2.0 GPa 块状斜长角闪岩部分熔融——时间和温度的影响

利用多顶砧压机,以青藏高原北喜马拉雅构造带的天然斜长角闪岩为样品,在2.0GPa,800~1000℃条件下进行了两个系列的块状样品脱水部分熔融实验:(1)保持压力p=2.0GPa,加热时间t=12h不变,改变温度(800℃~1000℃)的实验;(2)保持压力p=2.0GPa,温度T=850℃不变,改变加热时间(12~200h)的实验.结果表明,2.0GPa,加热12h的条件下,随温度升高,斜长角闪岩中依次生成了石榴石、熔体和单斜辉石,熔体的成分呈英云闪长质-花岗闪长质-英云闪长质的演化趋势.2.0GPa,850℃条件下,随加热时间增加,斜长角闪岩中依次生成了石榴石、熔体和单斜辉石,熔体的成分由英云闪长质向花岗闪长质演化.当块状岩石样品中熔体体积百分比的含量达到5%时,熔体已经相互连通.温度大于850℃的条件下生成的熔体其粘度在104Pas量级,已经满足了在地质时间尺度上熔体分凝形成岩浆的粘度要求.因此,可以认为在增厚地壳的下部,斜长角闪岩的脱水部分熔融可以形成英云闪长质-花岗质岩浆.

Deformation Of Pdms Membrane And Microcantilever By A Water Droplet: Comparison Between Mooney-Rivlin And Linear Elastic Constitutive Models

In this paper, we studied the role of vertical component Of Surface tension of a water droplet on the deformation of membranes and microcantilevers (MCLs) widely used in lab-on-a-chip and micro-and nano-electromechanical system (MEMS/NEMS). Firstly, a membrane made of a rubber-like material, poly(dimethylsiloxane) (PDMS), was considered. The deformation was investigated using the Mooney-Rivlin (MR) model and the linear elastic constitutive relation, respectively. By comparison between the numerical solutions with two different models, we found that the simple linear elastic model is accurate enough to describe such kind of problem, which would be quite convenient for engineering applications. Furthermore, based on small-deflection beam theory, the effect of a liquid droplet on the deflection of a MCL was also studied. The free-end deflection of the MCL was investigated by considering different cases like a cylindrical droplet, a spherical droplet centered on the MCL and a spherical droplet arbitrarily positioned on the MCL. Numerical simulations demonstrated that the deflection might not be neglected, and showed good agreement with our theoretical analyses. (C) 2008 Elsevier Inc. All rights reserved.

Hollow DNA/PLL microcapsules with tunable degradation property as efficient dual drug delivery vehicles by alpha-chymotrypsin degradation

Hollow deoxyribonucleic acid (DNA)/poly-L-lysine (PLL) capsules were successfully fabricated through a layer-by-layer (LbL) self-assembly of DNA and PLL on porous CaCO3 microparticles, followed by removal of templates with ethylenediamine tetraacetic acid disodium salt (EDTA). The enzymatic degradation of the capsules in the presence of alpha-chymotrypsin was explored. The higher the enzyme concentration, the higher is the degradation rate of hollow capsules. in addition, glutaric dialdehyde (GA) cross-linking was found to be another way to manipulate degradation rate of hollow capsules.

Effects of infection of EGH-expressing Escherichia coli on haemocytes in Ciona intestinalis

The effects of infection of EGFP-expressing Escherichia coli on the haemocytes of the ascidian Ciona intestinalis were investigated. The results showed that THC of the infected individuals changed significantly. Hyaline amoebocytes phagocytosed E. coli in 5 min and excreted lysosome particles that attached to the surface of the bacteria. Granular amoebocytes released lots of particles for Immoral immunity while stem-cell-like haemocytes remained intact. With the increase in THC, the stem-cell-like haemocytes showed division and proliferation. A small portion of hyaline amoebocytes was at early apoptosis stage I h after infection and typical apoptosis bodies emerged in granular amoebocytes. A few of the infected haemocytes showed DNA damage using SCGE assay. Flow cytometry analysis revealed an obvious apoptosis peak in infected haemocytes. In conclusion, apoptosis was found to be an important immune response of ascidian haemocytes response to bacterial infection. To our best knowledge, this is the first report of the occurrence of apoptosis of haemocytes in ascidians. (c) 2005 Elsevier B.V. All rights reserved.

