Theoretical study on longitudinally pumped Yb3+:Y2O3 lasers

To optimize the performance of longitudinally pumped Yb^(3+):Y2O3 ceramic lasers, cavity parameters such as material length and output coupler transmission at a certain laser output power are calculated numerically using quasi-three-level laser model. The results show great potential of Yb^(3+):Y2O3 ceramics for highly efficient diode-pumped solid-state lasers.

Phi 140 mm sapphire crystal growth by temperature gradient techniques and its color centers

Sapphire crystals, 140 mm in diameter and 90 turn in height, have been grown by temperature gradient techniques (TGT). The growth direction of the boule was fixed by means of Lane X-ray diffraction. A prominent 204 nm absorption band in TGT-Al2O3. which does not appear in single crystals grown by Czochralski method has been studied. Analysis further substantiates the F-center model of this band. Two relatively weaker bands absorbing at 232 nm and 254 nm were ascribed to F+ centers. F-type centers concentration was determined using Smakula's equation. (c) 2005 Elsevier B.V. All rights reserved.

~(140)Tb和~(141)Dy的β缓发质子衰变以及~(143)Dy的自旋宇称

利用40Ca+106Cd融合蒸发反应产生了近质子滴线核140Tb和141Dy,配合氦喷嘴带传输系统采用“质子-γ”符合方法观测了它们的β缓发质子衰变,其中包括半衰期、质子能谱和衰变到第二代子核不同低位态的分支比．通过统计理论拟合提取了140Tb和141Dy的基态自旋宇称分别为7±和9／2±．另一方面,用Woods-Saxon Strutinsky方法计算了这两种核限制组态的势能面,由此得到140Tb和141Dy的基态自旋宇称分别为7+和9／2-．此外用同一方法还计算了143Dy的核势能面,从中看出143Dy存在有自旋宇称为1／2+的基态和一个激发能为198keV的11／2-的同质异能态．该结果与2003年Eur．Phys．J． A16:347-351中的143Dy衰变实验数据相符．

双奇核~(140)Pr的高自旋态能级纲图

通过130 Te(14 N ,4n)反应首次对双奇核14 0 Pr进行了在束γ谱学研究 .在实验中进行了γ射线的激发函数、γ射线单谱和γ γ t符合测量 .建立了激发能达 4 717.3keV的14 0 Pr的能级纲图 ,其中包括新发现的 4 2条γ射线和新建立的 2 7个能级 .基于实验测量的γ跃迁各向异性度 ,建议了14 0 Pr部分能级的自旋值 .根据14 0 Pr附近同位素核结构的系统性 ,对部分能级的准粒子组态作了定性的讨论 .

~(130)Nd和~(140)Tb的EC/β~+衰变研究

利用能量为１７０ＭｅＶ左右的３６Ａｒ重离子束轰击９６Ｒｕ和１０６Ｃｄ浓缩同位素靶，分别生成缺中子同位素１３０Ｎｄ和１４０Ｔｂ．借助氦喷嘴带传输系统，用 Ｘ－γ和 γ－γ符合方法，分离鉴别了这两种核素，并进一步测定了它们的衰变性质．得到１３０ Ｎｄ的半衰期为（１３± ３）ｓ，首次建议了它的ＥＣ／β＋衰变纲图，推测了其子核１３０Ｐｒ的基态和低位能级的自旋宇称．修订了１４０Ｔｂ的原有极简单的ＥＣ／β＋衰变纲图并指认１４０Ｔｂ的基态自旋宇称为７＋．

beta-delayed proton decays of Tb-140 and Dy-140 as well as the spin and parity of Dy-143

