Automated voltammetric system for shipboard determination of metal speciation in sea water

An automated and semi-intelligent voltammetric system is described for trace metal analysis. The system consists of a voltammeter interfaced with a personal computer, a sample changer, 2 peristaltic pumps, a motor burette and a hanging mercury drop electrode. The system carries out fully automatically approximately 5 metal determinations per hour (including at least 3 repetitive scans and calibration by standard addition) at trace levels encountered in clean sea water. The computer program decides what level of standard addition to use and evaluates the data prior to switching to the next sample. Alternatively, the system can be used to carry out complexing ligand titration with copper whilst recording the labile copper concentration; in this mode up to 8 full titrations are carried out per day. Depth profiles for chromium speciation in the Mediterranean Sea and a profile for copper complexing ligand concentrations in the North Atlantic Ocean measured on board-ship with the system are presented. The chromium speciation was determined using a new method to differentiate between Cr(III) and Cr(VI) utilizing adsorption of Cr(III) on silica particles.

timng of the last glacial maximum from observed sea level minima

During the Last Glacial Maximum, ice sheets covered large areas in northern latitudes, and global temperatures were significantly lower than today. But few direct estimates exist of the volume of the ice sheets, or the timing and rates of change during their advance and retreat. Here we analyze four distinct sediment facies in the shallow, tectonically stable Bonaparte Gulf, Australia - each of which is characteristic of a distinct range in sea level - to estimate the maximum volume of land-based ice during the last glaciation and the timing of the initial melting phase. We use faunal assemblages and preservation status of the sediments to distinguish open marine, shallow marine, marginal marine and brackish conditions, and estimate the timing and the mass of the ice sheets using radiocarbon dating and glacio-hydroisostatic modelling. Our results indicate that from at least 22,000 to 19,000 (calendar) years before present, land-based ice volume was at its maximum, exceeding today's grounded ice sheets by 52.5 x 10 exp 6 cu km. A rapid decrease in ice volume by about 10 percent within a few hundred years terminated the Last Glacial Maximum at 19,000 +/- 250 years.

Diagnostic experiments for transport mechanisms of suspended sediment discharged from the Yellow River in the Bohai Sea

Five diagnostic experiments with a 3D baroclinic hydrodynamic and sediment transport model ECOMSED in couple with the third generation wave model SWAN and the Grant-Madsen bottom boundary layer model driven by the monthly sediment load of the Yellow River, were conducted to separately diagnose effects of different hydrodynamic factors on transport of suspended sediment discharged from the Yellow River in the Bohai Sea. Both transport and spatio-temporal distribution of suspended sediment concentration in the Bohai Sea were numerially simulated. It could be concluded that suspended sediment discharged from the Yellow River cannot be delivered in long distance under the condition of tidal current. Almost all of sediments from the Yellow River are deposited outside the delta under the condition of wind-driven current, and only very small of them are transported faraway. On the basis of wind forcing, sediments from the Yellow River are mainly transported north-northwestward, and others which are first delivered to the Laizhou Bay are continuously moved northward. An obvious 3D structure characteristic of sediment transport is produced in the wind-driven and tide-induced residual circulation condition. Transport patterns at all layers are generally consistent with circulation structure, but there is apparent deviation between the depth-averaged sediment flux and the circulation structure. The phase of temporal variation of sediment concentration is consistent with that of the bottom shear stress, both of which are proved to have a ten-day cycle in wave and current condition.

Controllable Red, Green, Blue (RGB) and Bright White Upconversion Luminescence of Lu2O3:Yb3+/Er3+/Tm3+ Nanocrystals through Single Laser Excitation at 980 nm

Lu2O3:Yb3+/Er3+/Tm3+ nanocrystals have been successfully synthesized by a solvothermal process followed by a subsequent heat treatment at 800 degrees C. Powder X-ray diffraction, transmission electron microscopy, upconversion photoluminescence spectra, and kinetic decay were used to characterize the samples. Under single-wavelength diode laser excitation of 980 nm, the bright blue emissions of Lu2O3:Yb3+, Tm3+ nanocrystals near 477 and 490 nm were observed due to the (1)G(4)-> H-3(6) transition of Tm3+. The bright green UC emissions of Lu2O3:Er3+ nanocrystals appeared near 540 and 565 nm were observed and assigned to the H-2(11/2)-> I-4(15/2) and S-4(3/2)-> I-4(15/2) transitions, respectively, of Er3+. The ratio of the intensity of green luminescence to that of red luminescence decreases with an increase of concentration of Yb3+ in Lu2O3:Er3+ nanocrystals.

Bright electroluminescence from a new conjugated dendrimer

Photoluminescence and electroluminescence from a new conjugated dendrimer consisting of three distyrylbenzene units linked by a central nitrogen atom as core and meta-linked biphenyl units as dendrons were investigated. Bright electroluminescence was realized by using bilayer devices with blurred interface, which were fabricated by sequentially spin-coating a neat dendrimer and a dendrimer doped with 2-(4-biphenyl)-5-(4-tert-butylphenyl)-1,3,4-oxadiazole (PBD). By optimizing the concentration of PBD, the maximum brightness and EL quantum efficiency reach 4100 cd/m(2) and 0.10%, respectively.