奶牛胚胎移植中GnRH、PGF_(2)#alpha#同期发情处理效果的比较

193头健康、经产的黑白花奶牛分为3个组,用3种不同的方法进行同期发情处理和胚胎移植。第1组:注射1次Lutalyse;第2组:注射2次Lutalyse;第3组:注射Fertagyl-Lutalyse-Fertagyl。结果表明:第1组和第2组之间的同期发情胚胎移植率无显著差异(P>0.05),分别为26.5%(21/79)和27.0%(18/68);第3组的同期发情胚胎移植率为60.9%(28/46),显著高于第1组和第2组(P<0.05)。

An internally-matched GaN HEMTs device with 45.2 W at 8 GHz for X-band application

Optimized AlGaN/AlN/GaN high electron mobility transistor (HEMT) with high mobility GaN channel layer structures were grown on 2-in. diameter semi-insulating 6H-SiC substrates by MOCVD. The 2-in. diameter GaN HEMT wafer exhibited a low average sheet resistance of 261.9 Omega/square, with the resistance un-uniformity as low as 2.23%. Atomic force microscopy measurements revealed a smooth AlGaN surface whose root-mean-square roughness is 0.281 nm for a scan area of 5 x 5 mu m. For the single-cell HEMTs device of 2.5-mm gate width fabricated using the materials, a maximum drain current density of 1.31 A/mm, an extrinsic transconductance of 450 mS/mm, a current gain cutoff frequency of 24 GHz and a maximum frequency of oscillation 54 GHz were achieved. The four-cell internally-matched GaN HEMTs device with 10-mm total gate width demonstrated a very high output power of 45.2 W at 8 GHz under the condition of continuous-wave (CW), with a power added efficiency of 32.0% and power gain of 6.2 dB. To our best knowledge, the achieved output power of internally-matched devices are the state-of-the-art result ever reported for X-band GaN-based HEMTs. Crown Copyright (C) 2009 Published by Elsevier Ltd. All rights reserved.

Low-temperature heat capacity and thermodynamic properties of crystalline 2-chloro-5-trichloromethylpyridine

The low-temperature heat capacities of 2-chloro-5-trichloromethylpyridine were measured with a high-precision automated adiabatic calorimeter in the temperature range from 80 K to 345 K. A solid-liquid phase transition was observed from 318.57 K to 327.44 K with peak temperature 324.67 K; the molar enthalpy and entropy of phase transition, DeltaH(m) and DeltaS(m), were determined to be 14.50 +/-0.02 kJ mol(-1) and 44.66 +/- 0.07 kJ K-1 mol(-1), respectively. The thermal stability was investigated through thermogravimetric analysis (TG). The TG and DTG results reveal that 2-chloro-5-trichloromethylpyridine starts to lose mass at 332 K due to evaporation and completely changes into vapour at 483 K under the present experimental conditions.

Microstructures and mechanical properties of as-cast Mg–5Al–0.4Mn–xNd (x=0, 1, 2 and 4) alloys

Mg-5Al-0.4Mn-xNd (x=0, 1, 2 and 4wt.%) alloys were prepared by metal mould casting method. The microstructures and mechanical properties were investigated. The results demonstrated that Al11Nd3 phase was formed and mainly aggregated along the grain boundaries with the addition of Nd. Meanwhile, the grain sizes were greatly reduced with the increasing Nd content.

2,5-双(4-羟基苯亚甲基)环戊酮中双电荷离子存在的串联质谱证据

应用串联质谱的碰撞诱导解离和联动扫描技术，研究了2,5-双(4-羟基苯亚甲基)环戊酮的质谱解离特征，提供了双电荷离子存在的实验证据。进一步对双电荷离子(m/z146)的碰撞诱导解离碎裂进行了讨论。