Tb-140 and Dy-141 were produced via fusion evaporation in the reaction Ca-40+Cd-106. Their beta-delayed proton decays were studied by means of "p-gamma" coincidence in combination with a He-jet tape transport system, including half-lives, proton energy spectra, gamma-transitions following the proton emissions, and the branching ratios to the low-lying states in the grand-daughter nuclei. The ground-state spins and parities of Tb-140 and Dy-141 were extracted as 7(+/-) and 9/2(+/-), respectively, by fitting the experimental data with a statistical model calculation. The configuration-constrained nuclear potential energy surfaces (NPES) of Tb-140 and Dy-141 were calculated by using the Woods-Saxon Strutinsky method, which indicate the ground-state spins and parities of Tb-140 and Dy-147 to be 7(+) and 9/2(-), respectively. In addition, the configuration-constrained NPES of Dy-143 was also calculated by using the same method. From the NPES a 1/2(+) ground state and a 11/2(-) isomer with the excitation energy of 198keV were found. The calculated results are consistent with our experimental data on the decay of Dy-143 reported in Eur. Phys. J., 2003, A16: 347-351.

beta-delayed proton decays and spin assignments for Tb-140, Dy-141 and Dy-143

The proton-rich isotopes Tb-140 and Dy-141 were produced via the fusion evaporation reaction Ca-40+ Cd-106. Their beta-delayed proton decays were studied by p-gamma coincidence in combination with a He-jet tape transport system, and half-lives, proton energy spectra, gamma-transitions following the proton emission, as well as beta-delayed proton branching ratios to the low-lying states in the grand-daughter nuclei were determined. Comparing the experimental data with statistical model calculations, the ground-state spins of Tb-140 and Dy-141 were found to be consistent with 7 and 9/2, respectively. The configuration-constrained nuclear potential energy surfaces (NPES) of Tb-140 and Dy-141 were calculated using the Woods-Saxon-Strutinsky method, which suggest the ground-state spins and parities of Tb-140 and Dy-141 to be 7(+) and 9/2(-), respectively. In addition, the configuration-constrained NPES of Dy-143 were calculated, which predict a 1/2(+) ground state and a 11/2(-) isomer with excitation energy of 198 keV. These findings are consistent with our previous experimental data on Dy-143 reported in Eur. Phys. J. A 16, 347 (2003).

High-spin states and collective band structures in the odd-odd Pm-140 nucleus

The high-spin states of Pm-140 have been investigated through the reaction Te-126(F-19, 5n) at a beam energy of 90 MeV. A previous level scheme based on the 8(-) isomer has been updated with spin up to 23 (h) over bar. A total of 22 new levels and 41 new transitions were identified. Six collective bands were observed. Five of them were expanded or re-constructed, and one of them was newly identified. The systematic signature splitting and inversion of the yrast pi h(11/2)circle times vh(11/2) band in Pr and Pm odd-odd isotopes has been discussed. Based on the systematic comparison, two Delta I = 2 bands were proposed as double-decoupled bands; other two bands with strong Delta I = 1 M1 transitions inside the bands were suggested as oblate bands with gamma similar to -60 degrees; another band with large signature splitting has been proposed with oblate-triaxial deformation with gamma similar to -90 degrees. The characteristics for these bands have been discussed.

Energy conversion in shape memory alloy heat engine - Part II: Simulation

In this paper, a theoretical model proposed in Part I (Zhu et al., 2001a) is used to simulate the behavior of a twin crank NiTi SMA spring based heat engine, which has been experimentally studied by Iwanaga et al. (1988). The simulation results are compared favorably with the measurements. It is found that (1) output torque and heat efficiency decrease as rotation speed increase; (2) both output torque and output power increase with the increase of hot water temperature; (3) at high rotation speed, higher water temperature improves the heat efficiency. On the contrary, at low rotation speed, lower water temperature is more efficient; (4) the effects of initial spring length may not be monotonic as reported. According to the simulation, output torque, output power and heat efficiency increase with the decrease of spring length only in the low rotation speed case. At high rotation speed, the result might be on the contrary.

固体破坏的损伤演化诱致突变现象

介绍了基于细观非线性动力学模型的研究所取得的进展。发现系统显示一种共性特征，称为演化诱致突变，即演化模式从整体稳定向灾变性模式转变，宏观破坏的样本个性行为，以及宏观性质对细观无序性的敏感性。