A high charge state all-permanent magnet ECR ion source for the IMP 320 kV HV platform

A 320 kV high voltage (HV) platform has been constructed at Institute of Modern Physics (IMP) to satisfy the increasing requirements of experimental studies in some heavy ion associated directions. A high charge state all-permanent magnet ECRIS-LAPECR2 has been designed and fabricated to provide intense multiple charge state ion beams (such as 1000 e mu A O6+, 16.7 e mu A Ar14+, 24 e mu A Xe27+, etc.) for the HV platform. LAPECR2 has a dimension of 0 650 mm x 560 mm. The powerful 3D magnetic confinement to the ECR plasma and the optimum designed magnetic field for the operation at 14.5 GHz makes it possible to obtain very good performances from this source. After a brief introduction of the ECRIS and accelerator development at IMP, the conceptual design of LAPECR2 source is presented. The first test results of this all-permanent magnet ECRIS are given in this paper.

Measurements of the heat capacity of an azeotropic mixture of water and n-butanol from 78 to 320 K

Molar heat capacities of n-butanol and the azeotropic mixture in the binary system [water (x=0.716) plus n-butanol (x=0.284)] were measured with an adiabatic calorimeter in a temperature range from 78 to 320 K. The functions of the heat capacity with respect to thermodynamic temperature were established for the azeotropic mixture. A glass transition was observed at (111.9 +/- 1.1) K. The phase transitions took place at (179.26 +/- 0.77) and (269.69 +/- 0.14) K corresponding to the solid-liquid phase transitions of. n-butanol and water, respectively. The phase-transition enthalpy and entropy of water were calculated. A thermodynamic function of excess molar heat capacity with respect to temperature was established, which took account of physical mixing, destructions of self-association and cross-association for n-butanol and water, respectively. The thermodynamic functions and the excess thermodynamic ones of the binary systems relative to 298.15 K were derived based on the relationships of the thermodynamic functions and the function of the measured heat capacity and the calculated excess heat capacity with respect to temperature.

Ultrasonic Tomography and Its Applications in oilfield

UTT (Ultrasonic Tomography Tool) is widely used in the oil industry and can be used to inspect corrosion, casing wall damage, casing breakoff, and casing distortion in the well borehole with the maximum environment temperature being 125 °C, and the pressure being 60 MPa. UTT consists of tool head, upper centralization, electronic section, lower centralization, transmitters, and receivers. Its outer diameter is 4.6 cm and length is 320 cm. The measured casing diameter ranges from 60 mm to 254 mm. The tomography resolution is 512×512. The borehole measurement accuracy is 2 mm. It can supply 3D pipe tomography, including horizontal and vertical profile. This paper introduces its specification, measurement principle, and applications in oilfield.damage, casing breakoff, and casing distortion in the well borehole with the maximum environment temperature being 125 °C, and the pressure being 60 MPa. UTT consists of tool head, upper centralization, electronic section, lower centralization, transmitters, and receivers. Its outer diameter is 4.6 cm and length is 320 cm. The measured casing diameter ranges from 60 mm to 254 mm. The tomography resolution is 512×512. The borehole measurement accuracy is 2 mm. It can supply 3D pipe tomography, including horizontal and vertical profile. This paper introduces its specification, measurement principle, and applications in oilfield.

液相介质对水平气液间歇流动压降的影响

研究了水平管内不同液相介质(水、油和不同浓度的CMC溶液)对气液两相间歇流动压降的影响.实验管道为内径50mm的透明有机玻璃管,从入口到分离器长约30 m,实验段由2个长3 m的水平管组成.共记录了320组不同表观流速下的压降信号:油相0.17～1.85 m/s,水相0.17～2.48 m/s,CMC溶液0.17～1.42 m/s,气相0.06～3.40 m/s.结果表明,液相为牛顿流体(油或水)的气液流动,随着表观气相流速的增大,压降呈增加趋势;非牛顿幂率流体(不同浓度的CMC溶液)的管道流动,当流动指数低于一定值时,压降随气相流量的增加呈降低趋势,并且低于单液相流动的压降.Lockhart-Martinelli模型过高地预测了气-非牛顿幂率流体两相的压降.

