K+ sensors based on supported alkanethiol/phospholipid bilayers

A novel kind of K+ sensor with valinomycin-incorporated bilayers supported on a gold electrode consisting of self-assembled alkanethiol monolayers (SAMs) and a lipid monolayer has been fabricated successfully. The lipid monolayer is deposited on the alkylated surface of the first alkanethiol monolayer through three different methods, such as the Langmuir-Blodgett (LB) technique, painted method and painted-frozen method. The response of K + sensors produced by a painted or painted-frozen lipid monolayer on an alkanethiol alkylated gold electrode is larger than that by the LB method, which is due to the difference in fluidity of the three kinds of bilayers. Selectivity coefficients KK+, Na+, KK+, Li+, KK+, Ca2+ and KK+, Mg2+ are 10(-4), 10(-4), 2 x 10(-5) and 3 x 10(-5) respectively, and there is no obvious difference among different fabricating methods. A linear response toward the potassium ion was found in the range from 10(-1) M to 10(-5) M with the detection limit of 10(-6) M. The sensor has a slope of 60 mV per decade. Meanwhile, the longevity of the sensor was improved obviously for at least two months at about -10 degrees C. The higher stability shows the possibility to fabricate a practical biosensor.

The rheological properties of polyaniline solution

This paper presents our work on the rheological properties of the solution of polyaniline (PAn) in N-methyl-2-pyrrolidone (NMP). The results indicate that the solution's non-Newtonian property becomes more prominent with the increase in solution concentrations exhibiting the behavior of pseudo-plastic fluid. Besides, there is a critical concentration C-v (around 0.06 g/ml), beyond which the viscosity of the PAn/NMP solution takes a sudden increase. with temperature rising, both the viscosity and the thixotropy of the solution decrease, implying that there exist physical cross-linking interactions between the molecular chains in the solution.

INVESTIGATION ON SELECTIVE DOPING OF POLYANILINE ENCAPSULATED IN THE CHANNELS OF ZEOLITE MOLECULAR-SIEVES

The aniline encapsulated in the channels of zeolite molecular sieves was polymerized electrochemically. The doping reaction of polyaniline was studied in 12-Molybdophosphoric acid and sulfuric acid solution. The results indicate the zeolite modified ele

THE PREPARATION OF ELECTRODES MODIFIED WITH ISOPOLYMOLYBDIC ACID PLUS POLYANILINE FILM AND ITS CATALYTIC EFFECTS ON CHLORATE IONS

Electrodes modified with isopolymolybdic acid+polyaniline film, which exhibit high stability and activity in aqueous acidic solution, have been prepared successfully using two methods: one-step synthesis by electrochemical polymerization at a constant applied potential of +0.80 V/SCE or by cycling the potential at 100 mV/s between -0.12 and +0.85 V in 0.5 M H2SO4 containing 5.0x10(-2) M aniline and 5.0x10(-3) M H4Mo8O26, or two-step synthesis by doping the polyaniline film electrode with isopoly acid (IPA) under a cycling potential between -0.20 and +0.40 V in 0.5 M H2SO4 containing the H4Mo8O26 dopant. The thickness of the film and the amount of dopant in the polyaniline film can be controlled by experimental parameters such as the charge, time and the ratio of aniline to IPA in the solution. The experimental results show that electrodes modified with isopolymolybdic acid+polyaniline film using both methods have a strong catalytic effect on the reduction of chlorate anions. Comparison of the two methods of modification shows that the catalytic effect at the modified electrode prepared by the two-step method is greater than that at the electrode prepared by the one-step method.

ELECTROCHEMICAL STUDY OF ISOPOLY-OXOMETALLATES AND HETEROPOLY-OXOMETALLATES FILM MODIFIED MICROELECTRODES .3. FURTHER STUDY OF ELECTRODE PROCESS OF ISOPOLYMOLYBDIC ANION DOPED IN POLYANILINE FILM

