高1,2-聚丁二烯及通用橡胶的流变性质

采用多速粘度计和Monsanto试验机联用,在表观剪切速率为3×10~(-8)—2.5×10~8s~(-1)时观察了高1,2-聚丁二烯(PB)生胶与顺式1,4-PB,EPDM,SBR 1500在流变性质上的差异。高1,2-PB虽在中等剪切速率下有较高的粘度,但在低、高剪切速率时的粘度均较低,这一特性有利于它的加工。高1,2-PB在低剪切速率下的流动活化能较其他橡胶高,故抗冷流性能优越,易于存放。

CHARACTERIZATION OF HIGH FLUENCE NEUTRON-INDUCED DEFECT LEVELS IN HIGH-RESISTIVITY SILICON DETECTORS USING A LASER DEEP-LEVEL TRANSIENT SPECTROSCOPY (L-DLTS)

Neutron irradiated high resistivity (4-6 kOMEGA-cm) silicon detectors in the neutron fluence (PHI(n)) range of 5 X 10(11) n/cm2 to 1 X 10(14) n/cm2 have been studied using a laser deep level transient spectroscopy (L-DLTS). It has been found that the A-center (oxygen-vacancy, E(c) = 0.17 eV) concentration increases with neutron fluence, reaching a maximum at PHI(n) almost-equal-to 5 X 10(12) n/cm2 before decreasing with PHI(n). A broad peak has been found between 200 K and 300 K, which is the result of the overlap of three single levels: the V-V- (E(c) = 0.38 eV), the E-center (P-V, E(c) = 0.44 eV), and a level at E(c) = 0.56 eV that is probably V-V0. At low neutron fluences (PHI(n) < 5 X 10(12) n/cm2), this broad peak is dominated by V-V- and the E-centers. However, as the fluence increases (PHI(n) greater-than-or-equal-to 5 X 10(12) n/cm2), the peak becomes dominated by the level of E(c) = 0.56 eV.

锇的一个重同位素:~(197)Os

利用14 MeV中子轰击天然铂靶,通过~(198)Pt(n,2p)~(197)Os反应产生锇的一种同位素~(197)Os,以γ(X)谱学方法鉴别了它,同时研究了它的衰变性质。观测到了能量为41.2、50.7、196.8、199.6、223.9、233.1、250.2、342.1、403.6和406.4keV的10条新γ射线,并指定为~(197)Os的衰变。测定它的半衰期为2.8±0.6 min。

Pore-filling membrane for direct methanol fuel cells based on sulfonated poly(styrene-ran-ethylene) and porous polyimide matrix

We have synthesized a porous co-polyimide film by coagulating a polyimide precursor in the non-solvent and thermal imidization. Factors affecting the morphology, pore size, porosity, and mechanical strength of the film were discussed. The porous polyimide matrix consists of a porous top layer and a spongy sub-structure with micropores. It is used as a porous matrix to construct sulfonated poly(styrene-ran-ethylene) (SPSE) infiltrated composite membrane for direct methanol fuel cell (DMFC) application. Due to the complete inertness to methanol and the very high mechanical strength of the polyimide matrix, the swelling of the composite membrane is greatly suppressed and the methanol crossover is also significantly reduced, while high proton conductivity is still maintained. Because of its higher proton conductivity and less methanol permeability, single fuel cell performance test demonstrated that this composite membrane outperformed Nafion membrane.

不同去甲肾上腺素剂量下布氏田鼠非颤抖性产热比较

非颤抖性产热是小型哺乳动物的一种重要产热方式。关于其定量测定，一般采用注射去甲肾上腺素（norepinephrine，NE）诱导的最大耗氧量的方式获得。因此，去甲肾上腺素剂量的选择就显得很重要。我们利用常用的3种经验公式计算剂量，即：（1）NE（mg／kg DK）=2．53W^-0．4；（2）NE（mg／kg）=3．3W^0.458；和（3）NE（mg／kg）=6．6W^0.458,W是体重（g），以布氏田鼠为实验对象，测定了3种剂量诱导的非颤抖性产热情况。结果表明，3种剂量都能诱导出最大非颤抖性产热能力，在非颤抖性产热大小上没有显著性差异，分别为6．190±1．342（公式1）、6．166±0．852（公式2）和7．005±1．501（公式3），但公式（3）剂量下体温增加程度显著高于前两个剂量，分别增加了1．9±0．9℃（公式3）、0．9±0．2℃（公式1）和0．7±0．2℃（公式2）。为了防止动物体温过高引起死亡，我们推荐公式（1）和（或）（2）。

常氧下高原鼠兔HIF-1α mRNA的表达

低氧诱导因子-1(HIF-1)是一种由低氧诱导因子-1α(HIF-1α)和芳香烃核受体转录因子(ARNT)组成的二聚体转录因子，在生物体氧平衡调节中起关键作用。高原鼠兔(Ochotona curzoniae)是生活在青藏高原海拔3000 m以上区域，有着极强的低氧、低温耐受能力的特有自然种群。它通过高的基础代谢率和高的氧利用率来适应高原低温、缺氧环境。将高原鼠兔带到北京，常氧室温条件下适应7 d。 RT-PCR扩增高原鼠兔HIF-1αcDNA片断，~（32）p标记作为特异性探针，Northern杂交检测了常氧条件下高原鼠兔HIF-1α的组织特异性表达。结果显示，HIF-1α mRNA在高原鼠兔多种组织中均有表达，并且表现出明显的组织差异性。其中脑的表达量最大，肾其次，心、脾和肝的表达相对较少。