Two-way coupling model for shock-induced laminar boundary-layer flows of a dusty gas

The present paper describes a numerical two-way coupling model for shock-induced laminar boundary-layer flows of a dust-laden gas and studies the transverse migration of fine particles under the action of Saffman lift force. The governing equations are formulated in the dilute two-phase continuum framework with consideration of the finiteness of the particle Reynolds and Knudsen numbers. The full Lagrangian method is explored for calculating the dispersed-phase flow fields (including the number density of particles) in the regions of intersecting particle trajectories. The computation results show a significant reaction of the particles on the two-phase boundary-layer structure when the mass loading ratio of particles takes finite values.

Zernike多项式展开系数的时间相关性

分析了受大气湍流扰动的光波波前在系统接收孔径上的Zernike多项式展开系数的时间相关性,在此基础上进一步分析了从不同方向到达系统接收孔径的光波波前整体倾斜之间的相关性，并给出了光波在水平均匀大气中传播时的结果。

韧性断裂裂纹尖端的物理特征和力学行为

本文综述了金属材料发生韧性断裂的裂尖钝化,孔洞成核和长大,孔洞-孔洞或孔洞-裂尖汇合导致裂纹扩展的物理特征,和描述这些特征的本构理论及物理模型。

用LDA测量U形水槽内的振荡流

本文介绍LDA用于测量U形水槽内的振荡流。水槽直管段为正方形,弯管段内侧弯面及外侧弯面是专门计算设计的。对于水平直管段、竖管段及弯管段共七个截面,测量了边界层外振荡流速的振幅分布。对于水平直管段上底面及下底面各三个截面,测量了边界层內振荡流速的振幅分布及相位分布。测量结果和无限长槽道的理论计算结果作了比较,二者基本符合。

非牛顿流体力学

《非牛顿流体力学》一文介绍了由流变学发展起来的一门分支学科——非牛顿流体力学的发展简况、学科内容、研究动向和展望。作者陈文芳教授系英籍非牛顿流体力学专家,1979年来中国,几年来已为我国非牛顿流体力学的发展作出了贡献。作者还深切期望,在本世纪末能建立一个具有中国特色的非牛顿流体力学学派。

纤维增强层合板在单双面压缩下屈曲的优化设计

<正> 1979年,日本宇航研究所的Hirano发表了一篇纤维增强层合板铺层角度优化的研究论文。他把与x轴成α_k和—α_k(k表示某一层)方向所铺设的纤维同种、数目相等、基体同一的一个层片定义为一个单层。各个单层之间可以不完全满足单层所定义的条件,这样就考虑到了由N个单层迭合起来的层合板沿厚度方向异质的情况。同时,他还限定各个单层厚度是相等的。每个单层可以取任意的角度。给出层合板的层数,寻求一组铺层角度——各个单层的角度,使临界载荷值最大。由于与迭代起始值有关,他一般是给出8种起始值,然后再从8组结果中挑选临界载荷最大者为最优铺层角度。

论长期稳定性和动力稳定性

<正> 根据Lejeune-Dirichlet定理,力学系统处于静平衡情形的稳定的充要条件是系统的势能在平衡位置具有极小值。对于旋转的力学系统(机械系统或液体系统)就不象这样简单了。早在100年前Thomson和Tait就指出了旋转力学系统具有长期稳定性(secular stability)和动力稳定性(dynamiC stability)的重要差别。对于旋转液体星准稳演化过程到底按哪一种稳定性判断,是一个争论近百年的问题。在本世纪50年代以前,Thomson,Tait,Poincare,Liapounoff,Darwin,Teans和Lamb等,主张“长期稳定是真实的稳定”,“是天体演化学唯一感兴趣的稳定”。基于这种观点建立的Jeans-Darwin双星分裂理论曾