~(139)Ce的多准粒子激发态

利用能量为50MeV的12C束流,通过反应130Te(12C,3n)布居了139Ce的高自旋态．基于标准在束核谱学实验测量结果,扩展并更新了139Ce的能级纲图．139Ce的能级结构具有球形原子核的典型特征,其高自旋态由单粒子激发形成．利用经验壳模型计算了139Ce的多准粒子激发态能量,研究了其高自旋激发态的多准粒子特性．

Study of multi-quasiparticle excited states in Ce-139

High-spin states in Ce-139 have been populated using the Te-130(C-12, 3n) reaction at beam energy of 50MeV. The level scheme of Ce-139 has been revised and extended greatly up to E=5765.0keV. The level structure of Ce-139 shows typical characteristics of spherical nucleus, and the high-spin states were formed by the excitations of valence nucleons. Energies of the yrast and near yrast high-spin states in Ce-139 have been calculated by the empirical shell model, and the multi-quasiparticle nature of high-spin excited states has been discussed.

Dipole bands in nucleus Pm-139

High-spin states in nucleus Pm-139 have been studied using the reaction Cd-116(Al-27, 4n)Pm-139. Two dipole cascades have been found. Spin and parity assignments were based on the Directional Correlation of Oriented Nuclei (DCO) ratios and systematic behavior in neighboring odd-proton nuclei. The level structures of Pm-139 are compared with those of the N = 78 isotone Eu-141 in which two dipole bands have been confirmed as magnetic rotational bands. The close similarity between them suggests that the dipole bands in Pm-139 may be magnetic rotational bands.

~(139)Pm高自旋态的实验研究；Experimental observation of high spin states in ~(139)Pm nucleus

通过重离子核反应116Cd(27Al,4n)与在束γ谱的实验技术,对A=130~140核区的奇A核139Pm的高自旋态进行了研究.根据γ-γ符合关系、γ射线的相对强度和各向异性度的测量结果,扩展并更新了139Pm的能级纲图.实验观测到基于πh11/2和πg7/2-[πh11/2]2(或者πd5/2-[πh11/2]2)组态的转动带,利用已有的理论计算结果对这些转动带进行了解释.同时还观测到三个具有很强M1跃迁、旋称劈裂很小的-I=1的带.通过简单分析和系统学比较,指认了它们的组态,发现它们具备磁转动带的特性,很可能是磁转动带.

三维简化Janbu法分析边坡稳定性的扩展

对三维简化的Janbu法进行了扩展,使得离散后在同一行上的各条块在水平横向的安全系数相等以及在同一列上的条块在水平纵向的安全系数相等,得到不同行(列)的安全系数,最后通过各条块底滑面的几何特性与受力分析给出其独立的安全系数以及各条块潜在的滑动方向.该方法拓展了传统极限平衡方法只给出坡体总体安全系数的思路,可对坡体局部稳定性和潜在滑动方向进行判定.该方法可适用于任意形状的滑面,还可分析包括考虑孔隙水压力、地质体分层、上覆载荷以及地震力等其他形式的外载.

Flow Rate Measurement in Multiphase Flow Using Turbine Flow-meter

对涡轮流量传感器进行了理论分析,给出了涡轮流量计仪表常数的计算方法,讨论了获得较大固有仪表常数K_0时涡轮传感器结构参数（如叶片数、涡轮半径、口径等）的优化组合问题,通过多相流动实验,总结出K_0与流动密度之间的实验关系,由此给出用涡轮流量计测量多相流的半理论半经验公式,并在油井多相流量测量中得到了实际应用,符合较好。

桥式类型起重机箱形梁变幅疲劳试验研究

本文对桥式类型起重机箱形梁在变幅载荷作用下疲劳裂纹扩展规律及其寿命进行了实验研究，建立疲劳裂纹扩展规律及其寿命进行了实验研究，建立了疲劳裂纹扩展的Ｐａｒｉｓ公式．由得到的裂纹扩展公式估算了箱形梁的疲劳寿命和疲劳强度，并与试验结果作了比较

Electromechanical influence of crack velocity at bifurcation for poled ferroelectric materials

