X-ray spectroscopy of hollow argon atoms formed on a beryllium surface

The X-rays induced during interaction of highly charged argon ions with a beryllium surface are reported. It is found that the K shell X-ray yield of single particle during interaction of hydrogen-like argon ions was 3.6 x 10(-3), which is five orders more than that of heliumlike argon ions. Moreover, due to the screening the 2s electron, no K X-ray was emitted during interaction of lithium-like argon ions with the beryllium surface. It is also found that the X-ray spectrum induced by Ar17+ interacting with residual gases is very different from that induced by Ar17+ interacting with the surfaces, that provided an experimental evidence for the existence of the hollow atoms below the surface.

30MeV/u~(40)Ar+~(nat)Ag反应中中等质量碎片的发射机制及其发射时间测量

中等质量碎片（IMF）的发射是中能重离子碰撞的一大特点，且随着轰击能量的升高其产额迅速增加。通过测量30MeV/u 40Ar+natAg反应中出射的中等质量碎片，研究了高激发热核的发射机制、发射时标和时空演化规律。 对反应中发射碎片能谱的运动源拟合表明，前角区（11°—22°）中等质量碎片（IMF）来自于三种成分：类靶源、类弹源和中速源成分，其中类弹和中速成分占主导，关联测量的IMF能谱拟合得到，一个来自于类弹源而另一个来自于中速源成分的事件占有相当大的比例。 利用小相对角度内的两碎片关联测量，研究高激发核衰变中中等质量碎片的发射时标和寿命。IMF发射时间随能量的变化很大，从低能碎片的250 fm/c到高能粒子的100 fm/c，表明在此能量下，反应中出射的IMF主要来自于相继两体衰变。通过与其它实验的比较可知，随着束流能量的升高，IMF发射时间由相继两体衰变向多重碎裂过渡。 IMF时空演化研究表明，发射空间的大小对IMF关联函数的影响主要来自于发射源的核物质密度而几乎不依赖于发射源的质量数。

中能区~(40)Ar + ~(197)Au/~(159)Tb/~(nat)Ag反应中高激发热核性质研究

通过对中能区Ar+Au/Tb/Ag反应中高激发核的发射时标、发射次序、发射机制、核温度、集体运动等衰变特性的研究，提取了轻粒子和中等质量碎片（IMF）的发射时间，IMF发射时间随束流能的升高而变短，发射机制逐渐由相继衰变过渡至多重碎裂。研究了轻粒子和碎片间的发射次序，对高能粒子和碎片，轻粒子先于碎片发射，而低能时，则为碎片先于轻粒子发射。IMF发射成分与角度和碰撞参数有关，前角区来自于弹核碎裂，后角区来自于类靶热核的蒸发。在平面和出平面研究表明，中速粒子和碎片为在平面发射占主导，即存在类转动效应；对轻粒子，转动效应随粒子质量增加而增加；对中速产物均观测到该效应随碰撞参数饿增大而增大。采用几种不同的方法提取了热核的核温度，研究了不同方法之间的区别。

On the propagation rate of the chemical waves observed during the course of CO oxidation on a Ag/Pt(110) composite surface

We have analyzed the propagation rate of the chemical waves observed during the course of CO oxidation on a Ag/Pt(I 10) composite surface that were reported in our previous papers [Surf Interface Anal. 2001, 32, 179; J. Phys. Chem. B 2002, 106, 5645]. In all cases, the propagation rate v can be adequately fitted as v = v(0) + D-0/d, in which v(0) and D-0 are constants, and d is the distance between the reaction front of the chemical wave and the boundary from which the chemical wave originates. We propose that the surface species responsible for the formation of the chemical wave comes from two paths: the adsorption of molecules in the gas phase on the surface and the migration from the adjacent surface with different catalytic activity. v(0) corresponds to the contribution from the surface species due to the adsorption, and D-0/d to that of the surface species that migrates from the adjacent surface. The rate equation clearly suggests that the observed chemical wave results from the coupling between adjacent surfaces with different catalytic activities during the course of heterogeneous catalysis. These results, together with our previous reports, provide a good fundamental understanding of spillover, an important phenomenon in heterogeneous catalysis.

Epoxidation of propylene over Ag-CuCl catalysts using air as the oxidant

Ag-CuCl catalysts were found to be active and selective for the epoxidation of propylene using air as the oxidant. Ag catalyst gives a propylene conversion of 31.6%, with a propylene oxide (PO) selectivity of 0.42% at a reaction temperature of 350 degreesC after 220 min of reaction. Addition of CuCl significantly improves the selectivity to PO, and suppresses the conversion of propylene. The Ag-CuCl (1/0.6) catalyst gives propylene conversion of about 3% and a PO selectivity of about 30% at a reaction temperature of 350 degreesC after 500 min of reaction. The activity of the Ag-CuCl catalyst increases with the reaction time and the selectivity to PO is very stable for this catalyst. It is found that AgCl and CuO phases formed during the catalyst preparation are beneficial to the epoxidation of propylene.

Self-assembly of p-sulfonatocalix[4]arene and a Ag-hmt coordination polymer into a porous structure

A novel porous material constructed from p-sulfonatocalix[4]arene molecules and a Ag-I coordination polymer has been structurally characterized. The porous supramolecular complex features a bilayer arrangement of p-sulfonatocalix[4]arene molecules linked by a Ag-I-hmt (hmt: hexamethylene- tetramine) coordination polymer through metal-ligand bonding, hydrogen bonding and host-guest interactions.

Excellent antimicrobial properties of mesoporous anatase TiO2 and Ag/TiO2 composite films

Optically transparent, crack-free, mesoporous anatase TiO2 thin films were fabricated. The Ag/TiO2 composite films were prepared by incorporating Ag in the pores of TiO2 films with an impregnation method via photoreduction. The as-prepared composite films were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray photoelectronic spectra (XPS) and N-2 adsorption. The release behavior of silver ions in the mesoporous composite film was also studied. Moreover, the antimicrobial behaviors of the mesoporous film were also investigated by confocal laser scanning microscopy.

High-quality hydrogen from the catalyzed decomposition of formic acid by Pd-Au/C and Pd-Ag/C

Pd-Au/C and Pd-Ag/C were found to have a unique characteristic of evolving high-quality hydrogen dramatically and steadily from the catalyzed decomposition of liquid formic acid at convenient temperature, and further this was improved by the addition of CeO2(H2O)(x).