400 resultados para LANGMUIR-BLODGETT MULTILAYERS
Resumo:
Semi-empirical molecular orbital calculations using PM3 Hamiltonian were employed to determine qualitative assignments of the vibrational spectrum of zinc phthalocyanine (ZnPc). The assignments are from the potential energy distribution calculations in the normal coordinate analysis and optimized geometry in the PM3 calculations. The structure of the ZnPc molecule is also deduced. (C) 1999 Elsevier Science B.V. All rights reserved.
Resumo:
应用可溶性聚酰亚胺(PI)Langmuir-Blodgett(LB)膜沉积在碳钢电极上,研究其在中性及酸性介质中对碳钢的缓蚀作用.结果表明PILB膜在中性及酸性介质中对碳钢有较好的缓蚀作用,单分子层数目对缓蚀效率有很大的影响.
Resumo:
A series of amphiphilic polymers, monoesters of polymaleic acid containing ate-side groups (PMAN-A(n)Me) was synthesized by the reaction of alcohol(A,Me) with polymaleic anhydride (PMAN) for Langmuir-Blodgett assembly. The effects of the length of flexible spacer in the side chain on the pi-A isotherms and LB films were investigated. The UV-Vis and infrared linear dichroism spectra showed that the ate-side groups were highly oriented in PMAN-A(6)Me LB film deposited on silica or CaF2 substrate.
Resumo:
Copper phthalocyanine doped polymethacrylate Langmuir-Blodgett films were transferred to align a nematic liquid crystal 5CB, It is found that the pre-tilt angle of the liquid crystal can be controlled with the variation of the doped copper phthalocyanine molecular ratio and is correlated with the dichroic ratio of the aligning layer. The polarity of the aligning layer is regarded as the most likely underlying factor that causes the different LC alignment configurations. (C) 1997 Elsevier Science B.V.
Resumo:
A novel kind of K+ sensor with valinomycin-incorporated bilayers supported on a gold electrode consisting of self-assembled alkanethiol monolayers (SAMs) and a lipid monolayer has been fabricated successfully. The lipid monolayer is deposited on the alkylated surface of the first alkanethiol monolayer through three different methods, such as the Langmuir-Blodgett (LB) technique, painted method and painted-frozen method. The response of K + sensors produced by a painted or painted-frozen lipid monolayer on an alkanethiol alkylated gold electrode is larger than that by the LB method, which is due to the difference in fluidity of the three kinds of bilayers. Selectivity coefficients KK+, Na+, KK+, Li+, KK+, Ca2+ and KK+, Mg2+ are 10(-4), 10(-4), 2 x 10(-5) and 3 x 10(-5) respectively, and there is no obvious difference among different fabricating methods. A linear response toward the potassium ion was found in the range from 10(-1) M to 10(-5) M with the detection limit of 10(-6) M. The sensor has a slope of 60 mV per decade. Meanwhile, the longevity of the sensor was improved obviously for at least two months at about -10 degrees C. The higher stability shows the possibility to fabricate a practical biosensor.
Resumo:
A new kind of amphiphilic polyether dendrimer bearing eight alkyl chains at the periphery were synthesized step by step using the convergent method. Their structures were confirmed by FT-IR spectra, H-1 NMR spectra and mass spectra etc. The pi-A isotherms, hysteresis and molecular area-time curves at air water interface were reported. These results showed that they could form stable monolayers at water surface.
Resumo:
A series of liquid crystalline copolymers, poly{2-hydroxyethyl methacrylate}-co-{6-[4-(S-2-methyl-1-butyloxycarbonylphenylazo)phenoxy]hexyl methacrylate} with an azobenzene moiety as photoreactive mesogenic unit, was prepared and investigated by using DSC, polarized optical microscopy and X-ray diffraction. The results show that these polymers exhibit smectic phases. Z-type Langmuir-Blodgett films of these copolymers were successfully deposited onto calcium fluoride and quartz. Reversible homeotropic and planar liquid crystal alignments were induced by using the photochromism of the LB films of one of the copolymers containing 20.6 mol % of the azo unit.
Resumo:
Monolayers of porphyrin and phthalocyanine at the air-water interface were studied by means of film balance and Brewster angle microscopy (BAM). Results showed that the final point of compression isotherm and that of recompression isotherm were coincident or not coincident depending on the target pressures. Results were discussed in terms of the morphology of monolayers observed by BAM.
Resumo:
The collapse behaviour of phthalocyanine monolayers at the air-water interface was studied by means of compression-expansion isotherms. Measurements of two cycles of compression-expansion isotherms of copper tetrakis (4'-benzyloxy-4-phenylsulfonylphenoxy) phthalocyanine showed that the difference in the area per molecule at target pressure between the first cycle and the second cycle was dependent on the target pressure. This difference was used to identify the collapse of monolayers at the air-water interface. The transfer behaviour of monolayers at the air-water interface onto a substrate at different target pressures was also studied.
