Application of the Sanchez-Lacombe lattice fluid theory to the system pvme/ps and model calculations

Cloud point curves reported in the literature for five representatives of the system poly(vinyl methyl ether)/polystyrene were evaluated theoretically by means of the Sanchez-Lacombe lattice fluid theory. The measured phase separation behavior can be described within experimental error using only one adjustable parameter (quantifying the interaction between the unlike mers). The Flory-Huggins interaction parameters calculated from this theoretical description depend in good approximation linearly on composition (volume fractions) and on the inverse temperature. An evaluation of these data yields a maximum heat effect which is almost one order of magnitude less (ca. -0.25 J/cm(3)) than obtained via Hess's cycle (dissolution of the components and of the blend) from calorimetric measurements. Model calculations on the basis of the present theory demonstrate that the critical points shift to a different extent upon a certain relative change in the molar mass of the blend components. The sensitivity of the calculated phase diagrams against changes in the scaling parameter decreases in the following order: interaction energies between unlike mers, differences in the scaling temperatures, pressures and densities.

DETERMINATION OF AMINOPYRINE AND ITS METABOLITE IN BIOLOGICAL FLUID BY LIQUID-CHROMATOGRAPHY ELECTROCHEMISTRY WITH A GLASSY-CARBON ELECTRODE DISPERSED WITH ALPHA-ALUMINA PARTICLES

A sensitive high-performance liquid chromatographic method has been developed for the quantitative determination of aminopyrine (AM) and its metabolite 4-aminoantipyrine (AAN). The method utilizes reverse-phase chromatography/amperometric detection with a glassy carbon electrode dispersed with alpha-arumina particles as the working electrode, on which the oxidation of AM and AAN was greatly improved compared with that on a bare glassy carbon electrode. As a result, the detection limit was as low as 1.4 ng for AM and 0.8 ng for AAN, and the calibration plots for the above compounds have wide linear ranges from 100 ng/mL to 100 mu g/mL and 60 ng/mL to 80 mu g/mL (for AM and AAN, respectively). The above method was applied for the detection of these materials in human urine with satisfactory results.

A HYDROXIDE INCLUSION COMPLEX OF A METHYLENE-BRIDGED TETRAPYRIMIDINIUM MACROCYCLE

In the structure of 4,10,16,22-tetraamino-6,12,18,24-tetramethyl-5,11,1 7,23-tetraaza-1,7,13,19-tetraazoniapentacyclo[19.3.1. 1(3,7).1(9,13).1(15,19)]octacosa-1(25),3,5,- 7(26),9,11,13(27),15,17,19(28),21,23-dodecaene dichloride dihydroxide octahydrate, C

STATISTICAL THERMODYNAMICS IN THE FRAMEWORK OF THE LATTICE FLUID MODEL .1. POLYDISPERSE POLYMERS OF SPECIAL DISTRIBUTION

The Gibbs free energies and equations of state of polymers with special molar mass distributions, e.g., Flory distribution, uniform distribution and Schulz distribution, are derived based on a lattice fluid model. The influence of the polydispersity (or t

STATISTICAL THERMODYNAMICS IN THE FRAMEWORK OF THE LATTICE FLUID MODEL .2. BINARY MIXTURE OF POLYDISPERSE POLYMERS OF SPECIAL DISTRIBUTION

In this paper, the Gibbs free energy, the equation of state and the chemical potentials of polydisperse multicomponent polymer mixtures are derived. For general binary mixtures of polydisperse polymers, we also give the Gibbs free energy, the equation of

STATISTICAL THERMODYNAMICS IN THE FRAMEWORK OF THE LATTICE FLUID MODEL .3. BINARY MIXTURE OF POLYDISPERSE POLYMERS OF SPECIAL DISTRIBUTION WITH STRONG-INTERACTIONS

For a binary mixture of polydisperse polymers with strong interactions, the free energy, the equation of state, the chemical potentials and the spinodal are formulated on the basis of the lattice fluid model. Further, the spinodal curves for the system wi

STATISTICAL THERMODYNAMICS OF A LATTICE FLUID - PURE POLYMER

A statistical thermodynamics theory of a polydisperse polymer based on a lattice model of a fluid is formulated. The pure polydisperse polymer is completely characterized by three scale factors and the distribution law of the system. The equation of state does not satisfy a simple corresponding state principle, except for the polymer fluid with sufficiently high molecular weight.

STUDY ON CYCLODEXTRIN AND ITS INCLUSION COMPLEXES - MOLECULAR MECHANICAL CALCULATION

We studied several inclusion complexes of beta-CD by means of molecular mechanical calculation. The inclusion process and the driving force were discussed, and the conclusion on stability agrees with the results of electrochemical experiments.

