圆域内双柱整流现象的数值模拟

基于Reyleigh整流定律，利用ψ－ε形式的定常不可压N-S方程，数值模拟了双柱在圆域内 作高频小振幅振动时所产生的定常整流流动。揭示了流动随整流雷诺数的演化特性。此外就求解ψ－ε形式的N-S方程所涉及的定解边界条件问题，亦进行了必要的讨论。

黏弹性材料界面裂纹应力场奇性分析

研究两半无限大黏弹性体间Griffith界面裂纹在简谐载荷作用下裂纹尖端动应力场的奇异特性。通过引入裂纹张开位移和裂纹位错密度函数，相应的混合边值问题归结为一组耦合的奇异积分方程。渐近分析表明裂尖动应力场的奇异特征完全包含在奇异积分方程的基本解中。通过对基本解的深入分析发现黏弹性材料界面裂纹尖动应力场具有与材料参数和外载荷频率相关的振荡奇异特性。以标准线性固体黏弹材料为例讨论了材料参数和载荷频率对奇性指数和振荡指数的影响。

流量配比对Coil增益分布影响的数值研究

利用三维CFD技术,通过求解层流Navier-stokes方程与组分输运方程,对简化后的化学氧碘激光RADICL模型进行数值模拟与分析,结合10种组分和21个基元反应的化学反应模型,对COIL亚声速段横向射流情况下,不同的主副流流量配比对化学氧碘激光器性能的影响进行分析与比较.结果证明,过高或过低的碘分子浓度状态均不利于合理、可观的小信号增益系数产生.存在一个最佳流量配比范围,与之对应的工作状态下,COIL的小信号增益系数会得到显著提高.

Nuclear fusion from Coulomb explosions of deuterated methane clusters subjected to ultraintense femtosecond laser pulses

This paper reports that Coulomb explosions taken place in the experiment of heteronuclear deuterated methane clusters ((CD4)(n)) in a gas jet subjected to intense femtosecond laser pulses (170 mJ, 70 fs) have led to table-top laser driven DD nuclear fusion. The clusters produced in supersonic expansion had an average energies of deuterons produced in the laser-cluster interaction were 60 and 1.5 KeV, respectively. From DD collisons of energetic deuterons, a yield of 2.5(+/-0.4)x10(4) fusion neutrons of 2.45 MeV per shot was realized, giving rise to a neutron production efficiency of about 1.5 x 10(5) per joule of incident laser pulse energy. Theoretical calculations were performed and a fairly good agreement of the calculated neutron yield with that obtained from the present experiment was found.

透镜自重变形引起波像差的有限元分析

在用大口径、长焦距平行光管模拟激光远场特性时，其光组透镜在重力作用下的变形不能忽略，为了分析对出射光束质量的影响，采用有限元分析软件“ANSYS”建立了平行光管光组中声400mm平凸透镜的有限元模型，给出一种分析透镜轴向变形引起的波像差的方法，在不同工况下，计算了平凸透镜在重力作用下轴向变形的峰谷值和均方根值，对轴向变形量均方根值最小工况画出了透镜表面变形的等值线图，计算了声350mm通光口径内的波像差峰谷值和均方根值，对平行光管光组的波像差做出估计，验证了设计的合理性。

基于傅里叶变换的光纤探头光谱特性校正方法的研究

针对光纤自身对光谱的非线性衰减的影响，提出了一种基于傅里叶变换的光谱校正方法。首先对是否经过光纤的两种情况下光电倍增管的输出电流进行傅里叶变换，得到光谱频域中的校正函数，然后通过傅里叶逆变换得到光谱域中的校正函数。为实现测试，建立一个光电检测系统，在可见光范围内进行测试。分别对是否带有光纤的两种情况下数据进行采集，使用该校正方法可以使光线的衰减得到较好的修正，误差小于1．54％。实验结果表明，该方法对特定的光纤传导系统的光谱非线性衰减有较好的校正效果。

Experimental study of Ti : sapphire laser end-pumped Nd : YAG ceramic laser Q-switched by Cr4+: YAG saturable absorber

By employing a continuous-wave (CW) Ti:sapphire tunable laser as a pumping source and a Cr4+:YAG single crystal as the saturable absorber (SA), a passively Q-switched Nd:YAG ceramic laser has been demonstrated at room temperature. With an absorbed pumping power of 541 mW at 808 nm, an average output power of 61 mW at 1064 nm has been obtained with 3.5 mu J pulse energy, 15 ns pulse width and 18.18 kHz repetition rate, and the corresponding slope-efficiency is 15%. The relationships between the pulse width, repetition rate, average output power, pulse energy, and peak power on the absorbed pumping power for different initial transmission of the Cr4+:YAG SA are discussed separately. The Nd:YAG ceramic is one of the most promising laser materials for compact, efficient, all-solid-state pulsed lasers.

Influence of B2O3 to the inhomogeneous broadening and spectroscopic properties of Er3+/Yb3+ codoped fluorophosphate glasses

In a three-components fluorophosphate glass system, the introduction of H3BO3 brings some valuable influence to the spectroscopic and thermal properties of the glasses. With H3BO3 increases from 2 to 20mol%, ohm(6), S-ed4113/2, FWHM, T-g and fluorescence lifetime change from 3.21 x 10(-20) cm(2), 1.77 x 10(-20) cm(2), 45 nm, 480 degrees C and 8.8 ms to 4.66 x 10(-20) cm(2), 2.11 x 10(-20) cm(2), 50 nm, 541 degrees C and 7.4 ms, respectively. sigma(abs), sigma(emi), FWHM x tau(f) x sigma(emi) has a maximum when H-3 BO3 is 11 mol%. T-g and T-x-T-g increases with H3BO3 introduction. Results showed that in fluorophosphate glasses, proper amount of B2O3 can be used as a modifier to suppress upconversion and improve spectroscopic properties, broadband property and crystallization stability of the glasses while keeps the fluorescence lifetime relatively high. (c) 2005 Elsevier B.V. All rights reserved.