基于TM模激射的圆柱形结构的微盘激光器

Submitted by zhangdi (zhangdi@red.semi.ac.cn) on 2009-06-04T08:36:34Z No. of bitstreams: 1 dspace.cfg: 33388 bytes, checksum: ac9630d3fdb36a155287a049e8b34eb7 (MD5)

端面抽运的Tm:YAP薄片板条激光器的研究

2μm激光器由于其在遥感、雷达和医疗等领域具有重要的应用前景而受到越来越广泛的重视。Tm3+具有长的荧光寿命,且其吸收带与商用的激光二极管相匹配。YAP具有与YAG近似的机械和热性能,其双折射特性使得Tm:YAP激光器可以直接得到线偏振的激光输出,并且可以降低热退偏效应。795nm连续抽运光经透镜组耦合进薄片板条1mm×5mm晶体端面,采用平凹腔结构,分析比较了1%,4%和5%掺杂浓度的Tm:YAP的激光特性。

Passive Q-switching of short-length Tm3+-doped silica fiber lasers by polycrystalline Cr2+:ZnSe microchips

We demonstrate passive Q-switching of short-length double-clad Tm3+-doped silica fiber lasers near 2 mu m pumped by a laser diode array (LDA) at 790 nm. Polycrystalline Cr2+:ZnSe microchips with thickness from 0.3 to 1 mm are adopted as the Q-switching elements. Pulse duration of 120 ns, pulse energy over 14 mu] and repetition rate of 53 kHz are obtained from a 5-cm long fiber laser. As high as 530 kHz repetition rate is achieved from a 50-cm long fiber laser at similar to 10-W pump power. The performance of the Q-switched fiber lasers as a function of fiber length is also analyzed. (c) 2008 Elsevier B.V. All rights reserved.

Tm-doped fibre laser pumped Cr2+: ZnSe poly-crystal laser

Demonstrations of cw lasing in Cr2+:ZnSe poly-crystal are reported. The laser consists of a 1.7-mm-thick Cr2+:ZnSe poly-crystal disc pumped by a Tm-silica double-clad fibre laser at 2050nm. Using a concave high-reflection mirror with a radius of curvature of 500mm as the rear mirror, the laser delivers up to 1030mW of radiation around 2.367 mu m.

970nm抽运下Tm^3／Yb^3＋共掺氧氟玻璃的频率上转换发光

稀土离子掺杂的氧氟玻璃是一种新型上转换发光材料。制备了Tm^3／Yb^3＋单掺、共掺的摩尔分数为n（SiO2）-0．30，n（PbF2）-0．50，n=（Al2O3）=0．15，n（AlF3）=（0．049-x），n（TmF3）=y，n（YbF3）=x（x=0，0．001，0．010，0．015，0．020，y=0，0．001）系统氧氟玻璃，研究了其上转换发光特性、分析了其上转换发光机理。研究发现，在970nm抽运光源激发下，Tm^3＋单掺时没有可见光上转换发射；而加入Yb^3＋后产生了强的蓝光（452n

卤化铅调整Tm^3＋／Yb^3＋共掺碲酸盐玻璃上转换发光研究

研究了卤化铅调整Tm^3+／Yb^3+共掺碲酸盐玻璃的热稳定性能、Raman光谱和上转换发光光谱，分析了Tm^3+／Yb^3+共掺氧卤碲酸盐玻璃的上转换发光机理．结果发现：混合卤化铅调整Tm^3+／Yb^3+共掺碲酸盐玻璃具有好的热稳定性能、低的声子能量、强的上转换蓝光．这表明混合卤化铅调整Tm^3+／Yb^3+共掺碲酸盐玻璃是一种上转换蓝光激光器的潜在基质材料．

Yb^3＋敏化Tm^3＋掺杂氧卤碲酸盐玻璃的上转换发光研究

研究了Yb2O3浓度对Tm^3＋／Yb^3＋共掺氧卤碲酸盐玻璃的上转换发光的影响，分析了上转换发光机理。结果发现，通过980nm的激光二极管激发，在室温下同时观察到强烈的蓝光（475nm）和微弱的红光（649nm），分别是由于Tm^3＋离子^1G4→^3H6和^1G4→^3F4跃迁产生的；上转换机理分析表明，上转换蓝光和红光都是由于双光子吸收过程。随Yb2O3浓度增加，Yb^3＋离子寿命降低，Yb^3＋到Tm^3＋的能量转移效率增加，上转换蓝光和红光强度先增加，在Yb2O3摩尔比为3时达到最大，然后降低。

Cooperative downconversion in GdAl3(BO3)(4): RE3+,Yb3+ (RE=Pr, Tb, and Tm)

An efficient near-infrared (NIR) quantum cutting (QC) in GdAl3(BO3)(4):RE3+,Yb3+ (RE=Pr, Tb, and Tm) phosphors has been demonstrated, which involves the conversion of the visible photon into the NIR emission with an optimal quantum efficiency approaching 200%, by exploring the cooperative downconversion mechanism from RE3+ (RE=Pr, Tb, and Tm) excitons to the two activator ions, Yb3+. The development of NIR QC phosphors could open up a new approach in achieving high efficiency silicon-based solar cells by means of downconversion in the visible part of the solar spectrum to similar to 1000 nm photons with a twofold increase in the photon number. (c) 2007 American Institute of Physics.