~(229)Ac具有较小的八极形变性质

通过 1 4MeV中子引起的2 32 Th(n ,α)反应产生2 2 9Ra ,由放射化学分离和γ(X)谱学方法 ,研究了2 2 9Ra到2 2 9Ac的低位态能级。分析结果表明 ,2 2 9Ac具有较小的八极形变性质

Main Progress of Microgravity Sciences and Space Life Sciences Research in China

The progress of the research activities on space material sciences, microgravity ‰uid physics and combustion, space life sciences and biotechnology research, fundamental Physics in China are brie‰y summarized in the present paper. The major space missions and experimental results obtained on board the Chinese recoverable/non-recoverable satellites and the Chinese manned spaceship named ``Shen-Zhou'' are presented summarily. The recent main activities of the ground-based studies in China are introduced in brief.

An Electrowetting Model For Rough Surfaces Under Low Voltage

Electrowetting is one of the most effective methods to enhance wettability. A significant change of contact angle for the liquid droplet can result from the surface microstructures and the external electric field, without altering the chemical composition of the system. During the electrowetting process on a rough surface, the droplet exhibits a sharp transition from the Cassie-Baxter to the Wenzel regime at a low critical voltage. In this paper, a theoretical model for electrowetting is put forth to describe the dynamic electrical control of the wetting behavior at the low voltage, considering the surface topography. The theoretical results are found to be in good agreement with the existing experimental results. (c) Koninklijke Brill NV, Leiden, 2008.

Influence of thermal residual stresses on the composite macroscopic behavior

The influence of the thermal residual stress on the deformation behavior of a composite has been analyzed with a new micromechanical method. The method is based on secant moduli approximation and a new homogenized effective stress to characterize the plastic state of the matrix. It is found that the generated thermal residual stresses after cooling and their influence on the subsequent deformation behavior depends significantly on the aspect ratio of the inclusions. With prolate inclusions, the presence of thermal residual stresses generate a higher compressive hardening curves of the composite, but it is reversed with oblate inclusions. For particle reinforced composite, thermal residual stresses induce a tensile hardening curve higher than the compressive one and this is in agreement with experimental observations. (C) 1998 Elsevier Science Ltd.

激光通过湍流剪切层后的光学性质

本文论述一个由流体力学和光学联系起来的新课题——激光通过湍流剪切层后的相位变化及峰值功率变化。描述了流体力学及光学的有关公式,并认为,某些光学公式可以用流体力学参数去关联。对实验装置及图象分析方法加以叙述,并附上一些实验结果及数据处理结果。

纤维增强复合材料的破坏机理

<正> 纤维增强复合材料本身是一个非均匀各向异性力学结构。复合材料的研制、设计和使用都与力学密切相关。复合材料的破坏机理比金属材料复杂,不同组分的构成使其在加工中存在和使用中带来的缺陷比金属多。它的破坏机理与纤维、基体组分的性能,粘结强度,纤维铺设方向和顺序,工作条件等有关。需要采用有效的试验和分析方法,研究复合材料在不同

等离子区射流发生器

<正> 随着噴气技术的发展,人們对上万度以上的高溫气流兴趣愈来愈大。一方面,空气动力学家和物理学家研究着在超高声速飞体表面的那层溫度在10,000°K以上的熾热气流中究竟发生了哪些物理的和化学的过程,以及这些过程对飞体的方影响;另一方面,冶金学家和工程师又在努力寻找耐高溫的合金材料,以防止飞体的焚毀、过热,并保持足够的刚度与强度。这些研究应該說多半是以实驗的方法来进行的。因此怎样能在实驗室內产生10,000°K以上的高溫源就成为一个迫切需要解决的問題。等离子区射流发生器应新问題的需要而作为一种新技术出现了。显然,任何新技术都不会局限和停留在原來所提

An improvement on the theoretical model for the large-scale coherent structures in the outer region of a turbulent boundary layer

According to the experimental results, there exist large-scale coherent structures in the outer region of a turbulent boundary layer, which have been studied by many authors.As experimental results, Antonia (1990) showed the phase- aver aged streamlines and isovorticity lines of the large-scale coherent structures in a turbulent boundary layer for different Reynolds numbers. Based on the hydrodynamic stability theory, the 2-D theoretical model for the large-scale structures was proposed by Luo and Zhou, in which the eddy viscosity was defined as a complex function of the position in the normal direction. The theoretical results showed in ref. were in agreement with those in ref. However, there were two problems in the results. One is that in the experimental results, there were divergent focuses between two saddle points in the streamlines, but in the theoretical results, there were centers. The other is that the stretched parts of the isovorticity lines appear at the location of centers in the theoretical results, while in the experimental results they located somewhere between the focuses and saddle points. The reason is that the computations were based on a 2-D model.

半焦燃烧特性的热重试验研究

针对目前提倡的煤部分气化燃烧系统集成优化联合生产煤气和热能的新概念,在不同温度下制得四种煤的半焦,通过热天平燃烧试验研究了半焦的燃烧特性,考察了煤种和制备温度对半焦燃烧特性的影响.试验结果表明:煤种不同,所制得半焦燃烧特性不同;相同煤种制得半焦,随制备温度升高,半焦着火温度上升,燃烧活化能增加,燃烧反应活性降低.

非光滑叶片对叶栅气动特性影响的实验研究

在低速平面叶栅风洞中对光滑叶片及3种非光滑叶片进行了实验研究,分析了非光滑叶片对叶栅出口流动特性的影响. 实验结果表明,采用非光滑叶片改变了叶栅出口旋涡结构及流动分布,使叶栅出口的流场趋于均匀,叶片可以承受更大的负荷.

激光点热源作用下试件内部热传导的实验研究

通过红外热像仪测温装置,对有限厚度试件在激光点热源作用下热作用区侧面温度分布进行实时测量。结果表明:对于小厚度的试件,材料内部温度分布与用傅立叶定律得到的结果完全相反,材料内部的温度高于边界温度。对比短脉冲激光作用下产生非傅立叶效应的条件,它们之间有很大差异,由此提出将实验中出现的非常规现象定义为泛傅立叶效应,认为它是由于热量传播到边界时发生反射、叠加等波动行为所致。

求解运动方程的一种不等时间步长的显式数值积分方法

在波动有限元模拟中, 若采用传统的显式数值积分方法求解运动方程, 计算时间步长需采用计算区内满足稳定条件要求的最小时间步长. 然而, 对于大部分计算区域, 这一时间步长过小, 是不必要的. 本文提出了一种不等时间步长的显式数值积分方法, 其基本思想是不同的计算区域采用满足各自稳定条件的计算时间步长. 最后, 本文通过数值试验检验了这一方法的可行性及其对数值计算精度的影响.