Production cross section of Th-236 in the interaction of U-238 with 60 MeV/u O-18 ions

The neutron-rich target-like isotope Th-236 has been produced in the U-238-2p multinucleon transfer reaction between a 60 MeV/u O-18 beam and natural U-238 targets. The activities of thorium were determined after radiochemical separation of Th from the mixture of uranium and reaction products. The Th-236 isotope was identified by the characteristic gamma-rays of 642.2, 687.6 and 229.6 keV. The production cross section of Th-236 was determined to be 250 +/- 50 mu b.

Production cross-section of Th-236 in the interaction of U-238 with 60MeV/u O-18 Ions

The neutron-rich target-like isotope Th-236 was produced in U-238-2p multinucleon transfer reaction between a 60MeV/u O-18 beam and nature U-238 targets. The thorium activities were radiochemically separated from the mixture of uranium and reaction products. The isotope Th-236 was identified by 642.2keV, 687.6keV and 229.6keV characteristic gamma-rays. The production cross section of Th-236 has been determined to be 250 +/- 50 mu b.

Crack propagation in structures subjected to periodic excitation

In the present paper, a simple mechanical model is developed to predict the dynamic response of a cracked structure subjected to periodic excitation, which has been used to identify the physical mechanisms in leading the growth or arrest of cracking. The structure under consideration consists of a beam with a crack along the axis, and thus, the crack may open in Mode I and in the axial direction propagate when the beam vibrates. In this paper, the system is modeled as a cantilever beam lying on a partial elastic foundation, where the portion of the beam on the foundation represents the intact portion of the beam. Modal analysis is employed to obtain a closed form solution for the structural response. Crack propagation is studied by allowing the elastic foundation to shorten (mimicking crack growth) if a displacement criterion, based on the material toughness, is met. As the crack propagates, the structural model is updated using the new foundation length and the response continues. From this work, two mechanisms for crack arrest are identified. It is also shown that the crack propagation is strongly influenced by the transient response of the structure.

负超载对Al-2024疲劳裂纹扩展的影响

本文讨论了负超载对Al-2024铝合金材料疲劳裂纹扩展的影响,试验发现在大量负超载循环周次之后也有裂纹停滞现象发生。这种停滞现象的产生与剪切唇的形成有关。本文发现负超载期间的剪切唇(简称剪切唇Ⅰ)和负超载之后的剪切唇(简称剪切唇Ⅱ)对疲劳裂纹扩展速率影响的程度不同。从裂纹闭合的观点建立了负超载对疲劳裂纹扩展影响的计算模型。

纤维增强复合材料的破坏机理

<正> 纤维增强复合材料本身是一个非均匀各向异性力学结构。复合材料的研制、设计和使用都与力学密切相关。复合材料的破坏机理比金属材料复杂,不同组分的构成使其在加工中存在和使用中带来的缺陷比金属多。它的破坏机理与纤维、基体组分的性能,粘结强度,纤维铺设方向和顺序,工作条件等有关。需要采用有效的试验和分析方法,研究复合材料在不同

Influence of 2 secondary effects on shear failure of cantilever with attached mass block under impulsive loading

The influence of two secondary effects, rotatory inertia and presence of a crack, on the dynamic plastic shear failure of a cantilever with an attached mass block at its tip subjected to impulsive loading is investigated. It is illustrated that the consideration of the rotatory inertia of the cantilever and the presence of a crack at the upper root of the beam both increase the initial kinetic energy of the block required to cause shear failure at the interface between the beam tip and the tip mass, where the initial velocity has discontinuity Therefore, the influence of these two secondary effects on the dynamic shear failure is not negligible.