The piezoelastodynamic field equations are solved to determine the crack velocity at bifurcation for poled ferroelectric materials where the applied electrical field and mechanical stress can be varied. The underlying physical mechanism, however, may not correspond to that assumed in the analytical model. Bifurcation has been related to the occurrence of a pair of maximum circumferential stress oriented symmetrically about the moving crack path. The velocity at which this behavior prevails has been referred to as the limiting crack speed. Unlike the classical approach, bifurcation will be identified with finite distances ahead of a moving crack. Nucleation of microcracks can thus be modelled in a single formulation. This can be accomplished by using the energy density function where fracture initiation is identified with dominance of dilatation in relation to distortion. Poled ferroelectric materials are selected for this study because the microstructure effects for this class of materials can be readily reflected by the elastic, piezoelectic and dielectric permittivity constants at the macroscopic scale. Existing test data could also shed light on the trend of the analytical predictions. Numerical results are thus computed for PZT-4 and compared with those for PZT-6B in an effort to show whether the branching behavior would be affected by the difference in the material microstructures. A range of crack bifurcation speed upsilon(b) is found for different r/a and E/sigma ratios. Here, r and a stand for the radial distance and half crack length, respectively, while E and a for the electric field and mechanical stress. For PZT-6B with upsilon(b) in the range 100-1700 m/s, the bifurcation angles varied from +/-6degrees to +/-39degrees. This corresponds to E/sigma of -0.072 to 0.024 V m/N. At the same distance r/a = 0.1, PZT-4 gives upsilon(b) values of 1100-2100 m/s; bifurcation angles of +/-15degrees to +/-49degrees; and E/sigma of -0.056 to 0.059 V m/N. In general, the bifurcation angles +/-theta(0) are found to decrease with decreasing crack velocity as the distance r/a is increased. Relatively speaking, the speed upsilon(b) and angles +/-theta(0) for PZT-4 are much greater than those for PZT-6B. This may be attributed to the high electromechanical coupling effect of PZT-4. Using upsilon(b)(0) as a base reference, an equality relation upsilon(b)(-) < upsilon(b)(0) < upsilon(b)(+) can be established. The superscripts -, 0 and + refer, respectively, to negative, zero and positive electric field. This is reminiscent of the enhancement and retardation of crack growth behavior due to change in poling direction. Bifurcation characteristics are found to be somewhat erratic when r/a approaches the range 10(-2)-10(-1) where the kinetic energy densities would fluctuate and then rise as the distance from the moving crack is increased. This is an artifact introduced by the far away condition of non-vanishing particle velocity. A finite kinetic energy density prevails at infinity unless it is made to vanish in the boundary value problem. Future works are recommended to further clarify the physical mechanism(s) associated with bifurcation by means of analysis and experiment. Damage at the microscopic level needs to be addressed since it has been known to affect the macrocrack speeds and bifurcation characteristics. (C) 2002 Published by Elsevier Science Ltd.

非均匀性对材料分叉的作用

利用数值方法研究材料空洞化和承受应力沿板厚分布的非均匀性对材料分叉(平板中平面剪切带和表面皱曲)的作用.

联合二能级气体激光器中空间烧孔被消除的条件

本文指出联合二能级气体激光器(包括流动的)空间烧孔被消除的条件是短程扩散时间远小于辐射寿命;当气体极其稀薄时,空间烧孔被消除的条件是短程自由运动时间远小于辐射寿命。并给出具体的判别公式。

A perturbational h4 exponential finite-difference scheme for the convective diffusion equation

A perturbational h4 compact exponential finite difference scheme with diagonally dominant coefficient matrix and upwind effect is developed for the convective diffusion equation. Perturbations of second order are exerted on the convective coefficients and source term of an h2 exponential finite difference scheme proposed in this paper based on a transformation to eliminate the upwind effect of the convective diffusion equation. Four numerical examples including one- to three-dimensional model equations of fluid flow and a problem of natural convective heat transfer are given to illustrate the excellent behavior of the present exponential schemes, the h4 accuracy of the perturbational scheme is verified using double precision arithmetic.