The isopolymolybdic anion-polyaniline film modified carbon fiber (CF) microelectrode with high stability and electroactivity in aqueous acid solution has been successfully prepared by cycling the potential between -0.15 V and +0.85 V vs. sce at 100 mV s-1 or applying constant potential (+0.85 V) for electropolymerization in a 0.5 M H2SO4 solution containing 5.0 x 10(-2) M aniline and 5.0 x 10(-3) M H4Mo8O26. The electrochemical behaviour of the isopolymolybdic anion entrapped in the polyaniline film is strongly influenced by the sweep-potential range besides the acidity of electrolyte solution. In some acidic electrolyte solution (eg 0.5 M H2SO4), the change of the sweep-potential range causes the structure alternation of the isopolymolybdic anion and resulting in a new electrode process. The cyclic voltammogram of Mo8O264- in 0.5 M H2SO4 solution exhibits three two-electron reversible waves between +0.70 and -0.20 V. However, when the potential sweeps to the lower-limit of -0.3 V, where the fourth four-electron cathodic wave appears, the redoxidation process of the reduction product of Mo8O264- becomes relatively complicated. The 10-electron reduction product seems to change into other isopolyanion (this unknown structure isopolyanions are simply called [Mo-O]), which can be reoxidized to Mo8O264- by five successive two-electron oxidation steps from -0.30 to +0.70 V. However, when the lower-limit of the cycling potential is maintained at -0.30 V and the upper-limit reduces to +0.40 V from +0.70 V, the [Mo-O] in the film exhibits four two-electron reversible waves. We have presented a novel explanation about its electrode reaction mechanism on the basis of our experimental results.

SYNTHESIS AND CHARACTERIZATION OF POLY-ORTHO-METHYLANILINE WITH DIFFERENT DEGREES OF OXIDATION

Poly-ortho-methylanilines (POT) in three states fully oxidized, fully reduced and oxidized in varying degrees were synthesized by the reaction of common POT (C-POT) having nearly equal amounts of benzenediamine and quinonediimine units with iodine or phenyl-hydrazine, and the resulting polymers were characterized by IR, C-13-NMR, SEM and elemental analysis. The results showed that the quinonediimine unit in C-POT could be reduced by phenylhydrazine to the benzenediamine unit, forming the polymer with low OD (oxidation degree) or in a fully reduced state and that iodine-oxidation resulted in the increase of quinonediimine unit and decrease of benzenediamine unit. The solubility and flexibility of the formed polymers depend strongly on the amount of quinonediimine unit in it. It is necessary to reduce the content of quinonediimine structure unit in order to improve the solubility of aniline-class polymers.

AN EFFECTIVE TRIPHASIC CATALYTIC-SYSTEM FOR OXIDATION OF BENZYL ALCOHOL UNDER PHASE-TRANSFER CONDITIONS

A tri-phasic catalytic system consisting of aqueous hydrogen peroxide, benzyl alcohol and a solid catalyst such as tungsten trioxide has been proved effective for the oxidation of benzyl alcohol in the presence of cetyl trimethyl aniline bromide (CTMAB). At first, the oxide reacts with CTMAB to form a complex, which can be oxidized by aqueous hydrogen peroxide to form a peroxide which effectively oxidizes benzyl alcohol.

A WOUND-TYPE LITHIUM POLYANILINE SECONDARY CELL

A wound-type cell with a polyaniline (PAn) positive electrode, a LiClO4-propylene carbonate (PC) electrolyte, and a lithium foil negative electrode has been constructed. The two electrodes are separated by a polypropylene separator. The PAn is deposited on carbon felt from a HClO4 solution containing aniline by galvanostatic or potentiostatic electrolysis. Using cyclic voltammetry charge/discharge cycles and charge/retention tests, the following results have been obtained: (i) reversibility of the charge/discharge reaction of the PAn electrode is very good; (ii) more than 50 charge/discharge cycles at 80% charge/discharge efficiency and 260 W h kg-1 discharge energy density can be achieved at 50 mA between 2 and 4 V; (iii) the open-circuit voltage and the capacity retention of the battery after storage at open-circuit for 60 days are 3.4 V and 33%, respectively.

LIGHT-ASSISTED OXIDATIVE DOPING OF POLYANILINES

A novel doping phenomenon of fully reduced polyaniline and poly-o-methyl-aniline, "light-assisted oxidative doping", was found for the first time. The doping reaction was followed by FTIR, UV-VIS, ESR and electrical conductivity measurements. It was shown that the fully reduced polyanilines in the form of HCl-salts undergo a spontaneous transition from an insulator or semiconductor to a conductor when exposed to air and light, and their final molecular chain structures are analogous to those found in HCl-doped common polyanilines.

An acidic polysaccharide with xylose branches from Porphyra yezoensis

An acidic polysaccharide (PY3) was isolated from the hot water extract of the red algae Porphyra yezoensis by successive column chromatographies over DEAE-cellulose and Sephadex G-200. PY3 with an average molecular weight of 1.8x10(5) was demonstrated to be composed of galactose (Gal), 3,6-anhydrogalactose (3,6-AnGal), 6-OSO3-galactose (6-OSO3-Gal) and xylose (Xyl) in an approximate molar ratio of 25 : 15, 10, 1. In view of Smith degradation and methylation and on the basis of spectral evidence including those of IR, GC, GC-MS, and H-1 and C-13 NMR, the most probable repeating unit of PY3 could be proposed as [(1-->3)beta -D-Gal(1 --> 4)alpha -L-3,6-AnGal](3)-[(1 --> 3)beta -D-Gal(1 --> 4)alpha -L-6-OSO3-Gal](2) with a xylose moiety at the C-6 of one of every twenty-five beta -D-Gal residues. To our knowledge, PY3 was shown to be the first porphyran possessing occasional xylose branches.

