Fabrication and emission properties of Er3+/Yb3+ codoped tellurite glass fiber for broadband optical amplification

Tellurite glass is proposed as a host for broadband erbium-doped fiber amplifiers because of their excellent optical and chemical properties. A new single mode Er3+/Yb3+ codoped tellurite fiber with D-shape cladding geometry is fabricated in this work. When pumped at 980 nm, a broad erbium amplified spontaneous emission (ASE) nearly 100 nm in the wavelength range of 1450-1650 ran around 1.53 mu m is observed. It was found that the emission spectrum from erbium in tellurite glass fibers is almost twice as broad as the corresponding spectrum in tellurite bulk glass. The changes in ASE with regard to fiber lengths and pumping power were measured and discussed. The output of about 2.3 mW from Er3+/Yb3+ codoped tellurite fiber ASE source is obtained under the pump power of 700 mW. The broad 1.53 mu m emission of Er3+ in Er3+/Yb3+ codoped tellurite glass fiber can be used as host material for potential broadband optical amplifier and tunable fiber lasers. (c) 2005 Elsevier B.V. All rights reserved.

CW-pumped evanescent amplification based on side-polished fiber with heavily Er3+-doped glass overlay

A novel diffractive-pumping scheme is proposed to improve the evanescent amplification using blazed fiber grating for the first time. We also investigate the cw-pumped-evanescent amplification at 1.55 mu m wavelength with the relative optical gain pumped at 1480 nm of around 2 dB based on side-polished fiber with the effective interaction length as long as 16 mm and with a heavily Er3+-doped (N-Er(3+) > 1.19 x 10(21) ions/cm(3)), low refractive index (n(1550) < 1.47) glass overlay, which has no concentration quenching (tau(f) = 9.0 ms).

Fabrication and amplified spontaneous emission spectrum of Er3+-doped tellurite glass fiber with D-shape cladding

Tellurite glass is proposed as a host for broadband erbium-doped fiber amplifiers because of their excellent optical and chemical properties. A single-mode Er3+-doped tellurite glass fiber with D-shape cladding was fabricated in this work. The characterization of amplified spontaneous emission (ASE) from this newly fabricated Er3+-doped tellurite fibers are exhibited. When pumped at 980 nm, a very broad erbium ASE nearly 150 nm around 1.53 mum is observed. The changes in ASE with regard to fiber lengths and pumping power were measured and discussed. The output of 2 mW from Er3+-doped tellurite fiber ASE source was obtained under the pump power of 660 mW. The broad 1.53 mum emission of Er3+ in tellurite glass fiber can be used as host material for potential broadband optical amplifier and tunable fiber lasers. (C) 2004 Elsevier B.V. All rights reserved.

Direct detection of Yersinia pestis from the infected animal specimens by a fiber optic biosensor

The FOB-3, anew type fiber optic biosensor, is designed to rapidly detect a variety of biological agents or analytes with better stability, sensitivity and specificity. In order to detect Y. Pestis, a sandwich immunoassay was developed by using the purified antibody against antigen FI immobilized on polystyrene probes as the capture antibody and the monoclonal antibody-Cy5 conjugate as the detector. After a series of optimization for the stability, sensitivity and specificity of the FOB-3, 50-1000 ng/ml of antigen FI and 6 x 10(1)-6 x 10(7) CFU/ml Y. pestis could be detected constantly in about 20 min, and Y pestis could be detected specifically from Y. pseudotuberculosis, Y. enterocolitica, B. anthracis and E. coli. Then, 39 blind samples, including 27 tissues of mice infected with Y pestis and 12 tissues of healthy mice as negative control, were detected with the FOB-3. 92.6% infected tissues were identified from the tissues of healthy mice and the tissues containing more than 100 CFU/ml bacteria could be detected by the biosensor. The results demonstrated the feasibility of the FOB-3 as an effective method to detect Y. pestis rapidly and directly from the infected animal specimens with the advantage of portability, simple-operation as well as high sensitivity and specificity. (c) 2006 Elsevier B.V. All rights reserved.

beam-shaping microstructure optical fiber

Microstructure optical fiber with uniform intensity distribution of the fundamental mode is proposed. The design guide line and characteristics of this kind fiber are demonstrated. The relationship between refractive index profile and structure parameters is investigated. The mechanism of forming uniform fundamental mode in these fibers is analyzed.

Electrochemical fabrication and electronic behavior of polypyrrole nano-fiber array devices

Electrochemically active Polypyrrole (PPy) nano-fiber array device was fabricated via electrochemical deposition method using aluminum anodic oxide (AAO) membrane as template. After alkaline treatment electrochemically active PPy nano-fiber lost electrochemical activity, and became electrochemically inactive PPy. The electronic properties of PPy nano-fiber array devices were measured by means of a simple method. It was found that for an indium-tin oxide/electrochemically inactive PPy nano-fiber device, the conductivity of nano-fiber increased with the increase of voltage applied on the two terminals of nano-fiber. The electrochemical inactive PPy nano-fiber might be used as a nano-fiber switching diode. Both Au/electrochemically active PPy and Au/electrochemically inactive PPy nano-fiber devices demonstrate rectifying behavior, and might have been used for further application as nano-rectifiers. (c) 2005 Elsevier B.V. All tights reserved.

外源褪黑激素对野芥菜(Brassica juncea)生长的影响

褪黑激素（N-乙酰基-5-甲氧基色胺）是一种广泛存在于生物体内的吲哚类活性分子。本文以野芥菜（Brassica juncea）为例，初步研究了外源褪黑激素对植物生长生殖的影响。我们选取了发芽2天和发芽4天的野芥菜幼苗，用不同浓度的褪黑激素对其处理24小时，然后测量根的伸长量。结果表明，对于发芽2天的野芥菜，0.1 µM的外源褪黑激素能够显著提高野芥菜幼苗根的生长，而100 µM的外源褪黑激素处理则能够显著抑制根的生长;对于发芽4天的野芥菜，低浓度的外源褪黑激素处理对根生长的影响不明显，而高浓度的褪黑激素处理（如100 µM）能够显著抑制根的伸长。结果表明发芽晚期的野芥菜幼苗的根可能对褪黑激素的处理不敏感。由于褪黑激素对植物的生理作用类似于生长素的作用，因此选用了发芽2天的野芥菜幼苗为植物材料，用外源褪黑激素处理其根24小时后，通过间接酶联免疫吸附测定(ci-ELISA)的方法测定了内源吲哚乙酸（IAA）含量的变化。结果表明低浓度的褪黑激素处理时，内源IAA的含量增高，而在高浓度的褪黑激素处理时，内源IAA含量的变化不大。 关于褪黑激素对野芥菜生殖的影响，我们在花蕾期用褪黑激素涂抹野芥菜的花蕾，并在开花授粉后用褪黑激素涂抹柱头，然后在结实时测量果荚长度，种子千粒重，平均每荚种子数，发芽率等指标。结果表明：对于在花蕾期用褪黑激素处理的植株来说，褪黑激素处理对其的果荚长度，千粒重，平均每荚种子数都没有显著的影响。对于开花后用褪黑激素处理授粉后的柱头，1 µM的褪黑激素处理过的主枝具有较长的果荚长度，而褪黑激素处理对千粒重，平均每荚种子数，发芽率，发芽势和发芽指数均没有显著的影响。在花粉萌发实验中，外源褪黑激素的处理浓度和时间均对花粉萌发有一定的影响，表现为随时间的增加，花粉萌发数目增加，在4 h时，低浓度的褪黑激素处理（10 µM）下花粉的萌发较多。