亚微米氮化钛膜的纳米压痕和划痕测定Coatings

采用等离子电弧沉积的方法分别在GT35和40CrNiMo钢上沉积厚约为0.5mm 的氮化钛(TiN)膜。为了筛选基材，采用纳米压痕和划痕技术评价膜基界面结合和固体润滑效果。纳米压痕结果，采用等离子电弧沉积的方法，分别在GT35和40CrNiMo钢上沉积厚约为0.5$\mu $m 的氮化钛(TiN)膜。为了筛选基材，采用纳米压痕和划痕技术，评价膜基界面结合和固体润滑效果。纳米压痕结果，GT35，40CrNiMo和TiN的纳米硬度/弹性模量的典型值分别约为11.5 Gpa/330 Gpa，6.0 Gpa/210 Gpa，30 Gpa/450 Gpa。纳米划痕结果，GT35有较理想的膜基结合能力；GT35，40CrNiMo，TiN及其有机膜的摩擦系数分别约为0.25，0.45，0.15，0.10。同40CrNiMo相比，GT35是较为理想的基体材料。纳米压痕和划痕技术能提供丰富的近表面的弹塑性变形、断裂和摩擦等的信息，是评价亚微米薄膜力学性能的有效手段。

爆炸法制备Sm_2Fe_(17)N_y永磁体

本文介绍了爆炸烧结Sm_2Fe_(17)N_7永磁体的试验及其结果.试验时,在外加磁场下把Sm_2Fe__(17)N_y磁粉取向压制成形后装人金属包套内并抽真空,炸药装在包套外的纸筒内,雷管引爆炸药后,在爆轰压力作用下,磁粉被压实而烧结成磁体。试验结束后,取出磁体测量密度及磁性参数。烧结磁体密度在理论密度6的85％～96％范围内,磁能积大于88 KJ?m~(-3)。它表明,爆炸烧结工艺是制备Sm_2Fe_(17)Ny永磁体的有效工艺。

关于具有剪应力的普通湍流理论发展

本文叙述了周培源1945年发表具有剪应力的普通湍流理论以后,各种湍流模式理论的主要发展概况.

High-speed streams from coronal holes and the accelerating mechanism of the solar-wind

In this paper, the general Mach number equation is derived, and the influence of typical energy forms in the solar wind is analysed in detail. It shows that the accelerating process of the solar wind is influenced critically by the form of heating in the corona, and that the transonic mechanism is mainly the result of the adjustment of the variation of the crosssection of flowing tubes and the heat source term.The accelerating mechanism for both the high-speed stream from the coronal hole and the normal solar wind is similar. But, the temperature is low in the lower level of the coronal hole and more heat energy supply in the outside is required, hence the high speed of the solar wind; while the case with the ordinary coronal region is just the opposite, and the velocity of the solar wind is therefore lower. The accelerating process for various typical parameters is calculated, and it is found that the high-speed stream may reach 800 km/sec.

爆轰波穿越惰性气团时的透射激波参数分析

爆轰波穿越惰性气团再进入可燃混合气体时,透射激波的参数主要受到三个基本过程的影响:头激波两次穿越惰性气团与可燃气体之间接触面导致的激波强度下降、放热反应中止、爆轰波后稀疏波对激波的衰减作用.放热反应中止是透射激波衰减的主要原因,不同种类的惰性气体对透射激波参数影响不大.

柱形容器开口泄爆过程中的火焰传播特性

泄爆过程中流动与燃烧的相互作用机制是研究开口泄爆问题的关键.对柱形容器泄爆过程中压力与火焰发展传播过程的观测与分析表明,不同泄爆条件下压力与火焰的发展传播具有明显特点.泄爆诱导流动通过加速火焰传播、加剧火焰变形、增大火焰面积对容器内燃烧产生增强作用,泄爆流动大小主要由泄爆面积决定.小口中低压泄爆过程压力与火焰的发展过程与封闭燃烧中类似;小口高压以及大口泄爆过程中,火焰变形剧烈,传播速度明显上升,并导致压力的回升.