The preparation and stability of the inclusion complex of astaxanthin with beta-cyclodextrin

Inclusion complex of astaxanthin with beta-cyclodextrin was prepared. The water solubility of the inclusion complex was < 0.5 mg/ml, which is better than that of astaxanthin. Large aggregates were observed in the aqueous solution of the inclusion complex. Furthermore, the stability of the inclusion complex against temperature and light was greatly enhanced compared to that of astaxanthin. (c) 2006 Elsevier Ltd. All rights reserved.

Geophysical signatures associated with fluid flow and gas hydrate occurrence in a tectonically quiescent sequence, Qiongdongnan Basin, South China Sea

Interpretation of high-resolution two-dimensional (2D) and three-dimensional (3D) seismic data collected in the Qiongdongnan Basin, South China Sea reveals the presence of polygonal faults, pockmarks, gas chimneys and slope failure in strata of Pliocene and younger age. The gas chimneys are characterized by low-amplitude reflections, acoustic turbidity and low P-wave velocity indicating fluid expulsion pathways. Coherence time slices show that the polygonal faults are restricted to sediments with moderate-amplitude, continuous reflections. Gas hydrates are identified in seismic data by the presence of bottom simulating reflectors (BSRs), which have high amplitude, reverse polarity and are subparallel to seafloor. Mud diapirism and mounded structures have variable geometry and a great diversity regarding the origin of the fluid and the parent beds. The gas chimneys, mud diapirism, polygonal faults and a seismic facies-change facilitate the upward migration of thermogenic fluids from underlying sediments. Fluids can be temporarily trapped below the gas hydrate stability zone, but fluid advection may cause gas hydrate dissociation and affect the thickness of gas hydrate zone. The fluid accumulation leads to the generation of excess pore fluids that release along faults, forming pockmarks and mud volcanoes on the seafloor. These features are indicators of fluid flow in a tectonically-quiescent sequence, Qiongdongnan Basin. Geofluids (2010) 10, 351-368.

Hydrogeochemistry of formation water in relation to overpressures and fluid flow in the Qikou Depression of the Bohai bay basin, China

The Qikou Depression is the largest hydrocarbon bearing depression in the western part of the Bohai bay basin, dominated by fan delta and lacustrine strata with volcanic and volcaniclastic rocks. In this study, the formation pressures and hydrochemistry of the formation water in the Qikou depression are investigated. It is found that a significant overpressure occurs in the Dongying (Ed) Formation and the first member (Est), the second member (Es2), the third member (Es3) of the Shahejie Formation. The pressure coefficients commonly range from 1.2 to 1.6 with the highest pressure coefficient being 1.7. The analysis of hydrochemistry data shows that the whole depression is dominated by NaHCO3 water type. The concentration of total dissolved solid (TDS) ranges from 2.13 to 53.16 g/L and shows a distinct vertical variation of salinity and ion ratios. High salinity water (TDS> 10 g/L) occurs below a depth of 2500 m, which coincides with the presence of the overpressured system. However, the increasing trend of TDS is diminished below 3500 m because the generation of organic acids in Qikou Depression is inhibited in the presence of overpressure. The analysis of the relationship among different ions indicates that the present-day characteristics of the formation water result from the albitization of feldspar and the dissolution of sodium-rich silicate minerals and halite in the different hydrochemical and pressure systems. (C) 2009 Elsevier B.V. All rights reserved.

The characteristics of fluid potential in mud diapirs associated with gas hydrates in the Okinawa Trough

Many mud diapirs have been identified in the southern Okinawa Trough from a seismic survey using R/V KEXUE I in 2001. The movement and accumulation of free gas related to mud diapirs are discussed in detail by an analysis of fluid potential which is based upon velocity data. It can be found that free gas moves from the higher fluid potential strata to the lower ones and the gas hydrate comes into being during free gas movement meeting the proper criteria of temperature and pressure. In fact, gas hydrates have been found in the upper layers above the mud diapirs and in host rocks exhibiting other geophysical characteristics. As the result of the formation of the gas hydrate, the free gas bearing strata are enclosed by the gas hydrate bearing strata. Due to the high pressure anomalies of the free gas bearing strata the fluid potential increases noticeably. It can then be concluded that the high fluid potential anomaly on the low fluid potential background may be caused by the presence of the free gas below the gas hydrate bearing strata.

Third-order Stokes wave solutions for interfacial internal waves in a three-layer density-stratified fluid

Interfacial internal waves in a three-layer density-stratified fluid are investigated using a singular method, and third-order asymptotic solutions of the velocity potentials and third-order Stokes wave solutions of the associated elevations of the interfacial waves are presented based on the small amplitude wave theory. as expected, the third-order solutions describe the third-order nonlinear modification and the third-order nonlinear interactions between the interfacial waves. The wave velocity depends on not only the wave number and the depth of each layer but also on the wave amplitude.