Bright green organic electroluminescent devices based on a novel thermally stable terbium complex

A navel thermally stable terbium carboxylate complex, Tb(MTP)(3)(phen) (MTP=monotetradecyl phthalate, phen=1,10-phehanthroline), was synthesized and characterized. The device structure of glass substrate/indium-tin-oxide/poly(p-phenylenevinylene) (PPV)/poly (N-vinycarbazole) (PVK):Tb(MTP)(3)(phen): 1,3,4-oxadizole derivative (PBD)/tris(8-hydroxyquinoline) (Alq(3))/aluminum (Al) was employed to study the electroluminescent properties of Tb(MTP)(3)(phen). A green emission with extremely sharp spectral band of less than 10 nm at 544 nm peak wavelength was observed. A maximum luminance of 152 cd/m(2) and an external quantum efficiency of 0.017% were achieved at a drive voltage of 24 V. A possible mechanism of energy transfer based on the polymer doped with lanthanide organic complex was also proposed.

Bright red organic electroluminescent devices based on a soluble rare earth complex Eu(TTA)(3) Phen

An Electroluminescent device with PVK film doped with Eu(TTA)(3) Phen and PBD was fabricated. The device structure of glass substrate/indium-tin-oxide/PPV/PVK : Eu(TTA)3 Phen : PBD/Alq(3)/Al was employed. A sharply red electroluminescence with a maximum luminance of 56. 8 cd/m(2) at 48 V was achieved.

Bright red electroluminescent devices based on a soluble lanthanide complex Eu(DBM)(3)(phen)

Electroluminescent devices with PVK film doped with Eu(DBM)(3)(phen) and PBD were fabricated. The device structure of glass substrate/indium-tin-oxide/PPV/PVK:Eu(DBM)(3)-(phen):PBD/Alq(3)/Al was employed. The emissive layer was formed by spin-casting method. A sharply red electroluminescence with a maximum luminance of 114.4 cd/m(2) was achieved at 42 V.

Bright blue electroluminescent devices utilizing poly (N-vinylcarbazole) doped with fluorescent dye

Bright blue electroluminescent devices have been fabricated using poly (N-vinylcarbazole) (PVK) doped with perylene as the emissive layer, poly(p-phenylenevinylene) (PPV) as the hole-transporting layer, 2-(4-biphenylyl)-5-(4-tert-butylphenyl)-1,3,4-oxadiazole (PBD), tris(8-hydroxyquinoline)aluminum (Alq(3)) as the electron-transporting layer, and Al as the cathode. A luminance of 700 cd/m(2) and a luminescent efficiency of 0.8% are achieved at a drive voltage of 36 V. In the experiment, it is found that the introduction of electron-transporting layer PBD has a great effect on the emissive color of the electroluminescent devices prepared by PVK doped with perylene. Yellow-green emission is observed from the device structure of glass substrate/indium-tin-oxide/PVK:perylene/Al. The possible emissive mechanisms are given. The effect of the transporting layer on the electroluminescence is also discussed. (C) 1997 Elsevier Science S.A.

Distribution of molluscan remains in the sediment of the Chukchi Sea and its vicinity, the Arctic

The result of an analysis of mollusca remains collected from the Chukchi Sea, Beaufort Sea and Bering Sea in the First Chinese National Arctic Research Expedition, from July to September, 1999 is presented. Seventeen species of mollusca have been identified, which belong to two classes: Bivalvia and Gastropoda. The compositions of the mollusca are very simple. According to the distribution pattern two groups may be distinguished among molluscan species. The Pan-Arctic and circumboreal group comprises Nuculana pernula, N.radiata, Nucula bellotii, Astarte montagui, Seripes groenlandicus, Macoma calcarea, M. moesta alaskana, Liocyrna fluctuosa, Mya pseudoarenaria and Turritella polaris. Three species, Cyclocardia crebricostata, Trichotrois coronata and Argobuccinum oregonense are components of the Pan-Arctic and Pacific boreal group. With regard to feeding habits, detritus feeders dominate. There are 7 species of detritus feeders, i.e., Nuculana pernula, N. radiata, Nucula bellotii, Macoma calcarea, M. moesta alaskana, Macoma sp. and Trichotropis coronata. Detritus feeders are dominant with regard to the numbers of species as well as to the frequency of occurrence. Macoma calcarea is the most abundant species.

TIDAL DEPENDENCE OF PHOTOINHIBITION OF PHOTOSYNTHESIS IN MARINE MACROPHYTES OF THE SOUTH CHINA SEA

PHOTOSYSTEM-II; CHLOROPHYLL FLUORESCENCE; ULVA-ROTUNDATA; ELECTRON-TRANSPORT; FIELD EXPERIMENTS; O-2 EVOLUTION; QUANTUM YIELD; TEMPERATURE; MACROALGAE; RESPONSES

Ulva diversity in the Yellow Sea during the large-scale green algal blooms in 2008-2009

P>In the Yellow Sea of China, large-scale green tides have broken out for three consecutive years from 2007 to 2009. As part of the efforts to localize the algal source, two cruises were conducted in the early stage and the outbreak stage of the bloom in 2009. We analyzed the morphological and genetic diversity of drifting Ulva specimens and culture-derived isolates from seawater sampled in different localities. For phylogenetic analyses, the nuclear encoded ribosomal DNA internal transcribed spacer region (ITS nrDNA) and the plastid encoded large subunit of ribulose-1, 5-bisphosphate carboxylase/oxgenase gene (rbcL) were used. Our molecular and morphological data indicate that the dominant free-floating Ulva species in 2008 and 2009 possibly belonged to a single strain of the U. linza-procera-prolifera (LPP) clade. The ITS sequences from bloom-forming algal samples with dense branches were identical to those from U. linza-like specimens without branches derived from the Yellow Sea. Microscopic individuals of the dominant Ulva strain were detected in eight stations, revealing that spore dispersal in the water helped to enlarge biomass in the water during the outbreak stage of green tide in the Yellow Sea.