冲击载荷作用下容器壳体动态响应的初步数值研究

本文针对带椭球封头的爆炸容器,黑索今(RDX)在中心处的爆炸用点爆炸模型描述,利用四阶Runge-Kutta法求解一组常微分方程得到爆炸近场的自相似解。采用有限体积形式的PPM格式求解轴对称Euler方程,得到了容器内冲击波传播及其演化的图象。以计算得到的冲击载荷为基础,修改HONDO程序,壳体弹塑性模型采用J_2流动理论描述。对冲击波和壳体的耦合作用进行了初步的数值研究。计算结果表明:容器内爆炸冲击波和壳体中应力波的传播及其演化与物理上的定性分析结果是一致的。由于应力波传播速度较冲击波快,因此,在冲击波未到达的静止流场,流场出现扰动声波,并向中心传播。封头顶点附近出现最大变形。在中等载荷作用下,可忽略壳体变形对流场的影响。

湍流射流理论与计算

板壳断裂力学

本书阐明了板壳断裂理论的基础。论证了Reissner型板壳断裂理论的科学性、经典板壳断裂理论的缺陷及在一定范围内仍具有的实用价值；介绍了作者所创意的研究Reissner型板壳断裂纹尖端场的方法等。

目录

超声速化学反应流动中燃料预喷研究述评

研制基于超声速燃烧的高效吸气式推进装置(运行Mach数在3.5以上)需要寻求改善混合效率的有效机制,这对于采用常规碳氢燃料(特别是可以增加密度的液体燃料)的装置尤为重要.延长混合时间的一种途径是在飞行器燃料室的上游喷入部分燃料.壁面喷射一直是超声速气动力学最具挑战性的课题,这里包括使比冲损失最小、改善燃料-空气的混合、减少入口段/燃烧室的相互作用以及增进火焰稳定性等.综述了超声速入口段或燃烧室的隔离器中液体燃料(个别情况下为气体燃料)喷射的研究进展.在这些研究中,燃料都是从后掠型细支架尾迹中的壁面处喷射出来的,动压比很低(qjet/qair=0.6～1.5).它们涉及入口段和燃烧室的隔离器中单个支架/喷射器的几何结构及其组合方式、各种各样的喷射条件、不同的引射剂,并且评估了这些因素对于燃料羽流喷散、比冲损失以及混合效率的影响.述评引用了46篇参考文献.

Group velocity of probe light pulse in an open lambda system

The group velocity of the probe light pulse (GVPLP) propagating through an open Lambda-type atomic system with a spontaneously generated coherence is investigated when the weak probe and strong driving light fields have different frequencies. It is found that adjusting the detuning or Rabi frequency of the probe light field can realize switching of the GVPLP from subluminal to superluminal. Changing the relative phase between the probe and driving light. elds or atomic exit and injection rates can lead to GVPLP varying in a wider range, but cannot induce transformation of the property of the GVPLP. The absolute value of the GVPLP always increases with Rabi frequency of the driving light field increasing. For subluminal and superluminal propagation, the system always exhibits the probe absorption, and GVPLP is mainly determined by the slope of the steep dispersion.

Enhancement and broadening of extreme-ultraviolet supercontinuum in a relative phase controlled two-color laser field

We experimentally demonstrate the generation of an extreme-ultraviolet (XUV) supercontinuum in argon with a two-color laser field consisting of an intense 7 fs pulse at 800 nm and a relatively weak 37 fs pulse at 400 nm. By controlling the relative time delay between the two laser pulses, we observe enhanced high-order harmonic generation as well as spectral broadening of the supercontinuum. A method to produce isolated attosecond pulses with variable width and intensity is proposed. (C) 2008 Optical Society of America.

光纤涂敷层对光纤裂缝传感器分布式监测能力的影响

基于混凝土模型试验，对涂敷层的传感光纤的裂缝复用能力进行了定量分析，得到了传感光纤和工程结构裂缝夹角在30°，45°，60°时的复用能力与裂缝宽度的关系曲线。对由软性材料构成的光纤涂敷层来说，光纤的复用能力随涂敷层厚度的增加而增大，在与裂缝夹角成45°时，二次涂敷粗光纤的复用能力约为细光纤的5倍，表明光纤敷层对光纤裂缝监测的复用能力具有较大影响。对这种影响的机理进行了理论分析和试验研究，发现当混凝土开裂时，光纤沿混凝土界面的滑移是光纤涂敷层影响光纤裂缝复用能力的主要原因，在光纤与裂缝夹角成45°时，这一影