulse had a maximum peak power of 759 W, a minimum pulse duration of 86 ns, and a 6.7 kHz repetition rate at 3.7 W absorbed pump power. The polarization degree of the radially polarized pulse was measured to be as high as 97.4%. Such a radially polarized laser pulse with a high peak power and a short width is important to numerous applications such as metal cutting. (C) 2008 Optical Society of America

用纳米粉制备Nd：Y1.84La0.16O3透明陶瓷Nd：Y1

用碳酸盐共沉淀法制备一种新的掺钕氧化镧钇（Nd：Y1.84La0.16O3）纳米粉体,得到颗粒细小、均匀、分散性好、粒径为50～60nm的Nd：Y1.84La0.16O3纳米粉体.分别采用Nd：Y1.84La0.16O3纳米粉料和商业粉料,用传统陶瓷无压烧结工艺制备Nd：Y1.84La0.16O3透明陶瓷.Nd：Y1.8vLa0.16O3纳米粉制备的陶瓷样品的组分均匀、几乎不存在第二相,具有较高的透过率.商业粉制备的陶瓷样品因混料不均匀而在晶界处存在部分第二相,降低了陶瓷的透过率.此外,还运用体视学法预测

广东省海岛资源综合调查

这次调查获取了大量具有历史价值的资料．其中包括广东海岛及其海域的自然条件、自然资源和社会经济条件的基本资料。海岛综合调查共登岛142个，占广东省759个面积大于500m2的海岛的18.7％，共布设调查断面316条，站点3919个，采样品7933个，采标本49000号．共获得资料数据104万多个；资料汇编288册；编制图幅1159幅，编写并出版海区调查报告7册，调查研究论文集3册、专业调查报告12册和100万字的《广东海岛资源综合调查报告》。广东海岛资源综合调查填补了广东海岛环境、资源综合调查的空白，不仅概括和揭示了海岛自然环境和自然资源的基本情况，而且揭示了海岛经济开发的规律，为发展当地经济作出了突出贡献。