Resumo:
Supported lipid membranes consisting of self-assembled alkanethiol and lipid monolayers on gold substrates could be produced by three different deposition methods: the Langmuir-Blodgett (L-B) technique, the painted method, and the paint-freeze method, By using cyclic voltammetry, chronoamperometry/chronocoulometry and a.c. impedance measurements, we demonstrated that lipid membranes prepared by these three deposition methods had obvious differences in specific capacitance, resistance and thickness. The specific capacitance of lipid membranes prepared by depositing an L-B monolayer on the alkanethiol alkylated surfaces was 0.53 mu Fcm(-2), 0.44 mu Fcm(-2) by the painted method and 0.68 mu Fcm(-2) by the paint-freeze method. The specific conductivity of lipid membranes prepared by the L-B method was over three times lower than that of the painted lipid membranes, while that of the paint-freeze method was the lowest. The difference among the three types of lipid membranes was ascribed to the influence of the organic solvent in lipid films and the changes in density of the films. The lipid membranes prepared by the usual painted method contained a trace amount of the organic solvent. The organic solvent existing in the hydrocarbon core of the membrane reduced the density of the membrane and increased the thickness of the membrane. The membrane prepared by depositing an L-B monolayer containing no solvent had higher density and the lowest fluidity, and the thickness of the membrane was smaller. The lipid membrane prepared by the paint-freeze method changed its structure sharply at the lower temperature. The organic solvent was frozen out of the membrane while the density of the membrane increased greatly. All these caused the membrane to exist in a ''tilted'' state and the thickness of this membrane was the smallest. The lipid membrane produced by the paint-freeze method was a membrane not containing organic solvent. This method was easier in manipulation and had better reproducibility than that of the usual painting method and the method of forming free-standing lipid film. The solvent-free membrane had a long lifetime and a higher mechanical stability. This model membrane would be useful in many areas of scientific research.
Resumo:
Langmuir-Blodgett膜以其超薄、均匀及在分子水平上进行组装等特点,在分子电子学、集成光学、信息存储、化学与生物传感器等方面有着潜在的应用前景。功能稀土配合物引入LB膜已开始引起人们的重视,但通常情况下其成膜性能较差,稀土羧酸配合物是一类具有无限链状结构的聚合物,它不仅具有良好的发光性能,同时还有热稳定性好,耐紫外光等优点。如果能把这些稀土羧酸配合物组装成有序的分子组合体,则很有可能在分子光学技术、光
Resumo:
聚酰亚胺(PI)是一类耐热性最好的聚合物,其性能和应用已得到极为广泛的研究,近年来发现这类聚合物可以进行电化学氧化还原反应;这对于金属/PI界面性质和PI的功能有重要的意义,本文评述了聚酰亚胺修饰电极的电化学行为、影响电极上的离子转移的因素、光谱特征及PI修饰电极的应用等方面的研究概况,讨论了聚酰亚胺电化学性质在分析化学方面应用的可能性.
Resumo:
N-Methyl-N'-hexadecylviologen (C16MV) has been the subject of several electrochemical and spectroelectrochemical studies which characterized the species present in various redox states for C16MV monolayers on silver electrode surfaces. Both self-assembled monolayers (SA) and Langmuir-Blodgett (LB) transferred systems have been studied. These indicated inconsistencies regarding the presence or absence of splitting of the first reduction peak in its cyclic voltammogram (CV). The present study demonstrates the important influence of the specific anionic species present in the supporting electrolyte. Splitting may or may not take place, depending on the size and relative strength of the adsorption of specific anions contributed by the supporting electrolyte. Small, strongly adsorbing anions such as iodide produced peak splitting in the CV of C16MV monolayers; bulky but weakly adsorbing anions such as perchlorate may disrupt the ordered structure of monolayers but produce no splitting. Ancillary data provided by surface enhanced Raman spectroscopy (SERS) was consistent with the electrochemical measurements.
Resumo:
Poly(2-acrylamido-hexadecylsulfonic acid) (PAMC16S) forms a stable monolayer on a pure water surface. More closely packed monolayers can be obtained when the subphase contains Cd2+ or Ca2+. Self-assembled monolayers have been formed on gold surfaces and characterized by contact angle measurement, XPS and electrochemical analysis. The results show that the monolayers are hydrophobic with the hydrophilic sulfonic acid groups adjacent to the metal surfaces and with the hydrocarbon chains extended from the surfaces. The monolayers exhibit great adsorption stability during the faradaic reactions, illustrating the advantage of polymeric LB films in potential applications.
Resumo:
L-B膜即 Langmuir-Blodgett单分子膜,它是人为地利用分子间相互作用而建立起来的特殊分子体系。在L-B膜中分子是有序的准晶体排列,其性质有别于固体和晶体,因而有人将其称为物质的第五相。用米制备L-B膜的技术称为L-B技术。