Chemical characteristics of a polysaccharide from Porphyra capensis (Rhodophyta)

The structure of a polysaccharide from the red seaweed, Porphyra capensis, growing along the coast of Namibia and South Africa was investigated. Algae growing at different sites and collected at different times gave a polysaccharide extract with similar chemical components. FTIR and NMR spectral analysis showed that the polysaccharide from P. capensis had a typical porphyran structure. It has the linear backbone of alternating 3-linked beta-D-galactose and 4-linked alpha-L-galactose-6-sulfate or 3,6-anhydro-alpha- L-galactose units. The ratio of alpha-L-galactose-6-sulfate and the 3,6-anhydrogalactose is 121, as reflected by a H-1 NMR spectrum. A high degree of methylation occurred at the C-6 position of the D-galactose units. The degree of methylation was 0.64 for the D-galactose residues. (C) 2005 Elsevier Ltd. All rights reserved.

The structure of a sulfated galactan from Porphyra haitanensis and its in vivo antioxidant activity

The sulfated galactan fraction F1 isolated from the red seaweed, Porphyra haitanensis, showed typical porphyran structure. It has a linear backbone of alternating 3-linked beta-D-galactosyl units and 4-linked alpha-L-galactosyl 6-sulfate and 3,6-anhydro-alpha-L-galactosyl units. The L-residues are mainly composed of alpha-L-galactosyl 6-sulfate units, and the 3,6-anhydrogalactosyl units are minor. Partial methylation occurred at the C-6 position of the D-galactosyl units and at the C-2 position of the 3,6-anhydro-alpha-L-galactosyl units. Intraperitoneal administration of F1 significantly decreased the lipid peroxidation in aging mice. F1 treatment increased the total antioxidant capacity and the activity of superoxide dismutase (SOD) and glutathione peroxidase (GSH-Px) in aging mice. The results indicated that F1 had significant in vivo antioxidant activity. (C) 2003 Elsevier Ltd. All rights reserved.

Analysis of primary aromatic amines using precolumn derivatization by HPLC fluorescence detection and online MS identification

2-(2-Phenyl-1H-phenanthro-[9,10-d]imidazole-1-yl)-acetic acid (PPIA) and 2-(9-acridone)-acetic acid (AAA), two novel precolumn fluorescent derivatization reagents, have been developed and compared for analysis of primary aromatic amines by high performance liquid chromatographic fluorescence detection coupled with online mass spectrometric identification. PPIA and AAA react rapidly and smoothly with the aromatic amines on the basis of a condensation reaction using 1-ethyl-3-(3dimethylaminopropyl)-carbodiimide (EDC) as dehydrating catalyst to form stable derivatives with emission wavelengths at 380 and 440 nm, respectively. Taking six primary aromatic amines (aniline, 2-methylaniline, 2-methoxyaniline, 4-methylaniline, 4-chloroaniline, and 4-bromoaniline) as testing compounds, derivatization conditions such as coupling reagent, basic catalyst, reaction temperature and time, reaction solvent, and fluorescent labeling reagent concentration have also been investigated. With the better PPIA method, chromatographic separation of derivatized aromatic amines exhibited a good baseline resolution on an RP column. At the same time, by online mass spectrometric identification with atmospheric pressure chemical ionization (APCI) source in positive ion mode, the PPIA-labeled derivatives were characterized by easy-to-interpret mass spectra due to the prominent protonated molecular ion m/z [M + H](+) and specific fragment ions (MS/MS) m/z 335 and 295. The linear range is 24.41 fmol-200.0 pmol with correlation coefficients in the range of 0.9996-0.9999, and detection limits of PPIA-labeled aromatic amines are 0.12-0.21 nmol/L (S/N = 3). Method repeatability, precision, and recovery were evaluated and the results were excellent for the efficient HPLC analysis. The most important argument, however, was the high sensitivity and ease-of-handling of the PPIA method. Preliminary experiments with wastewater samples collected from the waterspout of a paper mill and its nearby soil where pollution with aromatic amines may be expected show that the method is highly validated with little interference in the chromatogram.