飞秒强激光场中大尺寸氩团簇爆炸机理的实验研究

By using time-of-flight spectroscopy, the ionization and explosion of large argon clusters ( (n) over bar = 3 x 10(3) - 3 x 10(6)) in the intense femtosecond pulsed laser field (60 fs,2 x 10(16) W/cm(2)) has been studied, and the dependence of average energy of ions emitted from argon clusters on the gas backing pressure has been measured. By comparing the average ion energies obtained with two different supersonic conical nozzles and considering the Hagena's scaling law of clusters, we have found that the average ion energy is determined by the cluster size when the laser parameters are kept unchanged. The experimental results indicated that when the cluster size is less than 3 x 10(5) atoms per cluster, the Coulomb repulsion force is the dominating factor in the expansion mechanism. Beyond this size, for 3 x 10(5) < (n) over barn < 3 x 10(6), the expansion is the result of the combined effect of both the Coulomb repulsion force and the hydrodynamic force, and the latter will play the dominating role for increasing cluster size.

消色差相位匹配在光参量啁啾脉冲放大中的应用

Optical parametric chirped-pulse amplification (OPCPA) supplies broadband gain for ultrashort pulses. A new theoretic explanation of OPCPA has been obtained by introducing the concept of tilted pulse front in this paper, and the distribution of broadband amplification has been twice expanded by introducing the technology of achromatic phase matching (APM). The prospect of APM in OPCPA has been discussed in detail. Finally, a design for the amplification of chirped pulses at 1600 nm has been firstly proposed and numerically simulated. (C) 2004 Elsevier B.V. All rights reserved.

不等间距达曼型滤波器的飞秒脉冲时空变换整形与识别技术

研究了以不等间距达曼（Dammann）型滤波器为模板的飞秒激光时空变换与识别技术。优化设计出不等间距多脉冲达曼型滤波器，并在高斯光谱分布的模拟中讨论产生的超快时域多脉冲平均度和光谱平面上调制周期重复数的相关性。给出了频率分辨光开关法（FROG）技术识别超快时域两脉冲的实验结果。

Near-field hexagonal array illumination based on fractional Talbot effect

Hexagonal array is a basic structure widely exists in nature and adopted by optoclectronic device. A phase plate based on the fractional Talbot effect that converts a single expanded laser beam into a regular hexagonal array of uniformly illuminated apertures with virtually 100% efficiency is presented. The uniform hexagonal array illumination with a fill factor of 1/12 is demonstrated by the computer simulation. (C) 2006 Elsevier GmbH. All rights reserved.

Technique for diagnosing x-ray laser beam quality by use of the moire signal

We present what we believe is a novel technique based on the moire effect for fully diagnosing the beam quality of an x-ray laser. Using Fresnel diffraction theory, we investigated the intensity profile of the moire pattern when a general paraxial beam illuminates a pair of Ronchi gratings in the quasi-far field. Two formulas were derived to determine the beam quality factor M-2 and the effective radius of curvature R-e from the moire pattern. On the basis of the results, the far-field divergence, the waist location, and the radius can be calculated further. Finally, we verified the approach by use of numerical simulation. (C) 1999 Optical Society of America [S0740-3232(99)01502-1].

两种新型芴类衍生物的三光子吸收特性研究

研究了两种新型芴类衍生物9，9-二(2-乙基已基)-2，7-二咔唑-9H-芴(简记为DCZF)和9，9-二(2-乙基已基)-2，7-二(2-(4-甲氧基)苯-2，1-乙烯基)芴(简记为BMOSF)在N，N-二甲基甲酰胺(DMF)中的线性吸收和单光子荧光行为，并用脉冲宽度为38ps，重复频率为10Hz的1064 nm Nd：YAG脉冲激光研究了两种化合物的三光子吸收性质．结果表明：两种新材料的最大线性吸收峰分别位于330和380nm，吸收区域覆盖了270-420nm波段．两种化合物的荧光带位于蓝-紫区，中心

长周期光纤光栅气敏薄膜传感器结构优化

基于三包层长周期光纤光栅模型，研究了包层表面涂覆-层溶胶-凝胶气敏薄膜的长周期光纤光栅化学传感器的灵敏度Sn与薄膜光学参量（折射率n3和厚度h3）和光纤光栅结构参量（光栅周期、折变量和光栅长度）之间的关系。采用最优化数值方法，找到了获得高灵敏度所需的最佳膜层光学参量和光栅结构参量。理论计算表明，该类型传感器对膜层折射率的测量分辨率高达10^-8。实验上制作了对乙醇气体敏感的传感器，并证实了传感器结构优化的必要性。